钢和铸铁都有共析、亚共析和过共析这三种组织。
Both steel iron and cast iron have the structures of eutectoid, hypoeutectoid and hypereutectoid.
由于有色金属(钢和铸铁)是目前使用最广泛的金属，报导有色金属这些书籍是粗粗或缺席。
Because ferrous metals (steel and cast iron) are by far the most widely used metals, coverage of nonferrous metals in these books is cursory or absent.
由于生铁和废钢铁都便宜，又因为不需要昂贵的精炼过程，和钢相比铸铁是一种廉价材料。
Since pig iron and scrap are cheap, and because there is no expensive refinement process, cast iron is a low cost material compared with steel.
喷射泵可由各种各样的材料制成，例如铸铁、钢、不锈钢、哈氏合金、钛、搪瓷、玻璃、塑料和石墨，并可制成各种尺寸。
Jet pump may be all kinds of material, such as cast iron, steel, stainless steel, Hastelloy, titanium, ceramic, glass, plastics and graphite, and made of various sizes.
美国尼必可球墨铸铁阀门符合ANSI B 16.42标准150磅级法兰和相同端对端尺寸的125磅级铸铁或150磅级钢阀门。
NIBCO Ductile iron valves come standard ANSI B16.42 Class 150 flanges and the same end-to-end dimensions as Class 125 iron or Class 150 steel valves.
用于铸铁、碳钢、合金钢、不锈钢的切削和磨削加工，尤其磨剂效果甚佳。
For cast iron, carbon steel, alloy steel, stainless steel cutting and grinding processing, especially the grinding effect is very good.
黑色金属可分为钢，铸铁和熟铁。
The ferrous metals can be classified into steels, cast irons, and wrought irons.
黑色金属包括铁和含有50%以上铁的合金，比如铸铁，锻铁，钢和不锈钢。
Ferrous metals include iron and alloys of at least 50% iron, such as cast iron, wrought iron, steel, and stainless steel.
在这些阀门上不能使用250磅级铸铁和300磅级钢法兰。
Class 250 cast iron and Class 300 steel flanges can not be used on these valves.
曲轴表面及本体的缺陷，对发动机的可靠性有重要影响，对锻钢和球墨铸铁曲轴的探伤技术进行探讨。
Defects of crankshaft surface and body will produce important effect on engine reliability. This paper probes into flaw detection technology of forging steel and nodular cast iron of crankshaft.
当保护钢、铸铁或铜时，可选锰、锌和铝作阳极材料。
When protecting steel, cast iron, or copper, the anode material can be magnesium, zinc, or aluminum.
应用有机电解液低温电解及放射性测量方法测定了钢、铸铁和铝各相中的铈含量。
By means of the low temperature electrolysis with organic electrolyte and the radioassay method, the Ce content in various phases of steel, cast iron and aluminum was measured.
特殊的材料包括球墨铸铁和钢煅品，大部分机轴经过热处理，表面硬化、渗氮和感应淬火。
Typical materials include ductile iron castings or steel forgings. Most crankshafts require some form of heat treating including case hardening, nitriding and induction harden.
与铸铁相反，钢具有延展性，可以锻造和轧制。
In contrast with east iron, steel is malleable and can be forged and rotted.
适用于钢。铸铁及合金钢的精加工和半精加工，还可用于加工铸铁等短切削材料。
Semifinishing and finishing of steel, steel castings and alloy steel, also for castiron and other short chip materials.
目前工业制造的趋势是将不锈钢排气组件和球墨铸铁排气歧管直接焊接在一起，这大大缩小了焊材的选择范围。
The current industry trend is to weld the stainless steel exhaust components directly to cast Ductile Iron exhaust manifolds, which significantly reduces welding consumable options.
材质：穿线盒体和盒盖为热浸锌可锻铸铁；螺丝材质为不锈钢304；垫圈材质为橡胶。
Texture of material:The body and a box cover for malleable iron; screws made of 304 staintess steel; the gasket material for rubber.
无承口离心排水铸铁管的安装和拆卸均非常方便，但要注意不锈钢卡箍橡胶密封接口的安装方法和管道局部支吊架的特殊要求。
When using centrifugal cast iron pipe, we should pay attention to its installation and technical requirements, such as that of stainless steel clasp and local support and hanger of pipe.
结果表明，应用复合铸造工艺生产的导卫板安全可靠，使用效果明显优于常用高镍铬钢导卫板和高铬铸铁(钢)导卫板。
The results obtained show that the composite guide plate is safe and reliable in use, its service effect is more excellent than that of high Ni Cr steel and high Cr cast iron (steel) guide plate.
概述了半固态铁基合金及制品的制备方法和相关的性能，包括铸铁、不锈钢和其他合金钢。
The fabrication methods and relative properties of semi - solid ferro - based alloys and products were introduced, including cast irons, stainless steels and other alloy steels.
铸铁是汽车四项主要构造材料之一，其重量份额一般居第二位，仅次于钢，而高丁铝和塑料。
Cast iron is one of four main construction materials in automobiles. Its weight share is second to steel and higher than either aluminum or plastics.
结果表明，该刀片在车削奥氏体不锈钢、球磨铸铁和冷硬铸铁时，其耐磨性较好，与常规工艺生产的YG6刀片相当。
This type of tips has presented a good wear resistance equal to that of typical cemented carbides YG6 tips when cutting austenitic stainless steel, nodular cast iron and chilled cast iron.
分别采用高铬铸铁和碳素钢作为锤端和锤柄。
The cast steel and high chromium cast iron were used respectively as handle and head material of hammer respectively.
材料可钢，不锈钢，铝，铜，球墨铸铁铸造生铁和锦纶。
Material could be steel, stainless steel, aluminum, copper, nodular casting iron and PA6.
根据泵承受的最大压力，泵体和泵盖材质采用灰口铸铁(1.6Mpa)、球墨铸铁(2.0 mpa)、铸钢(2.5 Mpa，包括不锈钢)。
According to the maximum pressure to bear, pump body and cover can be made of grey cast iron (1.6mpa), spheroidal graphite cast iron (2.0mpa) or cast steel (2.5mpa, including stainless steel).
流经措施大多数金属和塑料管包括PVC，球墨铸铁，碳素钢和不锈钢。
Measures flow through most metal and plastic pipes including PVC, ductile iron, carbon steel and stainless steel.
它成本低廉，使用安全可靠，可广泛用于碳素钢、合金钢、铸铁等工件的浸没淬火和喷淋淬火。
It is safe and reliable to operate. It is extensive to be used for immersion quench and spray quenching of silicium steel, alloy steel and cast iron.
这些性能使得这种材质等级的刀具材料被用作粗加工淬硬钢和珠光体灰铸铁。
These properties make this kind of material grades of tool material is used for rough machining of hardened steel and pearlitic gray cast iron.
适用于轴承钢，不锈钢和特种墨铸铁的磨削。
Applicable bearing steel, stainless steel special cast iron grinding.
实践还证明球铁是一种良好的耐磨材料，其耐磨性能优于灰铸铁和碳素结构钢。
The practice also proved that the nodular cast iron is one good anti-friction material, its wear-resisting performance surpasses the gray iron and the carbon structural steel.
应用推荐