The results show that. (1) The mechanical fields around these faults are very different from those of a single fault;
结果表明，多断层的力学场与单一断层的力学场相差甚远，在断层间形成了影响区。
Even in the event of a single fault (single component failure) the ISO 13849-1 safety circuit will still function and disable the drive.
即使万一发生单一故障(单组件故障)，ISO 13849-1安全电路仍将起作用并禁用驱动器。
Analysis shows that the control core has a feature very similar to FSE (Fail Security) for a single fault or some sequent double faults.
分析表明，双微机核对于单故障和一类有序双故障具有非常类似于FSE(故障保险)的特征。
In the complex fault-block oilfield, small fault is very developed. A single fault-block that has only a single well is usually met in some oilfield.
通常情况下，复杂断块油气田中的细小断层十分发育，单井单块的情况在一些油田经常遇到。
This paper discusses the possibility of the method of stability analysis of the rock slope with the wedge failure and intersected by a single fault and joints.
本文探讨存在单一断层斜切岩石边坡时，断层与追踪破裂面所形成的三维块体的稳定性分析方法。
Because a single fault protection scheme has poor precision in ground fault detection, information fusion technology is discussed and many selection methods are fused.
由于单一故障选线方法的精确度较低，探讨了信息融合处理技术，将多种选线方法进行了信息融合实现。
In case a single fault occurs on a power feeder, the fault section must be between two adjacent switches, and the FTU information about fault currents passing through these switches must be different.
通过分析配电网馈线单一故障情况下，其故障点必位于两个相邻的开关之间。有故障电流和没有故障电流流过的开关，其FTU所采集的信息不相同。
Integrated fault and performance management enables consolidation of operations centers under a single management umbrella.
集成的缺陷和性能管理能够使单个管理保护下的操作中心发生突变。
Unlike WSDL: input and WSDL: output, the message referenced by WSDL: fault is only allowed a single message part which could refer to a simple type or a complex type.
与wsdl：input和wsdl：out put不同，wsdl：fault引用的消息只允许有一个单一的消息部分，这个部分可以引用一个简单的类型或一个复杂的类型。
Even on a single physical server, you can have redundant power supplies, error-correcting RAM, redundant disks, and copious monitoring of pre-fault indicators.
甚至在单个物理服务器上，您都有冗余电源、错误纠正ram、冗余磁盘和丰富的故障前诊断指示器监控。
If the problem does not happen on a single-processor system with JIT off, that might be an indication that JIT is not at fault.
如果这个问题不会在禁用jit的单处理器上发生，那么这就可能说明JIT不是问题的根源。
Because the Internet was originally designed to enable a high degree of fault tolerance, companies can eliminate single points of failure by using the cloud.
因为Internet最初的设计就能够支持一个高水平的容错，企业可以使用云消除单点故障。
Because fault contains a single string field, you might prefer to go the simple route and put the string directly in the fault element rather than to go through t: fault to get to the string.
因为fault包含单一字符串字段，您可能更愿意采用简单的路由，并将字符串直接放入错误元素中，而不是通过t： fault获得该字符串。
Given that a stereotype can be applied only once on a single element, you can apply the Fault Contract stereotype to an operation only once.
既然一个构造型对单个元素只能应用一次，所以您对一项操作只能应用FaultContract一次。
Although fault component current phase selector has excellent performance for single transmission lines, it may select unwanted phase for cross-country faults in double-circuit lines on a same tower.
相电流差突变量选相元件在单回线故障中具有良好的选相性能，但在同杆双回线跨线故障中可能误选相。
The system could control it's temperature in a best range to collect the best image, and when fault communication happens, single-control mode could control the temperature of the collection board.
将其工作温度控制在最佳工作范围以便采集到更好的图像，在通信故障时通过单独控制模块来控制采集板的温度。
A fault concentrated alarm system was developed with 80c196kc as its core. The system is composed of signal detection circuit, single chip minimal system and fault alarm circuit.
研制了一个故障集中声光报警系统，以80c196 KC单片机为核心，主要包括三部分：信号检测电路、单片机最小系统和故障报警电路。
A novel method of identifying permanent fault for single-phase adaptive reclosure in transmission lines with shunt reactors is proposed.
针对带并联电抗器的超高压输电线路，提出一种单相自适应重合闸永久性故障识别的新方法。
The analysis of related theory proved that the fault vibration signal of rotating machinery is a complex signal which has some components with single frequency.
通过对相关理论的分析证实了旋转机械的故障振动信号基本上是一个复合信号。
As most of the fault-tolerant systems are based on single-fault assumption, the dormant fault is a potential threat to its reliability.
由于大多数容错系统是基于单故障假设，所以系统中存在的潜在故障可能会影响系统可靠性。
This paper presents a new single-end fault location device based on traveling wave, detailedly describing the design of its hardware and software as well as the research on fault location method.
为此，提出了一种基于行波法的单端故障定位装置的开发思路，并详细介绍了该装置硬件、软件的设计工作及故障定位方法的研究。
The self-extinguishing of the arc caused by a single-phase grounding fault depends mainly on the amplitude of the residual current at grounding point.
可自恢复性单相接地故障点的电弧是否能自然熄灭的决定因素是接地故障残流的大小。
A new method based on calculating approximate entropy of transient zero-module current is presented in order to locate the single phase grounding fault in non-solidly earthed network.
提出一种通过计算暂态零模电流近似熵确定小电流接地故障区段的新方法。
The fault phase selector discussed is based on the result that the fault component of sound phases is zero when a single-phase-to-ground fault occurs.
文中所探讨的相电流突变量选相元件，是利用单相接地故障时，两健全相相间电流突变量为零这一特征来得到的。
The identification of the fault types is achieved in the neural network module using competitive learning algorithm. The seven models for the single and composite . faults of a cantilever beam…
文中对悬臂梁的单一故障和复合故障等七种模式进行了诊断分析，均获得了正确的诊断结果。
Fuzzy reasoning was used in the fault diagnosis program. The system can locate fault at a single-board quickly.
故障诊断程序采用模糊推理机制，能把故障快速定位到单板级。
To solve the problem of the fault location in distribution networks, a fault location method is suggested for the single-phase grounding fault based on C-type traveling-wave theory.
为解决配电网故障定位问题，使配电网故障定位自动化，以减少巡线工作量和用户停电时间，提出了利用C型行波法对单相接地故障进行故障测距的方法。
By analyzing the zero-sequence full current for single-phase grounding fault in isolated neutral distribution network, a new approach to determine the faulty transmission line is obtained.
通过对中性点不接地配电网单相接地故障时零序全电流的分析，得出了利用零序全电流的大小和方向进行故障选线的新方法。
Based on clustering FSVM and current injection method, a new method using two steps for single-phase grounding fault location of distribution feeders in networks with ungrounded neutral is proposed.
提出小电流接地系统实现单相接地故障定位的新方法。该方法应用基于聚类的FSVM和电流注入法分两步实现故障定位。
Based on clustering FSVM and current injection method, a new method using two steps for single-phase grounding fault location of distribution feeders in networks with ungrounded neutral is proposed.
提出小电流接地系统实现单相接地故障定位的新方法。该方法应用基于聚类的FSVM和电流注入法分两步实现故障定位。
应用推荐