总线是连接计算机各部件的一簇公共信号线，由地址总线、数据总线和控制总线组成。
The bus is the computer parts connected by a bunch of public signal, address bus, data bus and control bus composition.
第四章讨论总线管理，阐述了数据传输、流量控制和差错控制在网络式仪器总线中的实现。
In chapter four, describes the bus management, and discussed the implementation of data transfer, flow control and error control in the network-stye instrument bus.
总线控制协议是高速多路串行数据总线的关键，它决定了多路串行数据总线的实时响应能力以及在高负载和低负载情况下的串行数据总线的特性。
Bus control protocol is the key or high rate multiplex data bus. The capacity of real—time responseness of multiplex data bus and properties in high and low load are decided by the protocol.
从系统的功能组成、拓扑结构设计、数据流分析和总线性能分析等方面对基于1553B总线的运载火箭控制系统进行了分析讨论。
This paper mainly discusses the system function and component, topology design, data flow analysis and bus performance analysis of launch vehicle control system based on 1553b bus.
以C8051F 023处理器和CAN总线控制器SJA1000为核心，设计了一种通用的基于CAN总线的数据采集通信系统。
A kind of current data acquisition system based on CAN is designed, its core design is C8051F023 microprocessor and CAN controller SJA1000.
以C8051F 023处理器和CAN总线控制器SJA1000为核心，设计了一种通用的基于CAN总线的数据采集通信系统。
A kind of current data acquisition system based on CAN is designed, its core design is C8051F023 microprocessor and CAN controller SJA1000.
应用推荐