地下水动力作用的研究方法可概括为数学模拟法、数值模拟法和实验模拟法。
The underground hydrodynamic force function research technique may summarize is mathematics analogue method, the value analogue method and the experimental analogy method.
本文叙述了根据补偿法研制的深部温度计及其模拟测量实验。
In this paper, the development of a deep body thermometer based on compensation method and the simulating test with it are described.
实验应力分析模拟结果与有限元数值法吻合较好。
The simulated results from experimental stress analyses agree with calculating data of finite-element numerical method very well.
用蒙特·卡洛法及数值解析法对电荷中和、电流中和过程进行了模拟计算并解释了实验结果。
Simulations of charge neutralization using Monte-Carlo and current neutralization process using numerical analysis have been done, and explanations of experimental results have also been made.
本文以室内环境治理中甲醛清除为例，分别采用数值模拟方法及实验方法，对比研究了活性炭吸附法与光触媒喷涂法的治理效果。
This paper discusses the effects of active carbon adsorption and light accelerant spray in eliminating indoor formaldehyde by use of mathematical simulation and experiments respectively.
通过实验和单因素分析法对所建立的车辆振动模型的正确性及模拟计算程序的有效性进行了验证。
The validity of the vehicle vibration models that are set up and of the vehicle vibration simulation calculation procedure are validated by experiment and the single factor analytic approach.
首先用有限差分光束传播法模拟了器件的光波传播特性，然后进行了初步的实验验证。
The wave propagation characteristics of the splitter are numerically simulated by the finite difference beam propagation method and experimentally investigated.
采用蒙特卡罗法针对本文实验系统进行了流光电晕放电的模拟。
The streamer corona discharge in the experiment system was simulated with Monte Carlo simulation.
将该方法用于某汽车翼子板成形模拟，并与增量法模拟结果及实验结果进行了对比。
This method was applied to simulate an automobile front fender, and its results were compared with the results of experiment and simulation by incremental method.
在实验室内用频谱振幅比较法模拟测试了储集层岩石在高温高压下的弹性波振幅衰减值。
Attenuation of wave amplitude of reservoir rock at simulated high temperature and pressure is measured with spectrum-amplitude comparison mediod in laboratory.
应用加权余量法于动力相似非耦联方程，建立了结构实验的动力模拟势能原理。
Next, dynamic simulated potential energy principle for structural experiments is established by applying weighted residual method to the dynamic similarly non-coupled equations.
目前自然通风主要有三种研究方法：简单的理论分析法、实验法和数值模拟法。
There are three main research methods in natural ventilation: simple theory analyse method, experimental method and numerical simulation method.
利用模拟淋溶实验、质量平衡法、PROFILE模型、MAGIC模型以及两种经验方法对中国十几种主要土壤类型的风化速率进行了研究。
The weathering rates of soils in China were estimated through the mass balance approach, simulated leaching experiments, PROFILE model, MAGIC model, and two empirical methods.
根据电网络模拟场的实验方法，本文提出了一种电路网络模拟场的数值分析方法，即有限网络法。
A numerical method, namely finite network method, is used to analyze a simulation field of electric network based on experimental method of network simulation field.
提出了单蛇型系统的对数平均温差法设计方法，并用数值模拟法和实验法进行了验证。
The result is satisfying through comparing with experimental result, and the method of controlling the floor surface temperature is provided.
为了观察卤钨灯灭菌器灭菌效果，用载体定量法，进行了实验室和模拟现场试验。
In order to observe the germicidal efficacy of halogen tungsten lamp sterilizer, carrier quantitative method was used to carry out laboratory test and simulated field trial.
提出了一种提高净化效率，降低成本的新方法——旋转钟罩法，并在实验室内进行了水模拟实验。
The paper proposed the process of high efficiency of refining and low cost of treating-the Spinning Hood (SH), and the water simulation experiment was carried out in lab.
本文给出的简单模拟实验表明，这一方法是可行的。
The analogous calculation result shows that the above method is indeed applicable.
模拟结果证实了应用显式动力学弹塑性有限元法模拟双金属复合板轧制的可行性，且计算所得轧制力与实验结果吻合较好。
The specific rolling force distribution was obtained by simulation and the calculated results of rolling force are in good agreement with the measured ones.
运用高温云纹法模拟技术，对中心压实锻造法(J·T·S)现行生产工艺进行实验研究，提出了改进意见。
J. T. s forging process is investigated for improving in current production by high temperature moire modelling technique.
方法动物实验采用兔齿髓刺激法和小鼠福尔·马林实验，临床疼痛评定采用视觉模拟评分法。
METHODS Formalin test in mice, tooth pulp stimulation procedure in rabbits and human oral pain were used.
方法应用系统抽样法进行现场查螺，现场和实验室模拟水淹实验观察钉螺存活情况。
Methods Systematic sampling method was used in field Oncomelania investigation, and laboratory and field simulating drowning methods were also performed to observe survival of Oncomelania.
定性物理模拟实验证明了水平V形砧锻造法是控制轴类锻件力学性能的有效工艺手段。
Qualitative physical modeling verifies the fact that the forging method with horizontal V-shaped anvil is an effective process to control the mechanical properties of axial forgings.
分析了摄像机模型，提出了基于两阶段法和捆绑调整的摄像机定标方法，并通过模拟实验和真实实验进行了验证。
This paper analyzes the camera model and proposes calibration methods based on the two stage method and bundle adjustment. Both simulated experiments and real data were used to verify the methods.
用正交实验设计方法对不同窑车衬料、漏入冷空气量以及料垛码法情况进行了数字模拟。
Digital simulation is carried out for different materials of kiln car lining, different quantities of leakage air and different Settings.
模拟计算和对比实验表明：这一方法是合理的、可行的。
Simulation computation and experimental comparison results show that this method is reasonable and feasible.
给出了这一方法的理论分析、数值模拟以及实验研究。
Theoretical analysis, numerical simulation as well as the experimental investigation are presented and discussed.
本文在对钻屑法通过现场实测，实验室模拟和理论研究的基础上，提出用于快速估测松碎岩体应力的基本原理和实测技术。
The principles and measuring method are dealt with for fast estimation of stresses in loosened and broken rock in the paper on the basis of field measurement, lab. Modeling and theoretical analysis.
本文在对钻屑法通过现场实测，实验室模拟和理论研究的基础上，提出用于快速估测松碎岩体应力的基本原理和实测技术。
The principles and measuring method are dealt with for fast estimation of stresses in loosened and broken rock in the paper on the basis of field measurement, lab. Modeling and theoretical analysis.
应用推荐