应用热刺激电流分析测定了几种型号的氧化铁红粉末颜料的表面电荷。
The surface charges of several types of red iron oxide pigment have been determined by using thermoelectrieity analysis.
通过对低压电动机短路电流分析和计算，说明低压电动机短路的种类和保护方法。
By analysis and calculation for short circuit current of low voltage motor, kinds and protection methods of short circuit of the low voltage are explained.
分析了设置剩余电流火灾报警系统的必要性。
The necessity of installing the residual current fire alarm system was analyzed.
分析电流和未来预期了操作的规程和交易的数据为赞助商服从识别并且预先定义电位计划。
Analyze current and future anticipated operational procedures and transactional data to identify and pre-define potential projects for sponsorship submission.
分析了等离子喷涂逆变器在高电压大电流条件下，高频变压器参数设计和IGBT保护问题。
The designing parameters of high frequency transformer and the protecting IGBT in plasma spraying inverter with high voltage and large current is analyzed in this paper.
分析了功率超声波对电化学抛光过程的促进作用及电流密度对抛光效果的影响，获得了较为合理的工艺参数。
The promotion effect of intensity ultrasonic wave on electropolishing process and the influence of ultrasonic wave on polishing quality were analyzed, and better processing parameters were obtained.
对通电线圈的电流及环境温度进行测量的实验结果与理论分析相吻合。
The experimental results of measuring the current of a coil and the environmental temperature agree well with the theory.
以氮气滑动弧为例，分析了其在一个周期内电弧电压、电流、电阻和功率的变化特性。
The arc voltage, current, power and resistance of a nitrogen gliding arc in one period were studied.
本文中对于平均电流模式控制的工作原理和具体实现进行了深入分析。
The principle and implementation of the average current mode control was deeply analyzed in this thesis.
本着节约材料和减少能源消耗的目的，对新型方波交流TIG焊电源电流的调节电路进行了详细的分析与设计。
For the purpose of economizing on raw materials and reducing consumption, the detailed analysis and design of the regulating circuit of TIG electric welder have been presented in this article.
论文分析了数据远距离传输方法，详细论述了电流环的工作原理，根据需要设计了电流环接口电路。
The article analyses the method of long distance transmutation, dentally discusses work principle of current transmitter, designs interface circuit of current transmitter.
此外，通过模拟的手段，分析了各种电路参数对放电电流波形的影响。
Moreover, by the means of simulation, the influence of circuit parameters on the current wave were investigated.
对交流电流引线的趋肤效应进行了分析和讨论。
Finally, the skin effects of AC current leads are analyzed and discussed.
研究了基于相关分析的暂态电流差动保护的原理与性能。
In this paper, the principle and performance of the new type of transient current differential protection based on correlation analysis are investigated.
另外，还对滤波器的结构和参数对输出直流电压脉动和发电机相电流波形的影响及相电流谐波进行了仿真分析。
In addition, the thesis analyzes the influence of the filter structure and parameters on the output DC voltage ripple and the shape of phase currents, as well as harmonics of phase currents.
文中分析了系统平衡变换原理，讨论了系统的平衡方式、补偿电流检测与有源滤波器控制方法。
In this paper, the principle of balanced transformation is analyzed; the balance mode, detection of compensating currents and controlling method of the active filter are discussed.
通过对地铁杂散电流的危害及其产生原因的分析，从理论上提出了一种杂散电流监测的方法。
By analyzing the hazards and causes of stray current, theoretically raises a method for monitoring the stray current.
分析了腔镜反射率、量子阱数等参数对阈值电流、输出光功率的影响，并根据理论计算对器件参数进行了优化设计。
The effects of DBR reflectivity and well Numbers on threshold current and output power of bottom-emitting VCSELs were analyzed to design an optimal device structure.
分析了死区电压矢量和定子电流矢量的关系，由此得到一种根据重构电流矢量来补偿定子电压矢量的方法。
The relationship between the dead-time voltage sector and the stator current sector is analyzed and a method for compensating the stator voltage sector is proposed based on the reconstructed current.
设计了一种用于混合式光电电流互感器(HOCT)的电流传感头。分析了其测量误差，给出解决的方法。
A sensor head for hybrid optical current transformer (HOCT) is designed, the error resource of it is analyzed, and the overcoming method is given.
通过分析产生电流越限和电缆故障的各种原因，画出报警设计的逻辑图。
It shows the logic diagram of alarm design by analyzing reasons of current spillage and cable malfunction.
采用多项式拟合曲线，可以发挥其便于计算和分析的优点，能够更好地反映电流互感器10%误差特性，使用方便。
The interpolation polynomial is applied in curve fitting for easy calculation and analysis and better representation of CT10%error curve.
用混沌动力学方法对多道扫描静电探针的离子饱和电流信号进行分析，研究了等离子体尾迹流场。
A plasma wake flow field is studied by analyzing the saturated ionic current of multiple scanning probes with the method of chaos dynamics.
通过对这种变换器的工作原理分析可知，主辅开关管都可以实现零电压或零电流开关，且电压、电流应力较小。
Through the operational principle it can be verified that all the switches are capable of achieving ZVS or ZCS condition, and the voltage and current stress are relatively low.
对系统总体设计方案进行了研究分析，硬件设计中详细介绍了控制回路的电流检测模块、电机转速和位置检测模块、PWM输出和故障输入电路。
The overall design scheme is researched. The hardware of current detection module, motor speed and location detection module and PWM output and fault input module is introduced in detail.
对系统总体设计方案进行了研究分析，硬件设计中详细介绍了控制回路的电流检测模块、电机转速和位置检测模块、PWM输出和故障输入电路。
The overall design scheme is researched. The hardware of current detection module, motor speed and location detection module and PWM output and fault input module is introduced in detail.
应用推荐