当潜水员们走向海岸时，铅坠和氧气缸让他们步履维艰。
Lead weights and air cylinders encumbered the divers as they walked to the shore.
最后一步是将蒸汽引入气缸，使得活塞前后推动，从而提高了发动机的速度，降低了燃料消耗。
The final step came when steam was introduced into the cylinder to drive the piston backward as well as forward, thereby increasing the speed of the engine and cutting its fuel consumption.
这种提取通常借助于内尔特气缸。
This extraction is usually aided by the use of a Wehnelt cylinder.
这将意味着安装一个三通电动阀，一个气缸恒温器并对管道布局进行一些更改。
This will mean installing a three-way motorised valve, a cylinder thermostat and making some changes in the pipe layout.
使用叶片式风速仪测量模拟气缸内的涡流转速。
The blade type anemograph is used to measure and simulate the turbulence speed.
控制气缸内的压力急剧上升。
否则会造成轴承及气缸内部元件的损坏。
Otherwise it will cause bearings and cylinder damage internal components.
气缸选用铝金材料，重量轻、外形美观。
Use aluminum alloy cylinder material, light weight, beautiful appearance.
为什么不用具有八个气缸同等排量的一个大气缸代替？
Why not have one big cylinder of the same displacement of the eight cylinders instead?
一个版本的品种引导无杆气缸，包括引导和非。
A variety of rodless cylinders including guided and non-guided versions.
最常见的气缸盖类型是半球形，楔形和准半球形。
The most common cylinder head types are the hemi, wedge, and semi-hemi.
气缸向相反的方向旋转，所产生的吸力立刻阻止了涡流的形成。
The cylinders spin in opposite directions, creating suction that immediately prevents eddies from forming.
每一种方式是指气缸从内燃机的前面或后面看上去的方位。
Each refers to the orientation of the cylinders as viewed from the front or back of the engine.
气缸活塞直接连接到每个导杆，节约不牺牲输出力的大小。
Cylinder pistons are attached directly to each guide rod, conserving size without sacrificing output force.
气缸盖采用铝合金材料制成，具有重量轻，重量和散热良好。
Cylinder head made of aluminum alloy, which is light-weight and excellent in heat radiation.
这一机构有一系列部件组成，如曲柄箱、气缸体、活塞、连杆、曲轴等。
The mechanism consists of several parts like crankcase, cylinder block, pistons, connecting rod, crankshaft, etc.
维修及安装铁路车辆部件如压缩机，空气阀，轴承，联轴器，气缸和管道。
Repair and install railway car parts such as compressors, air valves, bearings, couplings, air cylinders and piping.
该腔室有一个很纤细的偏心气缸，它可以旋转以使唤得下部或者上部狭槽的气流更强。
This chamber contains a slightly eccentric cylinder which can be rotated to make either the upper or the lower slots bigger.
气缸上的孔最可能出现在气缸顶部（装阀门和火花塞的部位也即气缸盖）。
The most common "hole" in a cylinder occurs where the top of the cylinder (holding the valves and spark plug and also known as the cylinder head) attaches to the cylinder itself.
在二冲程发动机中你必须混和燃料和气体，因为气缸壁上的孔阻止使用活塞环密封燃烧室。
You have to mix oil into the gas in a two-stroke engine because the holes in the cylinder wall prevent the use of rings to seal the combustion chamber.
那台机器由气缸、活塞、旋转轴、齿轮、轴承、螺栓、螺丝钉和不锈钢外壳组成。
The machine consists of cylinder, piston, rotary, shaft, gears, bearings, bolts, screws and stainless steel crusts.
当潜水器以一定的角度接近当前水流时，压力传感器检测到涡流的形成，并启动气缸开始旋转。
When the submersible heads at an Angle into the oncoming flow, the pressure sensors detect the formation of eddies and start the small cylinders spinning.
当活塞上行压缩气缸中的混合气体，火花塞点燃气体燃烧，通过气缸上另一个孔排气。
As the piston moves up it is compressed, the spark plug ignites combustion, and exhaust exits through another hole in the cylinder.
气缸体与气缸盖之间的结合处必须保持密封，并且能够承受燃烧室产生的高压和高温。
The joint between the cylinder block and the head must be tight and able to withstand the pressure and heat developed in the combustion chambers.
每隔两周用温肥皂水清洗引擎也是个好主意，这样可以去除堵塞气缸的过量粉尘和污垢。
It's also a good idea to wash your engine with warm soapy water every couple of weeks to dislodge the excess dust and grime that builds up on your engine block.
以前面的例子来说，在气缸活塞和汽化器到位前，将发动机装配到摩托车架是没有意义的。
Using the example from earlier, it does not make sense to mount the engine of the bike to the frame of the bike before the pistons and carburettor are in place yet.
以前面的例子来说，在气缸活塞和汽化器到位前，将发动机装配到摩托车架是没有意义的。
Using the example from earlier, it does not make sense to mount the engine of the bike to the frame of the bike before the pistons and carburettor are in place yet.
应用推荐