Don't let your working pressure interfere with us.
不要让你的工作压力影响我们。
The rated working pressure of the separator is 10 MPa.
分离器的额定工作压力是10兆帕。
Third is the factor of working pressure and intensity.
三是工作压力和强度因素。
Last but not least, working pressure is another reason.
最后，工作压力是另外一个原因。
How did you manage to get away from the working pressure?
问：你有什么化解工作压力的妙招吗？
Working pressure is common in modern society as a phenomenon.
工作压力是现代社会中普遍存在的一种现象。
The working pressure is stated on the water heater's data plate .
热水器的工作压力标注在热水器的参数板上。
Double mechanical seal, No leakage, Can bear higher working pressure.
采用双机械密封，安全无泄漏，可承受更高的工作压力。
Working pressure and heated competition are the major factors behind the phenomenon.
工作压力和激烈的竞争是导致这一现象的主要因素。
Please offer working pressure and working temperature of the ordered equipment.
订货请说明所订设备的工作压力，工作温度。
The maximum working pressure is an important parameter for safe working of flange.
法兰压板的最大工作压力是其安全正常工作的重要技术参数。
The working pressure of safety valve should be set as per the applicable Standards.
安全阀的工作压力须按规定整定。
By this way the burst cement pipe could be repaired under water flow with working pressure.
叙述了带水带压使用导气导流法，辅以快速堵漏剂进行维修的新方法。
The top steam discharge valve discharge distance could regulate to maintain the working pressure.
顶部排汽阀的开度应调控，以保持连排内的工作压力。
They are all designed for working pressure of 200 LBS with NPT threads, not for air compressor service.
他们的设计能够承受200磅的工作压力，带NPT螺纹，而不是空气压缩机的服务。
The flange maximum allowable working pressure should not be smaller than the computed pressure of this flange in operation.
法兰最大允许工作压力应不小于该法兰在使用条件下的计算压力。
The dynamic working pressure in this catalog refers to the allowable maximum pressure in condition of continuously working.
资料中有关胶管的动态工作压力是指胶管连续工作时允许的最高压力。
These pages also show torque for differential pressures at full and half maximum cold working pressure for carbon steel valves.
这些内容也包括碳钢阀门在最大或一半的冷工作压力下压差的扭矩。
The influence regularity of working pressure and temperature on the lubrication parameters can be acquired in the mathematic model.
在数学模型中考虑了配流副高、低压对油膜形成和变化产生的影响。
The influence of the working pressure on the heat and mass transfer was analyzed by this model, and the detailed process was investigated.
应用该数学模型分析了压力变化对加填料饱和器传热传质的影响，同时讨论了沿加填料饱和器高度方向的传热传质过程。
The technical index of the rolling air bag, such as the diameter, internal working pressure and loading capacity are calculated and analysed.
对气囊技术指标所涉及的直径、工作内压和承载能力等进行了计算分析。
Then the determined accelerate stress is the stresses that affect the cylinder life as fluid temperature, working pressure and moving frequency.
然后确定了加速应力为影响气缸寿命的工作应力：流体温度、使用压力及气缸动作频率；
At last, according to its effect of clinic application, some major parameters as working pressure, cooling rates, rewarming rates are discussed.
最后根据临床应用对装置的工作压力、冷冻速率、复温速率等重要参数进行讨论。
The results show that the contribution of working pressure to stress of the Venturi separator is far greater than that of wind loads and seismic loads.
计算结果表明，分离器内部工作压力对分离器应力的贡献远大于风载荷和地震载荷。
Water supply pressure should not exceed 80% of the working pressure of the water heater. The working pressure is stated on the water heater's data plate.
供水压力不能超过热水器工作压力的80%。热水器的工作压力标注在热水器的参数板上。
Therefore, optional air compressor is the step: make sure the working pressure, then set corresponding volume flow, and finally the power supply capacity.
因此，选配空压机的步骤是：先确定工作压力，再定相应容积流量，最后是供电容量。
This article introduces JDC model, which is widely applied in the working pressure theory, to elaborate relationship between the postgraduates and teachers.
引进工作压力理论中被最广泛运用的JDC模型，试从这个维度阐述导师与硕士研究生之间的关系。
As a result, lower working pressure and higher RF power is helpful to prepare good a-C film, meanwhile, laser repetition has evident influence on films growth.
结果表明：在较低气压和较高的射频功率下制备的a - C膜质量较好，同时，激光重复频率对膜生长也有显著影响。
On the basis of analysing the experiments of atomized jet vacuum pump. it puts forward an empirical optimized working pressure formular for a definite area ratio in.
在分析液气射流泵的试验报告基础上，给出每一确定面积比的最优工作压力的经验表达式。
On the basis of analysing the experiments of atomized jet vacuum pump. it puts forward an empirical optimized working pressure formular for a definite area ratio in.
在分析液气射流泵的试验报告基础上，给出每一确定面积比的最优工作压力的经验表达式。
应用推荐