床垫应包括与聚酯-棉花图案(或印刷)织物。
Mattresses should be covered with polyester - cotton patterned (or printed) fabrics.
聚乳酸纤维与聚酯纤维都可由熔体纺丝法制得，是合成纤维中性能较为相近的两类纤维。
Polylactic acid fiber and polyester fiber are two kinds of synthetic fibers with similar properties and both can be made by using melt-spinning method.
市售的环氧树脂因用途不同，其配方也不同(粘接或层压等)，但不用区别层压树脂、面漆树酯与聚酯。
Epoxies are sold in various formulations for different USES (bonding or laminating, etc.), but the distinction between laminating resin and top coat resin as with polyesters does not apply.
概述了聚碳酸酯水桶面临的市场考验与聚酯水桶的市场机遇以及5加仑水桶专用料bg803瓶级聚酯切片的特点。
In this paper, the market challenges of PC water bottles and the opportunities of PET are presented, and thereby BG803 PET chips are introduced for 5-gallon water bottles.
分别采用MDI- 50、TDI- 65和TDI - 80与聚酯多元醇反应制得低硬度耐溶剂聚氨酯弹性体制品。
Polyurethane elastomers with low hardness and solvent resistance were prepared by reacting MDI-50, TDI-65 and TDI - 80 with polyester polyol respectively.
Selectamark公司的技术也是用微粒，虽然用聚酯或者镍基合金代替明胶，使用何种微粒与粘着剂的类型有关。
Selectamark's technology also USES microdots, though instead of celluloid it employs polyester or a nickel-based alloy, depending on the type of adhesive involved.
耐克表示，与先前的球衣相比，这种球衣更能使球员保持干爽、凉快，而且在能源生产消费方面比普通的聚酯纤维要少30%。
Nike says they will keep players drier and cooler than previous kit while reducing energy consumption in manufacture by 30 percent compared to normal polyester.
不饱和聚酯是一种良好的NBR增塑剂，与nbr的相容性良好，可部分替代液体酯类增塑剂。
The unsaturated polyester was a good plasticizer for NBR and compatible to NBR, and it could partly replace liquid ester plasticizer.
许多这些聚酯与淀粉混合应用的成本竞争力的生物降解塑料的聚合物。
Many of these polyesters are blended with starch based polymers for cost competitive biodegradable plastics applications.
探讨了浸胶液在聚酯帘子线与橡胶之间的作用机理以及增粘作用。
The interaction mechanisms and function of adhesive between polyester cord and rubber were discussed.
研究了两种聚酯工程纤维改性道路沥青的微观结构与性能。
The microstructure and properties of the pavement asphalt reinforced by polyester engineering fiber were investigated.
介绍了聚酯反应器热态试验装置的设计、制造与试验运行过程。
The design, manufacture, and test run of the hot test units for polyester reactors were presented.
着色聚酯纤维在进一步处理加工中的低聚物问题与纤维本身一样古老，至今仍未解决。
The still not solved oligomer problem during further processing of dyed PET fibers is as old as the fiber itself.
本文讨论了常温固化不饱和聚酯树脂浇涛体的拉伸强度、拉伸模量、断裂延伸率与固化度之间的关系。
In this paper, the relation of tensile strength, tensile modulus and breaking elongation of unsaturated polyester casting matrix cured at room temperature to curing degree was discussed.
试验结果表明：纳米炭黑分散体系对经过改性剂ep处理的聚酯纤维具有较高的上染性，且与分散染料有较好的染色相容性。
The results showed that nano carbon black dispersoid had high dye-uptake on polyester fiber modified by reagent EP in advance and good compatibility with disperse dye.
这种纤维可与棉、聚酯、丙烯酸酯等混纺织成抗菌保健纺织品。
It can be mixed weaving fabrics with cotton, polyester, acrylate and so on.
讨论了耐雨蚀面漆中聚酯树脂、多元醇和颜料对其性能的影响，施工工艺对耐雨蚀涂层与底涂层之间配套性能的影响。
The influence of polyester resin, polyols, and pigments on performance of topcoat and influence of application technology on compatibility between primer and topcoat are discussed.
根据与GDP的相关性，预测2003 - 2010年我国聚酯产品需求的年均增长速度仍将保持在10%以上。
According to the correlation with GDP, the average annual growth of polyester product demand was predicted to be above 10% in China during 2003 -2010.
通过在聚酯胶粘剂中使用改性有机硅偶联剂，可以改善着色铝箔与PVC的粘结性能。
The adhesion strength between the dyes covered aluminum foils and PVC can be enhanced significantly by polyester adhesive added modified organic silicon coupling agent.
亲水特性传授给疏水基合成聚酯纤维等，通过孵化与醋中的衬底存在细菌培养基。
Hydrophilic characteristics are imparted to hydrophobic synthetic substrates, such as polyester fibers, by incubating a culture medium with Acetobacter bacterium in the presence of the substrate.
研究了热固性不饱和聚酯常温固化制造新型塑料电热板的配方、成型工艺路线与成型条件。
A new pattern plastic galvanothermy board can be made by solidifying heat set unsaturated polyester resin at normal temperature.
在聚酯中引入刚性链段（即将脂肪族聚酯与芳香族、液晶基元共聚合）可改善聚酯的加工性能；
The processability of polyesters could be improved significantly after incorporating stiff chain segment through copolymerization of aliphatic polyester with aromatic liquid crystal element.
改性聚酯对酸性染料的上染率有一定的提高，但与PA6的上染率相比仍有差距。
The rate of dye-uptake of modified PET is improved, but is still far lower than PA6.
与环氧、环氧沥青、沥青系、乙烯等体系的涂料配套使用。但不能与油性、醇酸、聚酯类油漆配套使用。
It can be compatible with epoxy, epoxy - tar, vinyl paint systems. but it is incompatible with oil base, alkyd, polyester coating systems.
本文研究了制膜条件对PVDF/聚酯无纺布复合微孔膜结构与性能的影响。
The influences of preparing conditions on the structure and performances of composite membranes by casting PVDF solutions on PET non-woven fabrics were investigated.
利用新型改性聚酯T的常压可染性，将T与PP制成PP/T 共混纤维，以改善丙纶的染色性能。
Taking advantages of modified polyester T, who can be dyed at atmospheric pressure, it was blended with PP to improve its dyeability.
乙烯酯树脂既兼有环氧和聚氨酯树脂的优良物化性能，又具有与不饱和聚酯树脂一样简便的施工工艺性。
Vinyl ester resin has good physical and chemical properties of both epoxy and polyurethane. And it also has a technological property of easy processing as what unsaturated polyester does.
文章介绍利用废弃聚酯生产棉型涤纶短纤维的可行性，生产设备工艺流程，工艺参数选择与效果分析。
The equipment, producing process, technical parameters and the result analysis were introduced. It showed that the preparation of cotton type polyester staple was feasible by using waste PET.
综述了新型功能液晶聚酯材料的大分子链结构、液晶相变温度与应用前景。
The macromolecular structures, liquid crystalline phase transition temperatures and practical applicability of new kind of functional liquid crystalline polyesters were reviewed.
综述了新型功能液晶聚酯材料的大分子链结构、液晶相变温度与应用前景。
The macromolecular structures, liquid crystalline phase transition temperatures and practical applicability of new kind of functional liquid crystalline polyesters were reviewed.
应用推荐