• 利用大型有限单元程序ANSYS对框架频率进行模拟计算计算试验进行了对比。

    A simulative calculation was conducted of the natural frequencies of the frame towers using large-scale finite element program ANSYS, and the calculated value was compared with the test value.

    youdao

  • 采用上游加权单元均衡解法数学模型进行求解模拟计算结果进行了分析讨论。

    The upstream weighted multi cell balance method was used to solve the mathematical model, and simulation results are analysed and discussed.

    youdao

  • 通过运用有限单元静力凝聚法,对结构模型振动试验进行了模拟计算,建立简化分析模型。

    The finite element method and static condensation technique are used to simulate the responses of a steel frame model under the excitation of the shaking table.

    youdao

  • 讨论了有限元高速模拟计算中出现滑移问题单元畸变问题,给出相应处理方法

    The problems of sliding surface and severely distorted element in hyperveiocity impact simulations are discussed, and the corresponding solving ways are proposed.

    youdao

  • 本文就DYNAFORM软件单元尺寸回弹模拟计算关系进行了研究,得出了相应结论

    In this paper, the relation of springback simulation and mesh size is studied with DYNAFORM software, and the relative results are worked out.

    youdao

  • 应用PROCESS模拟程序,乙二醇装置进行流程模拟计算确定单元操作模型热力学方法计算结果与国外设计数据相吻合。

    The process simulation is performed for ethylene glycol plant by using the PROCESS simulation programme, and the unit operation model and the thermodynamic method are determined.

    youdao

  • 首次消除焊接应力数值模拟研究中,采用接触单元技术建立有限元模型模拟计算锤击作用。

    In the numerical simulation of relieving residual stress by hammer peening, contact element technique was firstly adopted for establishing the finite model and calculating the hammer peening.

    youdao

  • 采用上游加权单元均衡解法数学模型进行求解模拟计算结果进行分析和讨论。

    The upstream weighted multi cell balance method was used to solve the mathematical model, and simulation results are a.

    youdao

  • 本文有限单元坑道内的直流电阻率测深进行数值模拟计算

    In this paper, we performed modelling of DC resistivity sounding in tunnel using the finite element method (FEM).

    youdao

  • 本文阐述在大地电磁测深工作中,有限单元模拟计算京津唐地区地质构造的大地电磁响应

    The magnetotelluric response to the two dimension structures has been numerically modeled by use of the finite element method.

    youdao

  • 实验结果表明两个组合的变形镜的相位校正能力强于单个32单元变形,并且数值模拟计算结果一致

    The experimental results are in agreement with the numerical simulation results. It is indicated that the CDM AO system provides better correction performance than the single 32-element DM AO system.

    youdao

  • 最后通过计算模拟计算得出扫描对比度曲线以及相控阵调制单元上所加补偿电压

    Also, computer simulation is conducted to work out the contrast curve of scanning spots and the offset voltage across the modulation unit of the optical phased array.

    youdao

  • 最后通过计算模拟计算得出扫描对比度曲线以及相控阵调制单元上所加补偿电压

    Also, computer simulation is conducted to work out the contrast curve of scanning spots and the offset voltage across the modulation unit of the optical phased array.

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定