At high temperatures, the material is entirely austenite, but upon cooling enters a region where the stable phases are ferrite and austenite.
在较高温度时,这种材料全部是奥氏体,但随着冷却就进入到铁素体和奥氏体稳定状态的区域。
The results show that the dispersed second phase particles can effectively retard the growth of austenite grain in the CGHAZ, and improve the toughness.
结果表明,细小弥散的第二相粒子能有效地阻碍焊接热影响区粗晶区的原奥氏体晶粒长大,改善该区域的韧性。
An austenite formation diagram has been determined.
测定了与其相应的奥氏体形成图。
The interface of austenite and martensite is somewhat straight.
奥氏体和马氏体之间的界面为较平直的界面。
With increasing tempering temperature, the retained austenite decreases.
回火温度升高,其残余奥氏体量逐渐减少。
An austenite shell is formed over the entire surface of the graphite nodules.
在石墨球的整个表面形成了一层奥氏体壳。
The structure of the studied steels was bainite, martensite and retained austenite.
研究用钢的室温组织为贝氏体、马氏体、少量残余奥氏体。
The result shows that ferrite has lower corrosion potential than that of austenite.
实验表明,铁素体相电位比奥氏体相电位低。
However, the rapid cooling of austenite postpones dynamic transformation remarkably.
但奥氏体快速冷却明显推迟了动态相变的发生。
Only strip austenite substructure and stacking fault were observed around the carbides.
在碳化物颗粒附近只观察到奥氏体变体和层错。
Some methods of retained austenite measurement on high chromium cast iron were compared.
对高铬铸铁残余奥氏体测定的几种方法进行了比较。
These lath martensite first nucleates in parent austenite intergranular and twin boundary.
应变诱发马氏体首先在原奥氏体晶界和孪晶界形核。
Effect of Manganese on austenite cooling transformation of high Chromium cast iron is investigated.
研究了锰对高铬铸铁奥氏体冷却转变过程的影响。
The strengthening effects of C and V on high strength austenite stainless steel welds were studied.
研究了元素C、V对高强度奥氏体不锈钢焊缝金属的强化作用。
As before, any remaining austenite transforms to pearlite upon slow cooling through this temperature.
就像以前说的一样,当缓慢冷却到这温度时所有剩余奥氏体转化为珠光体。
Spheroidal austenite and acicular austenite can be seen during the austenitizing courses at low speed.
慢速加热奥氏体化过程中,观察到球状奥氏体和针状奥氏体。
The stable reverted austenite formed during heat treatment would be positive to the fracture toughness.
热处理形成的稳定的逆转变奥氏体对断裂韧度起到积极作用。
The decomposition and transformation of the retained austenite in bainite differ from that in martensite.
贝氏体中的残余奥氏体分解和转变的行为与马氏体中的不同。
The corrosion behavior of austenite stainless steel weld joint in the different acidic medium was studied.
研究了奥氏体不锈钢焊接接头在不同酸性介质中的腐蚀行为。
The retained austenite transformation prior to the necking of the example enhanced the uniform elongation rate.
分析认为:残余奥氏体在颈缩发生前的较完全转变有利于提高均匀延伸率;
The original structure consists of deformation induced martensite, quenching martensite and retained austenite.
原始材料的组织状态为形变马氏体、淬火马氏体及残余奥氏体。
The non equilibrium segregation of manganese to austenite grain boundaries in Mn cryogenic steels is investigated.
系统研究了锰低温钢中锰在奥氏体晶界上的不平衡偏聚。
Because the V_4C_3 precipitated along the crystalline defects in austenite, they could be inherited to martensite.
由于V_4C_3沿奥氏体的晶体缺陷析出,故这些缺陷将遗传至马氏体中。
At the upper temperatures, only austenite is present, the 0.77% carbon being dissolved in solid solution with the iron.
在较高温度时,只存在奥氏体,0.77%的碳溶解在铁里形成固溶体。
Since the alloy element and nitric atom segregate on the austenite crystal boundary, the vein-like structure is formed.
脉状组织形成的原因是合金元素和氮原子在原奥氏体晶界偏聚形成合金氮化物。
The effect of austenite deformation on nucleation rate of ferrite is discussed with classical nucleation theory as well.
最后在经典形核理论的前提下讨论了奥氏体形变对铁素体形核率的影响。
The process investigation on hybrid YAG - MAG laser arc welding of austenite stainless steel is systematically developed.
针对奥氏体不锈钢材料,系统地开展了YAG-MAG激光电弧复合焊工艺研究。
During the tempering process, the austenite in bainite decomposed into ferrite and cementite by diffusion transformation.
在回火过程中,贝氏体中的奥氏体以扩散转变方式分解为铁素体和渗碳体。
And solution treatment is the valid method to improve the anticorrosion property of the austenite stainless steel bellows.
固溶处理是改善和提高奥氏体不锈钢波纹管抗应力腐蚀能力的有效措施。
And solution treatment is the valid method to improve the anticorrosion property of the austenite stainless steel bellows.
固溶处理是改善和提高奥氏体不锈钢波纹管抗应力腐蚀能力的有效措施。
应用推荐