文章针对大体积砼产生裂缝的控制，论述了钢筋砼承受变形应力的特点。
According to the control of cracks in large concrete, this paper discusses the characteristics of reinforced concrete under deformation stress.
进而运用构造应力场分析的方法，恢复确定盆地褶皱构造的变形应力场。
And then the stress-field of the fold structures in the basin was ascertained after structural strain analysis.
采用孔径变形应力解除法，测量了某大型磷矿采空区中矿柱结构的应力分布规律；
The stress relief method of hole diameter deformation was used to measure the stress distribution of the pillar structure in the mined area in a big phosphate mine.
通过对板料弯曲变形应力应变分析，提出了几种近似计算最小相对弯曲半径的方法。
A few methods, which approximately calculate minimum relative bending radius, are put forward by analyzing the stress and strain as plate bending deformation in this paper.
分别采用六种载荷边界条件和三种位移边界条件对曲轴应力和变形进行了有限元分析；
The stress and deformation of crankshaft are calculated by finite element method with six load boundary conditions and three displacement boundary conditions.
控制网架的焊接变形与焊接应力是保证网架质量的关键之一。
Controlling on grid welding deformation and welding stress are the key problems for assuring grid quality.
采用实验研究的方法，探讨锚固体界面力学特征、在荷载作用下变形规律以及界面上的应力分布规律。
The stress characteristic of the interface, deformation rule under the action of load and the stress distribution rule were discussed by adopting the experimental research method.
并且分别从隧道围岩稳定性方面、围岩变形方面、应力分布方面、经济和技术方面以及安全方面得出结论。
And reach a conclusion in the tunnel and stability of the surrounding rock, rock deformation, stress distribution, economic and technical aspects of security.
按照剪切滞后理论和应变硬化规律，研究微复合材料的变形和应力状态。
The deformation and stress condition of the micro-composite are studied according to the shear-lag theory and strain-hardening law.
相对于平房、别墅等建筑，多层、高层建筑物由于外表受到阳光照射面积大，所以应力更大，变形也更大。
Relative to the bungalow, villa and other buildings, multilayer, high-rise buildings because appearance in response to sunlight the area is large, so more stress, deformation and more big.
本文在外载相同、艇体结构质量相等的条件下，对三种不同结构形式的艇体进行了应力与变形分析。
In this paper, the stress and deformation of three different structuring forms of ship hull are analyzed under the conditions of the same external load and the equal mass structure.
仅仅应力刚化和大变形是被允许的特殊特征。
The only special features allowed are stress stiffening and large deflections.
脱硫吸收塔结构及荷载形式复杂，常规设计计算方法不能给出其应力和变形分布情况。
The structure and load form of the absorbing tower is complex and regular design and calculation method cannot give its distribution condition of the stress and deformation.
如果在撤去应力后变形仍保留，则称此材料呈现塑性流动。
If, when the stress is removed, the deformation remains, the material is said to exhibit plastic flow.
隧道围岩应力和变形分析是隧道设计的重要内容。
The stress and deformation analysis for surrounding rock of tunnels is an important task in tunnels design.
钢制容器人孔的焊接应力及塌陷变形，直接影响容器的焊接质量和使用寿命。
The notch welding stress and the collapse-deformation of steel container directly affects the welding quality and service life of the container.
从唯象观点分析了循环变形期间相变应力和弹性模量的变化。
The change of transformation stress and the modulus of elasticity during cyclic deformation was analyzed from the continuum mechanical point of view.
采用数值分析方法对冲击压痕法测量残余应力的弹塑性变形过程进行了理论分析。
The indentation method of residue stress measurement depends on strain measurement around an indention caused by an impacting sphere.
比较了优化前后坝体的应力、变形与稳定分析结果。
Stress, deformation and stability analysis of the same cemented-rockfill dam are compared before and after optimization.
本文应用有限元法，对6125Q型柴油机机体在增压和扩缸时的变形和应力进行了计算分析。
Computation and analysis of the cylinder block stress and deformation are conducted on a 6125q diesel engine in supercharged or cylinder diameter enlarged situation by using the finite element method.
在分析动载荷下的应力和变形时，除考虑横向剪切效应外，还须考虑微段的惯性力和阻尼力矩。
In the analysis of the stress and deformation under dynamic loading, the inertia force and damping moment should be considered in addition to the transverse shear effect.
分析在弯曲工况、制动工况、转弯工况和扭转工况下的应力与变形状态，对应力集中位置结构提出改进方案。
Do research on the stress and deformation state in the condition of bending, braking, turning and reversing, and then make a program that improves the structure of the frame.
研究表明在膜结构的找形阶段应适当地加大结构的初始预张力，以减小由于支座变形所造成的预应力损失。
It is found that the prestress should be increased to reduce the loss of prestress with the deformation of the support.
采用变形法计算混凝土应力时，假设应力在各个时段内以突变形式增加，并对这种假设带来的误差进行了分析。
When the deformation method was used for concrete stress calculation, it was assumed that the stress increased suddenly at each stage, and such an assumption led to certain errors.
混凝土实测应变包含弹性应变、徐变应变及混凝土自由变形、温度应变等非应力应变。
The measured strain of concrete includes the elastic strain, creep strain and also the non-stress strain like the concrete free deformation and temperature strain.
弹性体是聚合物的一个种类，它的应力-应变曲线表明其变形是完全弹性的，即很低的应力变化就会产生很大的可回复应变。
Elastomer is a class of polymers whose deformation displayed by strain-stress curve is totally elastic i. e. large recoverable strains produced at low stress levels.
由于巷道掘进破坏了原岩地应力场，使围岩应力重新分布，应力集中区的高应力造成巷道变形破坏。
Because the natural stress field is changed due to tunneling roadway, a stress concentration area appears in rock of surrounding roadway that cause roadway deformation or destruction.
在拉应力作用下，塑性变形集中在铁素体区。
Plastic deformation concentrates at the ferrite area under the tensile stress es.
在拉应力作用下，塑性变形集中在铁素体区。
Plastic deformation concentrates at the ferrite area under the tensile stress es.
应用推荐