• 因此研究公路桥梁设计汽车荷载适应性,为修编汽车荷载标准服务

    Therefore, the research on adaptability of present highway bridge vehicle design load is needed to service the revision of the standard.

    youdao

  • 本文针对重载交通状况推力体系桥梁车辆荷载标准展开专门研究

    The paper specializes in the vehicle load standards on the thrust system bridge against heavy traffic conditions.

    youdao

  • 介绍了采用算法计算悬挂运输设备轨道容许集中荷载标准值的公式及其应用图表。

    Formula for calculating standard values of allowable concentrated loads in railway of hanging lifting equipment is introduced by using reversed calculation and their application.

    youdao

  • 参照结构正常使用阶段荷载标准取法,给出钢筋混凝土结构施工荷载标准值的建议

    Referring the method of choosing the standard value of loads in service phase, the standard value of live loads during construction is suggested.

    youdao

  • 介绍《门式刚轻型房屋结构技术规程》(CECS102:98)荷载和风荷载标准制订依据。

    Some explanations for specified values of live load and wind load for Technical Specification for Steel Structure of One-storey Light-weight Buildings with Gabled Frames (CECS102:98) are introduced.

    youdao

  • 分析中小跨径桥梁常用结构设计存在的问题,针对问题规范标准、设计方法、常用结构特点、荷载标准确定方面提出建议

    The paper analyzed the problems of common structure and design for middle and small span bridge, proposed some advice from standards, design methods and common structure characteristics etc.

    youdao

  • 输出数量就是削弱功能前提下输出栅门连接标准荷载的数量。

    Fan-out refers to the number of standard loads (inputs) that the output of a gate can be connected to without impairing its normal operation.

    youdao

  • 由于标准图集是某个系列分格大样图并未注明该图施工接受荷载所以不能作为制造装置查验的依据。

    Because the standard atlas is just a series of window type lattice drawing, does not indicate the load according to the drawings which can be accepted, it is not as manufacturing, device, check for.

    youdao

  • 混凝土紧固件设计技术标准包括荷载结构内部局部传递

    The Technical Specification 'Design of Fastenings for Use in Concrete' includes the local transmission of loads into the structure.

    youdao

  • 研究碾压混凝土重力拱坝不同荷载组合工况应力分布状态和分布特征以及最大应力出现位置应力控制标准

    It researches the stress condition, stress distribution, location of maximum stress and stress control criteria of RCC gravity-arch dam under different load combinations.

    youdao

  • 现有的路桥过渡段段差异沉降控制标准与交通荷载下路桥过渡段路面计算模型计算方法不能对桥头跳车问题进行全面描述和合理解释

    But the current differential settlement control criterion of bridge-approach, the existing calculation models and methods of bridge-approach pavements could not describe and explain.

    youdao

  • 根据微分方程标准基本本文导出侧向荷载垂直力作用内力侧移计算公式

    Based on the standard basic solution of ordinary differential equation, formulas for computing stresses and lateral deflections of piles under horizontal loading and vertical axial force are derived.

    youdao

  • 由于设计标准,加上恶劣地理环境行车荷载作用道路极易产生翻浆

    The frost heave in a road is easily induced due to low standard design, poor geographical circumstance and effect of daily travel loads.

    youdao

  • 本文主要介绍正在审批中的国家标准建筑荷载规范基本风压确定方法依据解释同时介绍我国风气侯特点

    This paper presents a brief introduction to the method, basis and some explanations for determining basic wind pressures of Building Load Code, as well as the feature of wind climate in China.

    youdao

  • 采用现场荷载试验所得到垂直承载力标准基本、最合理的,它是桩基础设计主要可靠的依据。

    The standard value from the spot dead load experiment is the most important and reliable basis of the stake base design.

    youdao

  • 根据不同设计使用年限荷载超越概率等于常规设计荷载超越概率原则确定活荷标准

    The live load should be determined that the exceedance probabilities of live load for different design working life equal to that for conventional design loads.

    youdao

  • 可以公路桥梁设计汽车荷载的修编现行公路桥梁设计汽车荷载标准的制定提供依据

    But also provides evidence to modify highway bridge design vehicle load and formulating the existing highway bridge design vehicle load limit.

    youdao

  • 畸变屈曲判断标准问题上,可以采用荷载—轴位移,亦可以采用荷载—横向应变法

    In the problem of how to judge distortional buckling, a good method is use load-axial displacement curve.

    youdao

  • 对于整体式衬砌,多年来均荷载结构进行结构检算,计算中考虑施工支护受力当前的标准均按此法编制。

    Load structure method has been applied in analysis of integrated lining structure analysis for many years without considering supporting force on the structure.

    youdao

  • 对于整体式衬砌,多年来均荷载结构进行结构检算,计算中考虑施工支护受力当前的标准均按此法编制。

    Load structure method has been applied in analysis of integrated lining structure analysis for many years without considering supporting force on the structure.

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定