阻值将根据如下表格中所施加的电压值后进行测量。
Resistance shall be measured using the applied voltage values of the following table.
并分析了施加的电压、压电片数和阻尼对刀头振幅的影响。
The impact of voltage, number of piezoelectric and damp on scalpel vibration amplitude is analyzed.
当施加的电压变化时，非常高值电阻器的阻值可能会发生很大的变化。
Very high ohmic value resistors may exhibit a significant change in resistance with a change in applied voltage.
有些绝缘体的性能会随施加的电压发生变化，因此评估绝缘电阻的预期工作电压是非常重要的。
The properties of some insulators change with applied voltage, so it is important to evaluate IR at or above the expected operating voltage.
通过考察施加的电压和运行缓冲液的组成对氯氮平电泳峰平台形成的影响确定了最优分离条件。
Effects of separation voltage and composition of running buffer on the plateau were investigated and the optimized...
基于各种材料的本构关系，导出了多层压电片作用在梁结构上的力和所施加的电压以及结构的运动之间的耦合关系和系统的控制微分方程。
The formula of actuating force produced by multiple piezoelectric patches and the control equations of multi layer beam are derived based on the constitutive relations of different materials.
他有一根装着电极的管子，里面充满了氢原子。通过施加电压，他能够使气体发光。
He had a tube with electrodes potted in it filled with atomic hydrogen. And by applying a voltage, he was able to get the gas to glow.
通过在针状物上施加电压，一个从液体提取离子并加速他们到一个非常高的速度然后强迫它们飞离的电场就被创造出来。
By applying voltage to the needles, an electric field is created that extracts the ions from the liquid, accelerates them at very high speeds and forces them to fly away.
一根同样非常纯的金线与银线呈交叉状，同时在两根线上施加一个较小的电压。
An equally fine gold wire is laid crosswise to the silver wire and a small voltage is applied across the two wires.
纳米电子蚀刻素描可以通过施加负电压，对画好的线路进行选择性清除。 他们的成果刊登在去年出版的《科学》杂志上。
Not so with the nanoelectric Etch A Sketch, which can selectively erase the conducting lines it creates by applying negative voltage.
当显微镜的尖端把正电压施加到材料表面时，它就在氧化层之间的空白处画出了导线。
When the microscope's sharp tip applied a positive voltage to the material's surface, it drew conducting lines that exist in the space between the oxide layers.
尽管可能会闭合多条路径，但实际应用中，只有在DC测试中才会用到，例如对多个DUT施加连续的偏置电压。
Although it is possible to close multiple paths, this is practical only in DC testing, for example, to apply continuous bias voltage to a number of DUTs.
他们把一个只有十几个碳原子的刚性碳链置于真空室中，并对样品施加425v的电压。
They placed a rigid chain of carbon atoms, just tens of atoms long, in a vacuum chamber and streamed 425 volts through the sample.
为了确定特定电压下的漏流，可以向该电路施加一个该幅值的阶跃电压。
To determine the leakage current at a particular voltage, apply a step voltage of this magnitude to the circuit.
通过施加一个已知的电压，然后测量通路至地或通路至通路的电流，即可确定漏泄电流。
The leakage current can be determined by applying a known voltage and measuring the current between either path to ground or path to path.
通过施加规定的反向电压，然后测量产生的漏泄电流，即可完成漏流测试。
To perform the leakage current test, source a specified reverse voltage, then measure the resulting leakage current.
为了进行测量，在预定的时间(通常为60秒钟)内，给样品施加恒定的电压。然后，用皮安计或静电计测量产生的电流。
To make the measurement, a constant voltage is applied for a predefined period, usually 60 seconds, and the resulting current is measured with a picoammeter or electrometer.
偏移电压会导致施加到被测装置的激励发生误差，或者使伏特计的测量值发生误差。
The offset voltage will cause an error in the applied stimulus to a device under test or the value measured by the voltmeter.
泄漏电流随时间呈指数衰减，所以通常需要在一个已知的时间期间内施加电压(浸润时间)，然后再测量电流。
The leakage current will decay exponentially with time, so it's usually necessary to apply the voltage for a known period (the "soak" time) before measuring the current.
通过施加规定的反向偏流，然后测量二极管两端的电压，即可测得反向偏置电流。
Measure the reverse breakdown voltage by sourcing a specified re verse current bias, then measuring the voltage drop across the diode.
由于材料按指数形式不断充电，所以施加电压的时间越长，测量出的电流就变得越低。
The longer the voltage is applied, the lower the measured current becomes because the material continues to charge exponentially.
为了确保磁保持继电器可靠动作，施加到线圈上的激励电压须达到额定值，且脉冲宽度设置须达到动作时间的3倍以上。
Ln order to ensure the reliability of relay coil voltage, must reaeh value, the pulse width must be 3 times more time.
漏泄电流是在施加电压时通过绝缘的误差电流。
Leakage current is an error current that flows through insulators when a voltage is applied.
当必须严格控制从施加电压到进行测量之间的时间间隔时，就需要采用热切换。
Hot switching may be required when the interval from when power is applied to the point when the measurement is made must be closely controlled.
分析了4极断路器非正常跳闸的原因，提出采用施加外接辅助电源电压的解决措施。
The cause of the improper trip of 4 pole circuit breaker was analyzed. A subsidiary power voltage is applied to solve the problem.
在测量电流之前，施加一定时间周期的测试电压。
The test voltage is applied for a specified period of time before the resulting current is measured.
用交变电压调制固定在光纤光栅上的PZT，同时对施加在光栅上的应力进行测量。
The PZT is modulated by periodicity voltage and the fiber grating fixing on the it is also modulated by PZT.
用交变电压调制固定在光纤光栅上的PZT，同时对施加在光栅上的应力进行测量。
The PZT is modulated by periodicity voltage and the fiber grating fixing on the it is also modulated by PZT.
应用推荐