试验结果表明,钛合金封装的线性度及应变灵敏系数优于不锈钢材料封装的传感器。
Experimental results show that the linearity and the strain sensitivity coefficient of packaged by titanium alloy are better than that of the FBG packaged by stainless steel.
采用等强度梁、挠度计、并联电阻箱、电位差计等测定电阻应变计的灵敏系数是一种常用的方法。
Shunting resistance box is a commonly used method in the determination of the sensitivity coefficient of the resistance strain gauge with the equal-strength beam aparatuses.
介绍了采用等强度梁和与测量片并联电阻的方式测定电阻应变片的灵敏系数的方法。
It introduced the methods of measuring the sensitive coefficient of the strain gauge of electrical resistance by means of equal-strength beam and the parallel connection with the measure gauge.
并通过实验标定ASE光源谱特性解调应变灵敏度系数。
The strain sensitivity was demarcated by experiment using spectrum character of ASE demodulation.
本文采用大子样、小子样抽样理论的数理统计方法,评定电阻应变计灵敏系数的精度等级。
The rank of accuracy of electric resistance strain gage factor is evaluated according to the sampling theory of large samples or small samples.
波导效应所引起的应变灵敏度系数都比弹光效应小几个数量级,因此可以忽略。
The strain sensitivity induced by the waveguide effect is several orders of magnitude smaller than that induced by the strain-optic effect, so it can be neglected.
详细研究了两种基体材料上钢管封装的光纤光栅应变传感器的应变灵敏度系数。
And the strain sensitivity coefficients are studied in detail when sticking the mental tube packaged FBG sensors on two materials.
用电阻应变仪对布拉格光栅光纤传感器应变传感特性进行实验对比标定,得出了表征fBG性能的应变传感灵敏系数。
A calibration test has been performed on FBG with strain gauges, and the strain sensing sensitivity coefficient of the properties of FBG was gained.
FBG中心波长漂移的应变灵敏度系数跟布喇格波长的应变灵敏度系数近似相等。
It is also found that the movement of center wavelength of FBG is approximately equal to the movement of resonance wavelength of FBG.
本文还证实了线性超应力模型可以予测实验条件下等应变区的存在,给出了铝和铜的速率灵敏系数K的建议值,讨论了铝的K值的普适性等问题。
The numerical values of the rate-sensitivity parameters K for aluminum and copper are proposed. The essence of general applicability of parameter K is considered for aluminum.
本文还证实了线性超应力模型可以予测实验条件下等应变区的存在,给出了铝和铜的速率灵敏系数K的建议值,讨论了铝的K值的普适性等问题。
The numerical values of the rate-sensitivity parameters K for aluminum and copper are proposed. The essence of general applicability of parameter K is considered for aluminum.
应用推荐