然后它自动地减少信号的计数值。
您将看到在我使用该计数值来汇总事情时，它如何工作。
You'll see how the count value works when I use it to sum things up.
真值是用计数值处以牌盒中剩余牌副数的值。
To find the running count, just divide the true count by the number of decks being played.
为了对这些事件做某些计算，必须使用规范化的事件计数值。
In order to do some calculation with these events, you have to use a normalized event count for calculation.
计数值除以一个常数得到输入电压的线性显示。
Dividing the ADC count by a constant yields a linear display of the input voltage.
注意，如果指定了多个事件集，那么事件计数值是规范化值。
You need to notice that the event counts are normalized values as the article discussed previously if you specify more than one event set.
当定时器计数值达到0(超时)，内部复位信号有效。
Internal reset signal is activated when the timer count value reaches 0 (time-out).
您可能需要增加计数值以查看时间的不同，具体取决于您系统的速度。
Depending on the speed of your system, you may have to increase the count value to even see a difference in The Times.
利用计数值进行曲线拟合，便得到无“死区”相位比对曲线。
The phase comparison curve can be observed by using calculated values to simulate the curve.
这个辐亮度与卫星通道的计数值比较得到该通道绝对定标系数。
At last the apparent radiance of sensor spectral channels are compared to the digital count of satellite's output to give the calibration coefficient.
比较了不同浓度的酵母膏对生活污水中细菌DVC计数值的影响。
The effect of concentrations of yeast extract on DVC of bacteria in sewage water was evaluated.
通过设计数值试验方案，研究了流场、水位等因素对海浪的影响；
The numerical experimentation scheme is designed to study the current field and water level's effects on the wave.
滚屏计数值的大小将递增，直到超过一块图素的宽度时再被清零。
The scroller location is incremented and zeroed again if it exceeds the width of a tile.
规范化的事件计数值使我们能够像是在整个数据收集过程中收集事件那样处理事件。
The normalized event count makes you handle events as if you collect them during the whole data collection.
以及其中将从所述计数器输出的计数值被提取作为转换后的数字输出值。
A count value output from the counter is extracted as a converted digital output value.
当计数值成为零时，信号对象的状态成为non - signaled。
When the count reaches zero, the state of the semaphore object becomes non-signaled.
启动计数值是一个界限值，用来界定分析仪由启动模式到正常模式的转换。
The starting count value is the threshold value where the analyzer switches from starting mode to normal mode.
根据我非正式的统计结果，我在信封背面所计算出的统计数值令人相当失望。
The results of my informal, back-of-the-envelope calculations were rather disheartening.
并且，根据正转脉冲信号的计数值算出卷绕到卷装（30）上的纱线长度。
Then, based on the count value in the forward rotation pulse signal, the length of the yarn wound into the package 30 is calculated.
断电可保持计数值，通电后继续计数，如达到计数次数，可通过清零按纽清零。
Without electricity can keep count value, after electrify continue to count, such as frequency, can achieve count by reset button reset.
当两个对象互相引用时，就构成了循环引用，其中每个对象的引用计数值都被赋1。
A circular reference is formed when two objects reference each other, giving each object a reference count of 1.
用LED数码管显示计数器t0的计数值，包含51单片机寄存器定义的头文件。
Use LED digital display counter plan of tube T0 numerical, including 51 SCM registers definition of header files.
减小前一个示例中的循环计数值，在脚本的开头添加set - x和一个注释，见清单12。
Tone down the loop count on the previous example, add set -x to the beginning of the script as well as a comment, and execute it, as shown in Listing 12.
一比较器，接收上述第一计数器及上述第二计数器的计数值，以产生一致能信号输出；
The third counter starts counting in the first clock frequency when receiving the enabling signal, and stops counting when the enabling signal stops.
它检查这个问题计数值是否是目前最大的。如果当前集合中还有其他问题，就再次递归运行这个例程。
It checks to see whether that's the highest question count so far, and if any other questions are in the current set, it sends them to run through the routine again.
结论：在无条件检测CD 4淋巴细胞计数的情况下，可用TLC预测CD 4淋巴细胞计数值。
Conclusion: TLC may be used as a prediction index for CD4 lymphocyte count.
LinuxPOSIX信号使用sem_wait来挂起发出调用的线程，直到信号拥有了非零的计数值。
Linux POSIX semaphores use sem_wait to suspend the calling thread until the semaphore has a non-zero count.
第二个表格answers 包含每个调查问题的答案，使用poll字段管理关系和当前答案投票数的计数值。
The second table, answers, holds the answers to each poll question, using the poll field to manage the relation and a count value with the current number of votes for that answer.
我们使用该计数值作为ETag，这样当客户端将ETag送回时我们就知道页面背后的一个或多个对象是否被修改了。
We use the count as the ETag, so when the client sends it back we know if one of the objects behind the page has been modified.
我们使用该计数值作为ETag，这样当客户端将ETag送回时我们就知道页面背后的一个或多个对象是否被修改了。
We use the count as the ETag, so when the client sends it back we know if one of the objects behind the page has been modified.
应用推荐