平衡浓度进一步增大，以固体溶液沉积为主。
However, further increase of the concentration results primarily in solid solution precipitation.
不过要知道，固体中和平衡时溶液中的单糖是以开链型环状半缩醛占多数。
However, it must be understood that cyclic hemiacetals of those open-chain forms prevail I solids and at equilibrium in solutions.
由于该溶液的固体颗粒太大，它们的混合物很难看作为真正的溶液。
The solid particles in this liquid are too large for the mixture to be considered a true solution.
考察了它们的溶液性质和固体表面性质。
The solution properties and solid surface characteristics of block copolymers were examined.
这类聚合物能以各种形式存在，如固体、溶液或吸附于载体表面。
These polymers may be in various forms, such as in solution, on surface, or as solids.
本文建立了裂变产额法用以刻度浸于铀溶液中的固体径迹探测器记录裂变碎片的效率因子。
In the present work fission yield method is developed to calibrate the fission fragment registration efficiency factor of solid state track detector immersed in uranium solution.
溶液里的维生素比固体食物里的维生素受到的影响更大。
Vitamins in solution are more affected than those in solid foods.
核磁共振对于探查溶液中的分子结构，研究固体材料以及分子动态已证明具有极丰富的信息来源。
It has proved to be an exceedingly rich source of information for exploring the structure of molecules in solution, for the investigation of solid materials, and for the study of molecular dynamics.
然后他用吸液管将细菌溶液滴到琼脂糖上，在琼脂糖吸干了溶液中的水分后，印章表面就会形成一层固体细菌。
He pipettes solutions of bacteria onto the agarose, which sucks out the water, leaving a solid layer of bacteria.
吸附净化是利用某些固体表面能够从流体的溶液中有选择地吸附凝聚一定的组分，使溶液中的组分彼此分离的操作过程。
Absorption and purification referre to the process that some solids could selectively agglomerate certain compositions in flowing liquid to achieve the separation of compositions in solution.
本技术的主要缺陷是需要使用溶液，当分析固体时比较耗时和速度慢。
The major limitation of this technique is the need to use solutions, which Can be time-consuming and tedious when solids have to be analyzed.
我们提供的固体和溶液相多肽合成等一系列的修改。
We offer solid and solution phase peptide synthesis including a whole range of modifications.
用70%丙酮溶液洗涤滤饼三次后，用清水洗涤一到两次，得到淡黄色固体。
Wash the cake three times with 70% acetone, one or two times with clean water, faint yellow solid is obtained.
根据钛酸盐的结构特点，通过测定各阶段固体和溶液中钛的含量，可以间接判断钛酸盐的组成。
According to physical truth of titanates' structure, the contents of titanates could be judged indirectly through determining content of titanium in solution and solids at every stages.
采用溶液聚合法合成了高固体分低粘度的羟基丙烯酸树脂(HAR)，详细讨论了引发剂、链转移剂、反应温度、溶剂等对HAR粘度的影响。
Hydroxyl acrylic acid resin (HAR) with high solid and low viscosity was polymerized from an appropriate acrylic acid monomer in solution.
反应使至少一部分非铁金属组合物溶解到与固体氧化铁接触的溶液中。
The reaction dissolves at least a portion of the non-ferrous metal compositions into the solution which is in contact with solid ferric oxide.
以H_2SO_4处理四甲基氯化铵的有机溶液，立即生成沉淀，经过滤、洗涤、干燥后，得到白色结晶状固体——TMAHS。
To treat tetramethyl ammonium chloride with H2SO4 in organic solvent, a precipitate is produced. A white crystallizing solid TMAHS is prepared after filtrating, washing and drying.
溶解后的“生物质溶液”可像液态石油(而不是固体煤)一样，很容易加工，并可实际用于流动反应装置来提高生产效率。
The homogenous biomass solution like petroleum not solid coal is also easily processed in a flow system for practical applications. Organic solvents e. g.
结构型液洗，表面活性剂盐析出溶液，形成层状相液滴，最终形成不透明的液体，它非常稳定且可以悬浮大量固体物。
In a structured liquid detergent, surfactants are salted out of solution to form lamellar-phase droplets, the resulting opaque liquid becomes very stable and can suspend high levels of solids.
该配合物水溶液荧光强度均弱于其固体配合物。
The fluorescence intensity of complex in aqueous solution is weaker than that in solid condition.
固体药物制品（如片剂）经过崩解和解聚，但其吸收则要等进入溶液后才能发生。
Solid drug products (eg, tablets) disintegrate and deaggregate, but absorption can occur only after drugs enter solution.
利用热力学原理分析了固体单质在液体中溶解形成理想溶液的热力学特征。
According to thermodynamic principle, the ability of solving solid - state substance in liquids is discussed in this paper.
本实验采用溶液浇铸法制备了PVA -KOH - H_2O基系列碱性固体聚合物电解质。
Alkaline solid polymer electrolyte films, which composed of PVA-KOH-H2O series, were synthesized by a solution cast technique.
测定它的甲苯溶液和玻璃态固体多晶EPR波谱。
快离子导体(有时又称固体电解质)是指离子电导率接近有时甚至超过盐溶液和电解质溶液的一类固态材料。
Fast ion conductors (sometimes are named solid electrolyte) are a kind of solid material which ion conductivity can near or exceed liquid electrolyte.
利用溶液聚合方法合成了聚醚聚氨酯，并以聚氨酯、高氯酸锂和增塑剂为组分，制备了一系列新型聚合物固体电解质。
A poly (ether urethane) (PU) was synthesized via solution polymerization, which was mixed with LiClO4 and various plasticizers to generate a series of novel solid polymer electrolytes.
利用溶液聚合方法合成了聚醚聚氨酯，并以聚氨酯、高氯酸锂和增塑剂为组分，制备了一系列新型聚合物固体电解质。
A poly (ether urethane) (PU) was synthesized via solution polymerization, which was mixed with LiClO4 and various plasticizers to generate a series of novel solid polymer electrolytes.
应用推荐