通过算例分析，提出了一些建议。
通过算例分析指出这些方法的适用性。
The adaptability of these POGO stability analysis is pointed through an example.
通过算例分析验证了该方法的有效性。
The validity of the proposed method was demonstrated by calculation examples.
最后通过算例分析验证了模型的有效性与可行性。
Finally, a numeral case is proposed to prove the validity and feasibility of the model.
通过算例分析研究了土水势方程和网格算法的影响。
A case study was carried out to investigate the influences of the SWP equation and mesh schemes.
通过算例分析，验证了所提方法的准确性和高效性。
The methodology proposed is proved to be valuable and efficient by a numerical example.
通过算例分析，研究了近似振型分解法的计算精度；
The precision of the approximate decoupled modal analysis is …
通过算例分析分层数目对计算速度和计算精度的影响。
Case studies show the effect of the number of load levels on calculation accuracy and speed.
通过算例分析，验证了本文理论结果的正确性和合理性。
A numerical example is given to verify the correctness of the results of the theoretical deduction.
通过算例分析验证了所给出的模型及其优化算法的有效性。
Thirdly, frequency-domain model of stochastic transportation network optimization and its algorithm with some constrained conditions are studied.
通过算例分析和总结三种方法预测消声器声学性能的优缺点。
The advantages and shortcomings of the three methods for the prediction of silencer acoustic attenuation performance are discussed.
通过算例分析表明：本文方法应用方便，精度高．收敛迅速。
The identification results of illustration by this method indicate that:the accuracy is high, and the convergence rate is rapid, the application is convenient.
最后通过算例分析，验证了价格补贴契约在协调供应链中的有效性。
At last, the effectiveness of markdown money contract is verified in supply chain coordination by a case study.
本文通过算例分析和对比，认为双非线性分析法可得出更合理的结果。
Based on example analysis and results comparison, the geometry-material nonlinear method is considered as the most reasonable one.
通过算例分析和算法性能测试，说明了模型及算法的可行性与有效性。
The computational results of numerical example and algorithm performance experiment verify the feasibility and effectiveness of models and algorithms.
通过算例分析，无论从坐标序列的均值还是中误差都验证了本方法的有效性。
And both the mean and the mean square error of the coordinate series are testified this method.
通过算例分析并与有限元计算结果相比较，验证了该方法的计算精度和计算效率。
A numerical example was given to demonstrate the accuracy and efficiency by comparing the results with finite element method.
同时，本文还通过算例分析，得到离散单元的计算中块体的刚度系数选取的合理范围。
Meanwhile, by some examples studied, the reasonable range of stiffness coefficient has been obtained during the discrete element calculating.
通过算例分析得到一些不同于线性结构的结论，为建筑结构动力设计与分析提供了理论基础。
Some conclusions different from linear structures have been drawn through the analyses of numerical example. Theoretical basis is provided for the structural dynamic design and analysis.
通过算例分析，讨论了索的轴向刚度与拉力变化的关系，分析了重力刚度和弹性刚度对轴向刚度的影响；
Through analyzing example, the relation between axial rigidity and pulling force of the cable and the affection to axial rigidity about gravitation rigidity and elastic stiffness have been discussed.
通过算例分析表明这些比例效应如何影响总体设计、布局，深入理解不同的飞艇设计比例效应的差异性。
The results show that these effects how to affect the overall design and general layout, it is comprehensively to understand the difference of various aspects of airship design.
通过算例分析了模糊智能桁架结构参数的模糊性对其动力特性的影响，并验证了本文方法的合理性与可行性。
The influences of structural parameters of fuzzy intelligent truss on structural dynamic characteristics are inspected by an engineering example and some significant conclusions are obtained.
通过算例分析表明该方法具有较大的灵活性和适应性，更加符合工程实际，是对传统故障树分析方法的进一步完善。
A practical example indicated that the method is so flexible and adaptive that it is more corresponded to engineering practice and further to improve the traditional fault tree analysis method.
通过算例分析和误差分析发现，与传统的方法相比，本文的计算结果更接近实验值，且与实验值比较时结果更稳定。
An example analysis and error analysis revealed that, by comparing with traditional methods, results obtained by the above method are closer to the experimental data and more stable.
随后又研究了供应链回购契约模型，通过算例分析得出，在缔结契约情形下比不缔结契约时双方都能达到各自的最优化决策。
Then study a supply chain repurchase lease model, conclude the lease situation than entering into a contract when both sides can reach their respective optimal decision-making.
通过算例分析表明，本文的边界简化和修正方法能更好地描述船舶局部结构的真实边界条件，而且在实际的工程分析中易于实现。
The numerical result shows that the method can describe the real boundary conditions more exactly and is simple and reliable in engineering analysis.
文中进一步通过算例分析，探讨了P、SV波的入射角度、土层厚度以及基岩和土层间的剪切波速比等因素对土层随机地震反应的影响。
The effects of incident angle of wave and elastic rock on the seismic responses of layered soil sites are considered precisely and conveniently. The influences of angle of incidence of P-and SV-…
本文采用交替迭代法分析索-桁结构体系，并导出了这种杂交结构无阻尼自由振动的简化方程，通过算例分析得出了一些对实际工程有益的结论。
In this paper, the alternate iteration method is used in static analysis of cable truss hybrid structural system, and the simplified non damping free vibration equations have been drawn.
通过算例，分析了机构的弹性变形和各随机参数对机构运动功能可靠性的影响。
Through an example, the influence of the elastic deformation and each random parameter on the mechanism reliability of motion function is analyzed.
通过算例，分析了机构的弹性变形和各随机参数对机构运动功能可靠性的影响。
Through an example, the influence of the elastic deformation and each random parameter on the mechanism reliability of motion function is analyzed.
应用推荐