在冻结温度下，应用YE2538型程控静态电阻应变仪测试了不同材料的弹性模量。
Freezing elastic ratios of materials were measured by the YE2538 programmable static strain gage.
一般是由于带电拔插系统中接插件，或电路中电源对地之间短路而引起，此时可采用静态电阻测量法。
General is due to the live system connector plug or circuit between the power-to-ground short-circuit caused by, at this point resistance measurement method can be static.
仿真研究表明：FNOSER算法可以实现静态电阻抗成像，且具有图像分辨率高、定位精确、成像速度快等特点。
The study results show that the FNOSER algorithm can obtain static image with a character of high space resolution, accurate orientation, fast imaging, and so on.
详细介绍了电阻式应变测量系统的组成、系统静态标定的方法与步骤；
This paper described the consist of the resistance strain measure system and the approach of static calibration in detail.
针对变压器绕组直流电阻测试特点，提出了“消磁动态测试法”，将静态测量法与动态测量法有机统一起来。
This paper brings up a method called demagnetization dynamic measurement system for measuring the direct current resistance (DCR) of the transformer due to the characteristics of the windings.
采用本文提出的电阻补偿器，可对系统产生的静态误差作完全补偿。
With a resistance compensator proposed in this paper, the static error produced by the system can be completely compensated.
切换采样转子一点接地保护，通过两个静态开关一开一合建立两组方程来求解接地电阻与位置。
Commonly, by opening one switch and closing the other, two group equations are set up to measure rotor earth-fault resistance in the rotor earth-fault protection with switch sampling principle.
第五步：调末级功率管的静态电流，该电流值可以经由过程测功率管的发射极电阻的电压换算而得到。
Step five: tune the final stage power transistor quiescent current, the current value of the power tube by measuring the voltage of the emitter resistance Converter and get.
本文提出了对电阻应变片采用脉冲加电来测量静态应变的方案。
This paper offers a new method for strain-gage measurements in which a synchronized electrical pulse is used.
该电路采用高精度低温漂的基准源为铂电阻形成静态工作电流。
The circuit also USES high accuracy, low drift voltage reference to bias the platinum resistor.
该电路采用高精度低温漂的基准源为铂电阻形成静态工作电流。
The circuit also USES high accuracy, low drift voltage reference to bias the platinum resistor.
应用推荐