为多层平面电感设计提出了一种全局优化方法。
A global optimization method is presented to optimize the multi-layer planar inductors.
逆变器满负荷时的电感电流有效值和电流峰值是滤波电感设计的两个重要参数。
During full load running of inverter, the inductive current RMS value and the peak current are two important parameters for designing the inductor of the output LC filter.
在电感设计中，直流电阻愈小愈好，其量测单位为欧姆，通常以其最大值为标注。
The unit of measure is ohms, and it is usually specified as a maximum rating.
本文介绍了一种电感式微位移测量仪和数字显示仪的设计与实现。
In this design and implementation of an inductive micro-displacement meter and digital indicator are presented.
系统还内置一个设计做工都非常讲究的功率分频器，它有着相对传统而言更低的低频单元串联电感值。
Design work has also built a system is very particular about the power divider, it has a lower frequency than traditional units in terms of series inductance values.
CMOS工艺的电容和电感是设计lna、VCO等射频电路需要考虑的重要问题。
The inductor and capacitor in CMOS process is an important issue in designing LNA and VCO.
磨损微粒是机械设备磨损的重要信息载体，基于电感测量原理和磨损颗粒的检测要求，提出了电感式传感器的设计。
Wear particle is an important information carrier, on the basis of inductive principle and monitoring requirement of wear particle, the design of inductive transducer is presented.
论述了电爆炸导体的爆炸机制，设计了两个电爆炸断路开关的电感储能电路，通过斩波来产生一个纳秒级大电流的单触发脉冲。
Through studying the mechanism of the electric exploding, an inductive storage circuit with two electric explosive switches is designed to produce shot nanosecond pulse by chopped wave.
主放电回路对回路电感有很高的要求，所以在回路主要部件的参数选取及结构设计当中考虑了这一因素；
Because the main discharge circuit has serious requirement for circuit inductance, when select main components' parameters and conduct architecture design, this factor must be considered.
因此，设计可靠，安全，便捷的电阻，电容，电感测试仪具有极大的现实必要性。
Therefore, the design of reliable, safe, convenient resistance, capacitance, inductance tester of great practical necessity.
本文提出了用8031单片机系统来完成电感测量的方法，介绍了软件设计，给出了硬件电路原理图。
A method for a system with 8031 single chip microcomputer to measure inductance is presented. The software designing is introduced and the circuit diagram is given.
根据有源滤波的特点提出了采用铁硅铝作为铁心材料，利用最小体积法对电感进行了优化设计。
According to the characteristics of active filter, Fe-Si-Al is used and minimum volume method is adopted to optimize the design of inductance.
平面螺旋电感是射频电路设计中最重要的无源元件。
Planar spiral inductor is the most important passive component of CMOS RF integrated circuit design.
本文简要介绍了非晶、微晶铁心的特点和使用情况，介绍了滤波电感的设计和计算方法。
Based on the design of the core inductance of the power filter, this paper presents analysis on the characteristics of the amorphous core and the microcrystalline core.
此外设计了基于TMS320F 2812和IPM模块的硬件实验系统，介绍了硬件系统的电感和电容的参数设计。
In addition, the hardware system was designed on the basis of TMS320F2812 and IPM module and the parameters design of inductance and capacitance was presented.
设计了一种新型数字电感测量仪，介绍了测量电路原理及其所用的元件，并进行了误差分析。
In this paper a new digital inductance tester is designed, its circuit principle and components used in the tester are described, and error analysis is given.
该模型可望用于硅基射频集成电路中电感的优化设计和进一步的理论探讨。
Hopefully, it can be applied to further theory research and optimum design of RFIC spiral inductors on si.
本测量装置采用改型设计的电感测量，测量结果通过电子柱形式表示。
The design was improved by inductance sensor. Showd the electronic micrometer the measuring result.
最后分析了磁性元件的特性，变压器，电感的设计和MOSFET开关器件的选型。
Ultimate analysis magnetic elements' characteristic, transformer, inductance design and MOSFET switch component's shaping.
设计的关键是采用微波串联电感反馈方法同时获得最佳噪声和最小输入驻波匹配。
The key to this design is to achieve a simultaneous optimum noise match and a minimum input VSWR match by using the microwave series inductance feedback method.
采用有限元法和增量电感公式对一种新型电极结构的电光调制器进行了理论分析和设计。
The characterization and design of LiNbOa optical modulators of novel electrode structures are discussed by using the finite-clement method (FEM) and the incremental inductance formula.
讨论了位移传感器对电磁轴承系统控制精度的影响，在此基础上提出一种差动电感式位移传感器的设计方案。
Discuss the controlling accuracy of displacement sensor used in AMB system. On the basis of this, a design program of differential conduct displacement sensor is given.
实验结果证明：用最优化方法设计的变螺距线圈，使电感传感器的有效线性输出范围得到了显著的提高。
The results of experiments have shown that the available linear range of output voltage of the optimized inductive transducer with solenoid pitch varying ino.
为了验证活塞式螺旋绕组磁通压缩发电机（MFCG“）减小电感以放大电流”的工作原理，设计制作了活塞式螺旋绕组MFCG原理样机，并完成了原理实验。
A kind of piston-type magnetic flux compression generator (MFCG) prototype model with a helix winding is developed to prove the working principle of decreasing the inductance for the enlarged current.
分析了泵用BLDCM的电磁设计，考虑电感对电机的影响，改进了电机设计程序。
Electromagnetic design of BLDCM for pump is analyzed and design procedure is improved considering the influence of inductance on motor.
并在该模型的基础上，分析了耦合器漏感与励磁电感对感应充电系统的影响，设计制作了实验系统耦合器。
Based on this model, the paper analysed the influence of magnetizing inductance and leakage inductance on inductive charging system, then designed the coupler of inductive charging experiment system.
本文通过分析这个过程，给出了适合这种工作的点火线圈(即电感线圈)的基本设计方法，同时还提供了测试点火线圈工作效率的方法和手段。
Through analyzing the process, this paper proposed a basic design method of the ignition coil (inductance coil). It also gave some ways for measuring the work-efficiency of the ignition coil.
本文设计了一种以8031单片机为核心的高分辨电感应变数字测量装置。
An inductive strain digit measuring device with 8031. single chip microcomputer has been designed with high resolution.
本文设计了一种以8031单片机为核心的高分辨电感应变数字测量装置。
An inductive strain digit measuring device with 8031. single chip microcomputer has been designed with high resolution.
应用推荐