触发叶轮随发动机转速而旋转，使得转速传感器或拾波线圈产生与发动机转速和活塞位置相对应的触发电压脉冲。
The trigger wheel rotates with engine RPMs and causes the speed sensor, or pickup oil, to produce triggering voltage pulses that correspond to engine speed and piston position.
因此，安装加工中心的位置，需要电源电压有严格控制。
Therefore, the installation of the machining center location, the need for strict control of power supply voltage.
含有电弧电压在零区梯度信息的指标可以有效地反映故障位置。
An index within the gradient information of the arc voltage on the local region of zero can reflect fault location effectively.
一个良好的安全实践是在测量之前假设所有位置电路上都存在危险电压。
A good safety practice is to expect that hazardous voltage is present in any unknown circuit before measuring.
如果能调节器具适用于不同的额定电压，则该器具所调到的电压值的位置应清晰可辨。
If the appliance can be adjusted for different rated voltages, the voltage to which the appliance is adjusted shall be clearly discernible.
采用含电机电压模型和电机电感模型的观测器，在低速时注入测试信号，可以得到位置和速度信号。
Position and speed are obtained by an observer using a voltage and an inductance motor model together with test signal injection at low speed.
ECM接收到一个带有IVS的油门踏板传来的代表负载命令的可变电压信号，它然后将这个位置命令其转换成一个负荷百分比命令。
The ECM receives its load command from a variable voltage signal through a foot pedal sensor with IVS. It then translates this position command into a load percentage command.
在静电力作用下，悬臂梁粘连的位置和长度会改变，使得执行器的电压位移特性严重依赖加载历史。
The position and length of cantilever stiction change with static driven voltage, so the voltage displacement characteristic depends on load history.
通过调节门电压可以较好地控制静电势孤子的形状及其位置，从而达到对电荷孤子的有效控制。
By changing the gate voltage, one can adjust the profile and position of the static potential soliton and then have an effective control of charge solitons.
试验结果表明：线圈位置，电压对封口效果影响较大。
The experiments show that coil position and voltage have larger influence to the sealing effect.
若管道中出现泄漏，接收换能器的电压立即发生变化，可以根据这种变化发现泄漏，进而按拟合曲线或方程序计算出管道泄漏的位置。
If there is a leak in the pipeline, the voltage of receiving transducer changes immediately. The leak position can be located with curve or formula.
提出了一种基于电压空间矢量调制的随机脉冲位置pwm方法，并着重讨论了采用80c196KC单片机实现的方法，给出了其软件设计。
A novel randomized pulse position PWM scheme based on voltage space vectors is proposed. Its realization by the microcontroller 80c196kc is presented. The software design is discussed.
交流伺服系统检测电路由电流、电压、转速及位置检测电路组成。
Test circuit of AC servo system was composed of current test circuit, voltage test circuit, speed and position test circuit.
最好的检测方式是检测有源滤波器安装点处的电压方式；最好的安装位置是馈线的最末端。
It is held that the best detecting mode is the one detecting the voltage at the installation point of the active filter, and the best installation position is the end of the feeder.
采取测量位置与冲击电压源分隔的测试方法，避开放电时的强烈干扰。
The test way adopted is that the measured place is separated from the sourse of impulse voltage, in order to avoid the strong disturbance by discharge.
在比例方向阀控缸气动位置伺服系统中，置中电压是影响控制精度的重要因素之一。
In pneumatic position servo system with proportional directional control valve and control cylinder, the centre adjust emt voltage is one of the important factors that influence control precision.
最后，探讨了旋转、脉动高频电压信号注入法下定子电阻对转子位置估算影响的问题。
Finally, the stator resistance effect of rotor position estimation in high frequency voltage signal injection is investigated.
实验结果表明：在电枢初始位置不变的情况下，弹丸初速度与电容器组的充电电压几乎成线性关系；
The experimental results showed that muzzle velocity of the projectile was almost linear with the charging voltage of the capacitor bank when the initial position of the armature was fixed.
另一种采用电压控制方式，通过电压的高低进行电机的转速控制，电机的反馈信号通过驱动器反馈到数控系统进行位置控制。
Another kind of the voltage control mode, through the high and low voltage on motor speed control, motor feedback signal through the drive to the numerical control system feedback position control.
本文给出了主机运行中各线圈电压监测结果；在测出HL-1装置变压器的磁化曲线基础上，从几个不同位置测量了装置在放电过程中伏秒数随时间变化过程的初步结果。
Measurements of induced voltage on coils, the magnetization curve of the iron-core transformer, voltage-second characteristics at a few positions during HL-1 operation are summarized in this paper.
最大功率点是最大电池电流和电压的乘积，这个位置的电池输出功率是最大的。
The maximum power point is the product of the maximum cell current and voltage where the power output of the cell is greatest.
得出了接地线位置和其电阻的大小是影响停电线路上感应电压大小的重要因素的结论。
The conclusion is that the position of ground wire and the value of earth connection's ground resistance are two of the most important factors.
他们都要求监控的电流、电压(流量观测)，然后运用知识的磁特性、转子位置所决定的。
They all require monitoring of the phase current and applied voltage (flux observation), then by using knowledge of the magnetic characteristics, the rotor position is determined.
注：关于其他电压与频率、绕组保护以及接线盒位置的编码，请见第20页订货号。
Note: About the code of other voltage and frequency, winding protection and connection box position, please refer to Orde No. in page 20.
给出反偏电压、光谱响应、暗电流、极间电容、极间阻抗、位置分辨率和位置线性特性等性能的测试结果。
Several test results, such as reverse voltage, photo sensitivity, dark current, terminal capacitance, terminal impedance, position distinguishability, position Iinearity, were reported in the paper.
有时即使把旋纽置于标准位置，其一元化焊接电压值可能也不太合适。
Sometimes even if sets at the knob to the standard position, its unification welding voltage value not too is possibly appropriate.
分布式电源(DG)对配电网网损和电压的影响主要与其位置和容量以及负荷分布有关。
The power loss and voltage distribution of distribution network are closely related to the location and size of DG (Distributed Generation) and the load distribution.
最后，利用DSP相关软件，对转子初始位置估算方法进行模拟仿真，验证了高频电压信号注入法理论的正确性。
Finally, the paper simulated to the rotor initial point estimate method using DSP related tool and confirmed the accuracy of high frequency voltage signal method.
计算并对比两个屏蔽环多个位置组合的电压分布，选取最优的位置组合。
The voltage distribution of several position combinations of the two grading rings is calculated and compared, and the best position combination is selected.
计算并对比两个屏蔽环多个位置组合的电压分布，选取最优的位置组合。
The voltage distribution of several position combinations of the two grading rings is calculated and compared, and the best position combination is selected.
应用推荐