应用该家用电器模糊控制开发平台大大提高了模糊控制系统设计质量，缩短设计时间。
With fuzzy control software development platform, the design quality of fuzzy control system is improved and the design period is cut down.
并进行了仿真研究，结果表明，基于稳定性而设计的模糊控制系统不仅具有良好的动态及稳态的性能，而且具有很强的抗扰能力。
The simulation results show that fuzzy control systems which are designed based on the stability have not only good dynamic and steady state feature but also strong rejection ability to disturbances.
摘要：针对高速公路交通系统的非线性、时变特性，设计了一种模糊自适应控制器，并将其应用于高速公路匝道控制系统。
Abstract: Aiming at the nonlinear and time-varying characteristics of freeway traffic system, a fuzzy self-adaptive PID controller is designed and applied to freeway ramp metering in this paper.
本文论述了一种预估模糊逻辑控制系统的工作原理和设计方法。
This paper presents the principle of a predictive fuzzy logic control system and the design method of it.
这两种方法可完全消除量化误差和调节死区，为设计高精度模糊控制系统提供了一种新途径。
The two methods can eliminate quantization errors and adjusting dead zone thoroughly, and provide a new way for designing fuzzy control system with high accuracy.
设计了基于CAN总线的预焙铝电解槽计算机控制系统的总体方案及基于混沌优化的电解质温度模糊控制器。
The computer control system scheme of Aluminum electrolytic cell based on CAN bus and Fuzzy controller based on chaos optimization are designed.
模糊控制系统的稳定性分析和设计方法一直是较活跃的研究课题。
The analysis and design of controllers for fuzzy control systems have been an active question for a long time.
针对多输入多输出非线性锅炉-汽机系统在大范围运行工况下参数发生变化的情况，设计了基于渐近跟踪控制的T - S模糊控制系统。
T-S fuzzy control system based on asymptotic tracking control is designed for a MIMO nonlinear boiler-turbine system whose parameters vary under the operating condition within wide range.
第四章探讨了自适应模糊控制系统的设计与稳定性分析方法。
In chapter 4, design and stability analysis methodologies of adaptive fuzzy control system are discussed.
设计出模糊控制器，并建立温室温度的模糊控制系统。
A fuzzy controller for the greenhouse is designed, and the fuzzy control system of the greenhouse temperature is built up.
本文的主要工作是机械臂终端多自由度视频头调节机械手的运动学建模及其参数自适应模糊PID控制系统的设计。
The kinematics modeling and parameters adapt fuzzy-PID control system design of the video regulator manipulator on the terminal of the arm is the focus of this text.
针对四轮驱动汽车，应用模糊理论设计了牵引力控制系统的油门控制器和制动控制器。
Fuzzy theory was used to design throttle controller and braking controller of traction control system for four-wheel drive vehicles.
本文在前馈式智能模糊控制系统原型的基础之上，对该系统的各个组成部分进行详细的研究与设计。
On the base of feed-forward intelligent fuzzy logic control system prototype, this paper performs particular research and design to each constituent of this system.
将专家系统和模糊控制的理论应用到温度控制过程中，介绍了这类专家模糊控制系统的设计方法。
The design of an expert fuzzy control system which applies expert system theory and fuzzy control theory to temperature control process is described.
采用现代设计方法设计的工业洗衣机模糊控制系统各项性能均达到设计要求，超过国家相关标准。
Designed with the modern design methods, each capability performance of the fuzzy control system of industry washing machine reaches design requirements and surpasses the relevant national standard.
本文提出了一种在线插值模糊控制方法，设计了在线插值模糊控制器，并在炉温控制系统中应用。
Puts forward a new kind of online interpolation fuzzy control method, and at last the controller is applied in the temperature control system of furnace.
为了削弱变结构控制中的颤振现象，采用了模糊变结构控制方法，并将该方法应用于反舰导弹的过载控制系统的设计中。
In order to reduce chattering phenomenon of variable structure control, a fuzzy variable structure control method is adopted and applied in the overload control system design of anti-ship missiles.
文中以罗克韦尔的三层网络控制系统为平台实现了模糊控制算法的设计。
The design of fuzzy control algorithm based on the Rockwell three-layer network control system is realized.
然后介绍了模糊控制系统的概念、基本控制思想，简述了模糊控制器的设计方法，给出了模糊控制系统的一般模型。
Then it introduces the concept of fuzzy control system and basic control ideas, and demonstrates the design approaches of fuzzy controller, and gives the general model of fuzzy control system.
实验结果表明，本文所设计的模糊pid控制系统比常规pid控制系统具有更优良的控制品质。
The experiment results show that the fuzzy PID control system designed in this paper has better control performance than conventional PID control system.
在分析了真空感应熔炼供电控制对象特性的基础上，设计了基于模糊PID控制的计算机控制系统。
On the basis of analyzing speciality of VIM's power supply control system, computer control system based on fuzzy PID control is designed.
本文最后设计了直升机模糊pd轨迹跟踪控制器，与姿态角控制器相结合，完成对整个飞行控制系统的设计。
Finally, the dissertation designed the fuzzy PD controller of trajectory tracking, which is combined with attitude Angle controller, so that the whole flight controller is completed.
在前馈控制器设计思想的启发下，提出了一种基于神经模糊系统的自适应前馈-反馈控制系统。
Motivated by the designing idea of conventional feedforward control, an adaptive feedback-feedforward control scheme based on neuro-fuzzy system is proposed.
文章着重介绍模糊逻辑控制、神经网络控制以及它们的交叉结合的神经网络-模糊控制系统及其应用与设计。
Emphasis is put on the fuzzy logic control, neural network control, and both crossed neural network with fuzzy control system along with its application and design.
然后应用一种改进的模糊神经网络自适应控制系统，设计了TCBR的控制器。
Then, applying adaptive control system based on improved fuzzy neural network, a TCBR controller is designed.
该方法把模糊控制技术和PID算法结合起来，采用多模态分段控制设计出温湿度控制系统。
The method combines fuzzy control technology with PID algorithm and applies the multi mode control to design a control system of temperature and humidity.
同时又设计了模糊自校正控制，进一步提高控制系统的控制品质。
At the same time the fuzzy correct control is actualized to further improve the character of.
参考电容器卷绕装置制作了由单片机控制的张力控制系统，并设计了模糊控制器。
Referenced to the capacitor winding machines, we made a tension control system with the single -chip micro-computer and designed a fuzzy controller.
使用反馈线性化与改进的模糊控制方法设计飞机纵向自动着陆控制系统。
The control system for longitudinal automatic landing of an aircraft was designed with the methods of feedback linearization and improved fuzzy control.
使用反馈线性化与改进的模糊控制方法设计飞机纵向自动着陆控制系统。
The control system for longitudinal automatic landing of an aircraft was designed with the methods of feedback linearization and improved fuzzy control.
应用推荐