热态试验结果表明，铸铜冷却壁与轧制铜冷却壁在热态性能上没有大的区别，冷却能力很好，壁体与埋管间没有气隙热阻。
The result shows that there is no difference in thermal properties between cast copper stave and rolled copper stave. The cooling capacity of cast one is very good.
结果表明，窄隙流道内的换热在低雷诺数区表现出与普通流道不同的多变特性，而在高雷诺数区与普通流道相近。
The results show that the performance of heat transfer in lower re number region is poly tropic, and that in higher re region is similar to conventional channel.
本文运用热弹性力学原理，分析了温度变化对啮合齿轮侧隙的影响以及对齿厚偏差选择的影响。
Based on the thermal elastic mechanics, the influence of temperature change on the normal backlash was analyzed, and the deviation of teeth width was calculated.
通过分析文献实验数据，得出了在整个凝固过程中热传递系数与空气隙成反比的半经验耦合表达式。
A semiempirical inverse equation was used to characterize the HTC air gap relation across the whole stages through the analysis of the experimental data of the literatures.
论述了气隙式热开关的原理、结构形式及参数特性，讨论了它的结构尺寸对性能参数的影响。
This paper represents the principle, structure and characteristics of the gas gap heat switch. The influences of structure dimension on the performance parameters of heat switch have been discussed.
推入总线125的第一分支127可以占据96个时隙，其中每个时隙都为热传感器120之一所保留。
A first branch 127 of the push bus 125 May take up to 96 time slots, where each time slot is reserved for one of the thermal sensors 120.
该LM 1085电路包括1齐纳修剪带隙参考，电流限制和热关机。
The LM1085 circuit includes a zener trimmed bandgap reference, current limiting and thermal shutdown.
给出了肋片的厚度、长度、气隙宽度、外壳壁厚与导通热导之间的关系曲线以及气体压强、外壳厚度与关断热导之间的关系曲线。
The relationships between thickness of the fin, length of the fin, gap clearance between fins and on-inductance are given. The off-inductances as functions of gas pressure, thickness of exterior...
研究结果表明：当坯壳角部有明显的气隙形成时，铸坯偏角区成为热节区。
The simulation results indicate that hot spot is formed at the billet corner when there is an enough large air gap...
影响通量的主要因素是空气隙的传质阻力，影响分离因子的主要因素是膜热侧蒸发表面和冷侧冷凝表面之间的温度差。
The major factor affecting the flux is resistance to mass transfer in the Air Gap. The major factor affecting the separation fact…
影响通量的主要因素是空气隙的传质阻力，影响分离因子的主要因素是膜热侧蒸发表面和冷侧冷凝表面之间的温度差。
The major factor affecting the flux is resistance to mass transfer in the Air Gap. The major factor affecting the separation fact…
应用推荐