In this paper, the impact of draft Angle to the moulding dimensions and the comprehension of the dimensions in plastic production with the unlabeled tolerance were discussed.
本文通过论述模具脱模斜度对模具尺寸的影响、塑料件未注公差的确定，并通过一个设计实例进行了说明。
If not allow for a larger ejection Angle, then plastic parts radial tolerance to employ large.
若不允许取较大脱模斜度时，则塑件径向公差宜取大。
Furthermore, the multi defect structure has greater tolerance of film thickness and incidence Angle.
同时这种多缺陷的结构对于膜层厚度的变化和入射角度也有很好的宽容性。
It can process the measurement data, and can obtain the profile curve, the starting Angle, the profile tolerance and symmetry of a CAM, and then corresponding assessment can also be complete.
对一次测量得到的多个数据进行处理，得到检测出的轮廓曲线、起始角、凸轮的轮廓度与对称度，并进行相应的评定。
Automatic correct the tolerance: if you input the actual value it can reach automatically correct the tolerance of length, opposite Angle line, snapping position and glass plate falling position.
误差自动校正：对板长误差。对角线误差。掰断位置误差及落板下落位置误差，只要输入实际值，可实现一次性自动校正。
The influences to the surface shape accuracy caused by the mismachining tolerance, the wear and the fixed angle of the cup wheel are analyzed.
分析了加工残留误差，砂轮磨损以及砂轮倾角误差对面形精度的影响。
The significance and basis of Angle production with negative tolerance are stated, the condition and technical measures introduced, the economic profit analyzed.
论述了角钢负偏差生产的意义和依据，介绍了角钢负偏差生产的条件和技术措施，分析了负偏差生产角钢的经济效益。
The enhancement factor strongly depends on the illumination spot size, taper Angle of the probe, and the metal film thickness. The tolerance of the alignment Angle is investigated.
研究发现电场增强跟入射光斑大小，探针的锥形角，以及金属膜厚度密切相关。
The enhancement factor strongly depends on the illumination spot size, taper Angle of the probe, and the metal film thickness. The tolerance of the alignment Angle is investigated.
研究发现电场增强跟入射光斑大小，探针的锥形角，以及金属膜厚度密切相关。
应用推荐