Please consider the boundary of a semiinfinite slab as shown in Fig. 2.6.
请考虑一个半无限平板的边界,如图2.6所示。
Let us consider the block diagram of a digital computer as shown in Fig. 2-5.
让我们来考虑下图2 - 5所示(那样)的数字计算机的方框图。
As shown in Fig. 1 and Fig. 1, an example of a sense amplifier is illustrated.
如在图1及图1中所示,图解说明一检测放大器的实例。
The center of gravity of a flat object can be located experimentally as shown in Fig 3-9.
扁平物体的重心,可用实验方法来确定,如图3-9所示。
AND (12) correlated the experimental results well as shown in fiG. 11 for different conditions.
和(12)相关的实验结果也显示在图的不同状况。
The hard switching approach (as shown in Fig. 26) doesn't consider the minimum drain-source voltage.
硬开关(图26所示)几乎不考虑漏源极电压的最小值。
For example, as shown in FIG. 8a, an oxide layer 810 optionally is patterned on a silicon substrate 820.
例如,如图8a所示,氧化层810选择性地在硅衬底820上形成图案。
With the core end flush with the coil top, lay over it a thick piece of sheet copper as shown in Fig. 6.
随着核心结束线圈顶部齐平,奠定了它的铜片如图厚片。6。
Internal grinding. Internal grinding is employed for grinding relatively short holes, as shown in Fig. 8.3.
内表面磨削用于相对较短的孔,如图8.3所示。
Boost converter is commonly used in transformer-less inverters to regulate PV array voltage, as shown in Fig.
升压转换器,是常用的在变压器少变频器调节光伏阵列电压,为显示图。
As shown in Fig. 4.2, grain flow is the direction of the pattern that the crystals take during plastic deformation.
如图4.2所示,晶粒流动的方向就是在塑性变形期间结晶排列的方向。
Usually the compressive force is in the form of hammer blows using a power hammer or a press, as shown in Fig. 4.1.
通常压力都是以由如图4.1所示的动力锤或压力机提供的锤击形式出现。
As shown in Fig. 5-1, the knuckles are pivoted at the top and bottom. Thus, the wheels and tires can turn from side to side.
如图5 - 1所示,转向节的上下端可自由转动,这样车轮可从一侧转到另一侧。
As shown in FIG. 5, system 305 May be a cellular telephone handset, although the scope of the present invention is not so limited.
图5示出,系统305可以是蜂窝电话手持机,但是本发明的范围并不局限于此。
As shown in FIG. 1, the feed conductor 106, and the grounding conductor 108 are carried on a portion of the dielectric support 110.
如图1所示,在电介质支撑件110的一部分上承载该馈送导体106及接地导体108。
A way to circumvent the problem is to fabricate devices in small islands of silicon on an insulating substrate as shown in Fig. 32.
消除这个问题的一个方法是把器件制造在绝缘衬底的硅岛上,如图32所示。
When using low power system aims at target, the graduation form is as shown in Fig. 4, it is the graduation of three concentric circles.
用低倍系统瞄准目标时,分划形式见图4,分划形式是三个同心圆的分划。
Digital computers are also used to guide machine tools which perform precision-machining operations automatically, as shown in Fig. 6.5.
数字的计算机也是过去常指导自动地动机器制造精度手术的机床,在Fig . 6.5。
Removed cuts can be omitted the sectional symbol, but the labeling of cutting position and cut views should be fit the rules as shown in Fig. 15.
在不致引起误解的情况下,机件图中的移出断面允许省略剖面符号,但剖切位置和断面图的标注必须遵照原来的规定,如图15所示。
Discontinuous variables such as shown in Fig. 2-1A-2c occur in "on-off" or "bang-bang" control system and are treated separately in a subsequent paper.
如图2-1A-2c所示的不连续变量,主要是在“通-断”控制或者“砰-砰”控制出现,将后续章节单独处理。
When relative length or the slenderness ratio is the same, cavitation number becomes big as the conic angle or the diameter of the cone becomes big, as shown in Fig.
在相同的空泡相对长度或长细比下,随着锥顶角或直径的增大,对应的空化数也增大;
As shown in FIG. 2, a portion of the light will be emitted back towards the light emitting device 102, where it will be reflected by the dichroic filter for recycling.
如图2所示,光的一部分将被朝向发光装置102反向发射,在此它将被二向色滤光片反射用于再循环。
In the steady four-waves flow, the mean meridional circulation is indirect, with a descending motion near the cold source and an ascending motion near the heat source, as shown in Fig.
维持四波时,平均经圈环流为靠近热源处下沉和靠近冷源处上升的反环流。
With the horizontal dispersion pattern of FIG. 7B, as shown in FIG. 7D, the portions 48 of the audience receive similar levels of high frequency radiation as other portions 50 of the audience.
就图7B的水平散射模式而言,如图7D所示,该部分听众48所接收到的高频辐射和其它部分听众50所接收到的高频辐射为类似水平。
We used Poincare map and bifurcation map to analyze the nonlinear dynamic response of a eight degree of freedom rotor system with two disks supported on a squeeze film damper(SFD) as shown in Fig.
对双盘悬臂柔性转子-非同心型挤压油膜阻尼器(SFD)系统进行了非线性动力学分析。
It implies that the surface is rougher at the beginning region and more smoother at the ending one, that is in agreement on textural fractal dimension values obtained in this work, as shown in Fig.
这意味着表面粗糙度在开始区域和更顺利地在结尾之一,这是协议构造分维值在这项工作中,如图。
This waveform can be presented as a superposition of the following elements (Fig. 22 and Tab. 5). The superposition of all these elements results in a typical drain current shown in Fig. 21.
这个波形可以被看作是下列原理的叠加(图22和平台5)。全部这些波形的叠加整合结果变成图21所示的典型漏极电流。
Electron micrographs give some indication here as is shown in Fig 3.12.
电子显微照片给出的一些说明示于图3.12中。
Electron micrographs give some indication here as is shown in Fig 3.12.
电子显微照片给出的一些说明示于图3.12中。
应用推荐