用数字信号增强技术可以得到足以精确定位的信号噪声比。
Achievement of a signal to noise ratio adequate for precise registration is accomplished using digital signal enhancement techniques.
为了提高晚电位分析结果的精确度,提高信号噪声比,在HOLTER记录和分析时,采用了“二级筛选”的设计方法。
In order to improve the signal noise ratio and the precision of the analysis, a "two-level sifting" is processed in recording and analyzing VLP by HOLTER.
计算不同图像中肿瘤信噪比(SNR)、肿瘤与肝脏对比噪声比(CNR)及信号强度比(SIR)等数据,并进行统计学分析。
The signal to noise ratio (SNR) of tumors, contrast to noise ratio (CNR) and signal intensity ratio (SIR) of tumors and normal liver were calculated and analyzed.
目前涡街流量计所采用的放大、滤波、整形、计数的处理方式,在从噪声中提取流量信号方面存在较大的局限性,只能采用限制量程比、不测小流量等方法来抑制噪声。
The traditional signal processing methods that amplify, filter, rectify signal and count, which are used in vortex flowmeter now, has shortage in extracting real flow signal from noise.
同样噪声强度情况下,强信号的信噪比增加比弱信号的增加更加迅速。如果同时改变噪声强度,体系的信号频率也维持不变。
It is found that, with the same noise intensity, the increment of the SNR of strong signal is faster than that of the weak signal's, however, the frequencies of both them change hardly.
利用相应的高层次模型,详细分析并仿真了电流源匹配误差和电流源输出阻抗对DAC的非线性误差nl、信号噪声失调比SNDR、无杂波动态范围SFDR的影响。
With corresponding models how the matching errors and output resistance of current source affect the NL, SNDR and SFDR of DAC is analyzed and simulated in detail.
正是这种被称为信噪比的东西,即真实信号与噪声的关系引起了通信工程师的极大的兴趣。从本质上讲,如果信号比噪声电平大得多,则信息的传输是完美的。
It is the relationship of the true signal to the noise signal, known as the signal-to-noise ratio, which is of the most interest to the communication engineer.
在采用信号增强技术降低观测噪声后,利用总体最小二乘方法估计被测信号参数可以得到比传统方法更好的分析结果。
After reducing the noise by the technique of signal enhancement, the more extract approximation results than traditional approach can be achieved with the TLS method.
限幅法是目前应用较为广泛的一类预畸变峰均比抑制算法,但其会引入额外的限幅噪声,从而对数据信号和导引符号造成干扰,恶化传输性能。
Clipping is a popular method to control the PAPR with distortions, but it introduces additional clipping noise, so as to distort the data and pilot symbols and degrade the system performance.
限幅法是目前应用较为广泛的一类预畸变峰均比抑制算法,但其会引入额外的限幅噪声,从而对数据信号和导引符号造成干扰,恶化传输性能。
Clipping is a popular method to control the PAPR with distortions, but it introduces additional clipping noise, so as to distort the data and pilot symbols and degrade the system performance.
应用推荐