在本文中，我们选择一个虚构的汽车风挡刮水器公司进行案例分析。
For this article, we've chosen a fictional automobile windshield wiper company as a case study.
底部显示刮水器电动机的行动。
前风挡刮水器离开驻车位置后锁定。
The front windscreen wiper locks after leaving the parking position.
前风挡刮水器启动后不离开驻车位置。
The front windscreen wiper does not leave the parking position when activated.
安装车门挡水器和装饰板。
汽车挡风玻璃上刮水器的速度是可变的。
挡风玻璃的刮水器得换了。
固定的睡眠中睡眠如果冷冻水器是空的。
Fixed sleeping freezing mid sleep if a water collector was empty.
安装车门挡水器和装饰板。
本文介绍一些刮水器间歇控制应用电路。
A few intermittent control circuits of wipers are introduced here.
文章重点介绍套筒式滗水器的设计及应用。
The design and application of a new style SBR water decanter was studied in this paper.
电热蒸馏水器是化学实验室的常规设备之一。
Electrothermal distiller is one of the common devices in chemistry laboratory.
真空预冷装置中，捕水器是一个十分关键的部件。
The vapor condenser is a very important device in vacuum pre-cooling equipment.
定量分析的水样用有机玻璃采水器，用视野法计数各属的细胞数。
Water specimen for quantitative analysis was put into organic glass hydrophore and then the cells were counted with perioptometry.
论述了无转速转矩传感器的刮水器电动机机械特性测试基本原理；
The essential theory of the mechanical characteristic test of the wiper motor without torque and speed sensors is discussed in this paper.
防弹衣，走火通道，和汽车上的风窗玻璃刮水器，三者有什么共同点？
Q. What do bulletproof vests, fire escapes, windshield wipers, and laser printers all have in common?
刮水器是汽车上的重要设备之一，它的好与坏关系到汽车能否安全行驶。
Wiper is one of the most important equipment of auto, it is essential to auto's safety driving.
介绍如何应用DF 系统原理设计小直径深孔加工中吸压送水器的问题。
The article describes how DF concept is used in the design of pressure feeders in small-diameter deep-hole drilling process.
我们认为泌水器可提供为日后研究植物细胞膜内噬作用的一个理想研究系统。
We suggest that the hydathode is an ideal system for studying endocytosis in plants.
探讨了冻结速率、升华温度、干燥室及捕水器温度、压强对干燥时间的影响。
The influence of freezing rate, sublimation temperature, the temperature and pressure of drying room and water catching machine on the freeze drying process was discussed.
研究了采用磷化处理工艺代替传统的镀锌工艺以提高汽车刮水器弹簧的防腐能力。
This paper proposes a new anticorrosive process of phosphating instead of the traditional process of zincification to improve the ability of corrosion prevention of windscreen wiper.
探讨了冻结速率、物料温度、干燥室及捕水器温度、压强对冷冻干燥过程及制品质量的影响。
The influence of freezing rate, materiel temperature, the temperature for drying room and water catching machine on the freeze drying process and the quality of the products were discussed.
厌氧反应器uasb在实际运行中，其底部的布水器经常出现堵塞，从而造成了配水的不均匀。
Once the water distributor on the bottom of UASB is often blocked, when operating in practice, the uniformity of water distribution is destroyed.
刮水器间歇控制与刮水器控制开关、刮水间歇控制继电器及其在刮水器工作电路中的控制方式有关。
The intermittent control of wipers is related to the control switch, control relay and its control mode of the wipers operating circuit.
介绍一种用实验的方法求解配水器水嘴嘴损的方程，并根据该方程制作了配水器水嘴嘴损曲线图版。
This paper brought in an experimental method to crack the nozzle choke loss formula and drew out the curve chart of choke loss.
分析了小波脊线与信号瞬时频率的关系，提出了基于小波脊线的刮水器电动机机械特性测试新方法。
The relationship between wavelet ridge and instantaneous frequency is analyzed and a new method of the mechanical characteristic test of the wiper motor based on wavelet ridge algorithm is proposed.
介绍了捕水器的内部结构和捕水特性，建立了物理模型，对水蒸气在捕水器管路凝结问题进行了理论计算。
Its interior structure and vapor condensation characteristic are introduced, and the physical model is constructed. The vapor condensation process around water condenser is calculated in theory.
前言：本文对铜合金复水器腐蚀原因及“镀铜”现象产生原因进行了探讨，并在此基础上提出了防腐蚀对策。
This paper discussed the reason of the copper metal alloy exchange-heat corrosion and "copperizing" phenomenon, and put forward the antisepsis countermeasure.
前言：本文对铜合金复水器腐蚀原因及“镀铜”现象产生原因进行了探讨，并在此基础上提出了防腐蚀对策。
This paper discussed the reason of the copper metal alloy exchange-heat corrosion and "copperizing" phenomenon, and put forward the antisepsis countermeasure.
应用推荐