最后通过切齿试验证明了本文理论分析计算的正确性。
The correctness of the theoretical analysis and calculation has been proved by shaping experiment.
经理论分析计算扣除了这些因素的影响，修正了JR曲线。
The influence factor to the JR was deducted by theoretical analysis. an…
经理论分析计算扣除了这些因素的影响，修正了JR曲线。
The influence factor to the JR was deducted by theoretical analysis. and the JR curve was...
通过材料力学理论分析计算了主要承载部件横梁、立柱的强度和刚度。
Throughelastic structure analysis theoretical calculation main load bearing part crossbeam, columnintensity and rigidity.
高温中再生混凝土柱温度反应分析及高温后再生混凝土柱承载力有限元理论分析计算。
The thermal response the recycled concrete column at high temperature and the bearing capacity of the recycled concrete column are analyzed by ANSYS FE method.
经理论分析计算，确定变速泵理想的转速，确定调节阀理想的开度，调节过程一次完成。
Calculation by theoretical analysis may ascertain the ideal rotate speed of variable-speed pump and ideal opening of regulating valve, completes adjust process at one time.
作者研制了差动式电感传感器，对实际铸件进行了测试，测试结果与理论分析计算一致。
The authors have studied and developed a differential inductive sensor, by which some actual castings ha...
在进行理论分析计算的基础上，给出该问题的定量求解方法，并在工程应用中取得了良好效果。
Based on the theoretical analysis and calculation, a quantitative solution is given and good results in engineering application are obtained.
在此基础上，采用环境随机振动法进行动载试验，并对理论分析计算值和动测试验值进行比较分析。
Through the ambient vibration testing, this paper make a comparative analysis of the theoretical conclusion and experimental data.
论文通过试验研究和理论分析计算，对组合梁界面水平相对滑移和竖向掀起性能进行了比较系统的研究。
By using finite element method, the paper makes the analysis of steel concrete composite beam 'slip and uplift.
采用传统的岩石力学理论分析计算岩石边坡的开挖变形时，发现计算的边坡位移量远小于实际的边坡位移量。
The rock slope displacement that is calculated using classical rock mechanical theory is much smaller than the actual displacement.
对于连续与离散积分型变结构控制，分别从理论分析计算与数值仿真两种途径得到了典型惯性过程的参数可摄动范围。
The perturbation domains of parameters in typical inertial process are obtained by theoretical analysis and numerical simulation respectively for continuous and discrete integral VSC.
应用AHP方法，建立了因素指标间的层次结构分析模型，通过理论分析计算与专家咨询，确定了各指标在评价中的权重；
Using the AHP method, this paper establishes level-structure analysis model, and determines the weight of various targets by theoretical analysis and experts consultation.
压强的测量采用半导体硅压阻式压强传感器，通过测量MPT进气管路的静压，结合理论分析计算得到MPT谐振腔的总压。
The measurement of pressure was carried out by using semiconductor silicon piezometer. With the static pressure in inlet of pipeline and theoretic analysis we could get the total pressure of MPT.
同时本文借助矩阵变换的计算力学方法，考虑进了车轮外倾角和前束角，准确的对转向车轮在转向时的运动变化进行理论分析计算。
At the same time, we academic analyze and compute the steering wheel during the vehicle turnaround using the transform matrix method considering the camber Angle and toe Angle.
本文通过理论分析计算，结合多次的实验结果，对该方面的设计提出一套比较完整的设计和控制方案，对今后类似试验技术的研究开发具有良好的借鉴作用。
This article provides a complete design and control method according to the theory calculate and analyse of experiments. It is useful to improve the research about alternative pressure test.
它有很多实际应用，因为它所强调的是计算机维护和分析的理论基础。
It has few practical applications, because it concentrates on the theoretical underpinnings of computer maintenance and analysis.
文中给出了详细的理论分析和计算方法及部分实验结果。
Theoretical analysis and calculation method are given in detail, and part of experimental results are presented.
在此模型的基础上进行了理论分析和数学计算。
On the basis of the model theoretical analysis and mathematical calculation are carried out.
当待融合数据为两个时，通过理论分析得到了计算融合参数的公式。
Through theoretic analysis, we obtain the formula to calculate the parameters for fusion of two uniform distribution data.
针对柴油机（4 85 ）低频排气噪声，对其产生机理、规律及其影响因素等作了理论计算、分析及实验。
The low frequency exhaust noise of a diesel(4 85), its generation, frequency characteristics and influencing factors have been studied through theoretic calculation, analysis and experiment.
论文包括四部分：气动分析与计算理论、紊流风场模型、动态失速模型、组件软件开发。
This paper includes four sections: aerodynamic analysis and calculation, turbulent wind field model, dynamic stall model, develop software with COM.
本文对格构式变截面吊臂金属结构的临界力计算作了理论分析。
This paper theoretically analyzes the critical force in metal hoisting boom structure of lattice type and variable section.
论文论述了每一种算法结构的原理，从理论分析和计算机仿真两方面对算法性能进行了研究。
Principles of each blind estimation structure are presented in this thesis and the algorithm performance is studied by both theoretical analysis and computer simulation.
通过对四种二次曲线截面的柔性铰链的理论计算和有限元分析，比较分析了它们的力学特性。
Theory calculate and finite element method to symmetric conic-section flexure hinges is used to compare and analyze their dynamics characteristic.
理论分析和计算机模拟结果表明：运用码变换的方法来产生回波抵消信号是可行的，这将有利于用数字方法来实现。
The theoretical analysis and the results of computer simulation showed that it is possible to build a cancelling signal by means of code transformation.
两个典型算例的理论分析和实际计算表明，这种预条件方法可以降低方程的迭代次数约30%，明显减少方程求解时间。
The theoretical analysis and numerical results of two typical examples show that this method can decrease the numbers of iterative by30%and reduce the computation time greatly.
在计算结果的基础上，结合其他同类型桥梁的理论计算和试验结果，分析了该类型桥梁的动力特性。
The dynamical characteristic of this kind of bridge is analyzed basing on the calculation results and referring to the results of theoretics calculation and testing of other similar bridges.
在计算结果的基础上，结合其他同类型桥梁的理论计算和试验结果，分析了该类型桥梁的动力特性。
The dynamical characteristic of this kind of bridge is analyzed basing on the calculation results and referring to the results of theoretics calculation and testing of other similar bridges.
应用推荐