例如，测试4线电阻器时，则每个电阻器可能需要4个开关闸刀。
For example, testing four-wire resistors may require four switch poles per resistor.
基于可补偿引线电阻影响的三线制铂电阻测量电路提出了一种高精度测温方法。
Based on a 3 wire platinum resistor measuring circuit, in which the lead wire resistance can be compensated, a high precise temperature measuring method is stated.
本文研究的重点是基于四线电阻式触摸屏的在线签名数据采集系统的软硬件设计。
The key point of this paper is the software design and hardware design for on-line signature data acquisition system based on four-line resistance touch panel.
注意，这种测量方法是两线电阻测量，而使用静电计电压表和外部电流源则可以进行四线测量。
Notice that this is a two-wire resistance measurement compared to using the electrometer voltmeter and external current source, which can make a four-wire measurement.
用导体截面矩量法提取多导体芯片传输线电阻和电感频变分布参数时，为了使矩量法程序化，提出了几种不同的网络划分方法。
Conductor cross section method of moment was applied in extracting the resistance and inductance frequency dependent distribution parameter of multiple conductor transmission lines of IC.
Hla说(金属线)是可能在半导体或绝缘体上制作的，从而进一步证明电子是沿着电线无电阻导电。
Hla said (metal wire) is probably produced in the semiconductor or insulator and thus further evidence of the electronic conductivity along the wires without resistance.
Hla说(金属线)是可能在半导体或绝缘体上制作的，从而进一步证明电子是沿着电线无电阻导电。
Hla said (metal wire) is probably produced in the semiconductor or insulator, and thus further evidence of the electronic conductivity along the wires without resistance.
Hla说(金属线)是可能在半导体或绝缘体上制作的，从而进一步证明电子是沿着电线无电阻导电。
Hla says it should be possible to grow the wires on semiconductors or insulators as well and prove that electrons superconduct along the wires.
详细研究了微带线尺寸对器件功率容量的影响，以及大功率合成系统中隔离电阻功率容量的量值；
The infection of the dimension of microstrip line to power capability of devices and the power capability of isolate resistor has been investigated in detail.
利用线模电流的小波变换系数进行测距，不仅不受故障电阻的影响，也不受故障起始角的影响。
The location result is not influenced by fault resistance and inception Angle when wavelet transform coefficient of aerial mode current is used in fault location.
在+5V和每根线之间连接着一个电阻，所以总线的空闲状态是高电平。
A resistor is connected between each line and + 5v, so the idle state of the bus is high.
通道电阻包括闭合触点的电阻、印制板走线和输出连接器的电阻。
The channel resistance includes the resistance of the closed contact, the printed circuit traces, and the output connectors.
把电阻线绕在无硷性耐热陶瓷件上，外面加上耐热、耐湿及耐腐蚀之材料保护固定而成。
Wire wound resistors are made by winding the resistance wire on the alkali less ceramic core, then coated with noncorrosice, heat-proof and humidty proof material.
电阻焊接飞溅了适合汽车制造商谁指定快速轨道升降机和进行传输线的车身面板的焊接。
Resistance to weld splatter has made it suitable for car manufacturers who specify Speedy Rail for lift-and-carry transfer lines for car body panel welding.
此控制板适用于4线模拟式电阻输入屏。
This control board applies to the 4wire Analog Resistive Film Input Panel.
测量绝缘电阻的例子包括测量印制板上走线之间的通路，或多芯电缆中导线之间的电阻。
Examples of insulation resistance measurements include measuring the path be tween traces on a printed circuit board or the resistance between conductors in a multi-conductor cable.
屏蔽层的导电率是由连同半导电层所采用的金属带或线的截面积和电阻率所决定的。
Shielding layer conductivity is made together with the semiconductive layer adopts metal strip or wire cross-sectional area and the resistivity is determined by the.
使用：接好电源、负载及热电阻线后，按下温控器电源开关，温控器即可自动投入定温控制运行。
Operation: Once get power supply, loads and thermal resistors connected, press the power switch of temperature controller, and then it will start temperature control program automatically.
铂丝缠绕电阻式温度探测器(RTD)采用非常精细的高纯度的铂线缠绕在陶瓷芯上，采用玻璃涂层密封。
Platinum wire wound Resistance Temperature Detectors (RTD) construction consists of very fine high purity Platinum wire wound onto a ceramic core and then hermetically sealed with a glassed coating.
有限元计算和电阻网模型试验的结果也表明，坝的各向异性对浸润线的位置有较大的影响。
The results of numerical computation of finite element method and analogy model test of electric resistance network also indicate the serious effect of anisotropy on the position of saturation line.
内套有纤维与电阻线缠绕编织成形；
The inner sheath is formed by reeling and weaving of fibers and resistance wires.
电阻器的元件由全焊接的线绕陶瓷电阻器构成，这是一种众所周知和已定型的技术。
The resistor components consist of fully welded wire wound ceramic resistors, which is a well-known and approved technology.
同时研究了引线及顶线的各项参数变化对天线的有效高度、增益、输入电抗、辐射电阻及静电容的影响。
The affection of parameter variation of down lead wires and top loading wires on effective height, radiation pattern, input reactance, radiation resistor and static capacitance is discussed.
为使通道电阻引起的测量误差最小化，则采用4线切换电路。
To minimize measurement error due to channel resistance, use a four-wire switching circuit.
大功率无感合成电阻的问世，无疑是金属线绕电阻的最佳换代产品。
And it will become the best substitute of metal wirewound resistance for sure in the future.
例如，在小电流和高电阻应用中，没有保护线电缆会产生漏泄电流，从而影响测量准确度。
For example, in low current and high resistance applications, unguarded cabling can introduce leakage current that will degrade measurement accuracy.
通用型电阻分选仪是电阻生产厂家的电阻生产线及相关用户对电阻进行范围筛选的关键仪表，是电阻质量检测的关键仪器。
The universal resistance sorting instrument is a key instrument to both product line of resistance producer and its pertinent user. It is important to test the quality of resistance.
本文讨论了在电子束控制放电激光器中，由于传输线与放电阻抗失配所引起的放电特性的变化。
This paper discusses the change of discharge properties due to mismatch effect between transmission line and discharge impedance in electron beam controlled discharge gas lasers.
本文讨论了在电子束控制放电激光器中，由于传输线与放电阻抗失配所引起的放电特性的变化。
This paper discusses the change of discharge properties due to mismatch effect between transmission line and discharge impedance in electron beam controlled discharge gas lasers.
应用推荐