Installation and assembly clearance error caused by the vibration of the pump body is an important reason.
安装及装配间隙误差是造成泵体振动的重要原因。
The parameter selection and permeability-proof for structure design, interference magnitude and assembly clearance of the couplings with the tubing were also studied systematically.
对管接头结构设计、过盈量和装配间隙等参数选择、防渗漏等进行了较系统地研究。
Do not follow the original clearance, arbitrarily change the assembly clearance, without disassembly and assembly according to the manual, do not make the performance test after assembly.
不遵从原件配合间隙，任意改变装配间隙，未按使用说明书进行拆装，装配后未做性能试验。
Because of the error of design, manufacturing and assembly, there will be the clearance between the primary components of the tripod constant velocity joint.
由于设计、制造和装配误差的存在，三球销式等速万向节的主要零部件之间会有间隙存在，使得传动轴总成在汽车运行过程中产生噪音和振动。
The sorting results have direct influence on bearing clearance quality and assembly efficiency.
分选效果如何将直接影响到轴承游隙质量和装配效率。
In addition, the gear-pair return clearance can be adjusted and eliminated through the repeated assembly of gear pairs and the rotary drums, so as to improve the utilization rate of equipment.
同时齿轮副回程间隙可通过齿轮副与转鼓间的重复装配调整消除，提高了设备利用率。
There are three classes of fits: 1) clearance fits, 2) transition fits (the assembly may have either clearance or interference), and 3) interference fits.
存在三种配合：1）间隙配合，2）过渡配合（装配后可以有 间隙或过盈），和3）过盈配合。
The direct cause of this bearing 'failure was its improper assembly caused by improper maintenance procedure, and the root cause was too small internal radial clearance after mounting.
而非驱动端轴承损坏的直接原因是由于检修程序不完善使轴承在大修中安装不当所造成的，其根本原因则是轴承安装后游隙过小。
A method of monitoring a clearance gap measurement system for the rotary machine includes providing at least one clearance gap measurement assembly.
监测转动机器的间隙测量系统的方法包括提供至少一个间隙测量组件。
The method also includes positioning the at least one measurement assembly on the stationary member to facilitate measurements of the clearance gap during operation of the rotary machine.
该方法还包括将至少一个测量组件定位在固定构件上，以有助于在转动机器的操作过程中进行间隙测量。
The method also includes positioning the at least one measurement assembly on the stationary member to facilitate measurements of the clearance gap during operation of the rotary machine.
该方法还包括将至少一个测量组件定位在固定构件上，以有助于在转动机器的操作过程中进行间隙测量。
应用推荐