电压或当前的控制。
All versions feature analog voltage or current outputs.
所有版本的功能模拟电压或电流输出。
The term can be used for any voltage or current in a circuit.
该术语可用于任何回路的电压或电流。
The quantities are usually a voltage or current in switching power supply testing.
这个电量通常是指开关电源测试中的电压或电流。
Johnson noise imposes a theoretical limit to achievable voltage or current resolution.
约翰逊噪声给出了可以达到的电压或电流测量分辨率的理论极限值。
An electrical signal is a voltage or current which conveys information, usually it means a voltage.
电子信号是一个携带信息的电压或电流，通常是指电压。
PSS technique can be used for the output voltage or current regulation by employing an auxiliary winding.
初级侧感测方法可藉由辅助线圈來达到输出电压或电流的控制。
Various errors of an operational amplifier can be substituted by equivalent error voltage or current sources.
运算放大器的各种误差都可以用等值的电压源或电流源来代替。
Pulse: a regular, significant abrupt change of short duration in the level of an electric voltage or current.
脉动：电压或电流作有规则的，短暂的和明显的突然变动。
If another voltage or current source is present, you could replace S1 with an open-collector switch that sinks current only.
如果另外有个电压或电流源存在，用仅有减小电流作用的集电极开路开关代替s1。
For example, a fully automatic synchronous condenser is started and stopped by an initiating device responsive to voltage or current or both.
例如，全自动调相机由响应于电压或电流，或两者组合的启动设备来启动或停止。
An overloaded voltage or current would cause a electrical sparkle in the thinner zone, which broke the films components and made them lose effectiveness.
加载电压或电流过大易导致薄膜厚度较薄处产生电火花，使元件熔断失效。
Here the discrete on or OFF state of the modulation itself can be used to control the switches thereby controlling the voltage or current across the load.
在这里，离散的开或关的状态调制本身可以被用来控制开关，从而控制得或电流负载。
Bandgap reference source is an important unit in integrated circuits, which supplied reference voltage or current independent of temperature and supply voltage.
带隙基准源是集成电路中的重要单元，输出不随温度、电源电压变化的基准电压或电流。
It is available for specifying the harmonic emission (voltage or current) limits from distorting loads concerned with the capacity, operation and harmonic nature.
该方法适合对容量、负荷工作特性和谐波发射特性不同的负荷谐波(电压和电流)限值的确定。
Conversely, if the current through an ideal current source is determined by some other voltage or current in a circuit, it is called a dependent or controlled current source.
相反，如果其他一些电压或电路中的电流通过一个理想电流源的电流决定，它被称为从属或控制的电流源。
For signal conditioning hardware to condition a signal, or for the DAQ device to measure it directly, you must first convert it to an electrical signal such as voltage or current.
对于信号调节、信号硬件调理或是DAQ设备直接测量，你首先必须将其换算成电信号，如电压或电流。
This paper presents a new method to obtain the sum of random harmonic vectors (voltage or current) whose phases have different probability distribution functions in a power system.
提出了一种处理电力系统中具有不同相角分布时随机谐波矢量(电压和电流)的求和问题的新方法。
Be careful when connecting a voltage or current source to your DAQ device. Make sure the signal source will not exceed the maximum voltage or current that the DAQ device can handle.
在DAQ设备与电压源或电流源连接时必须细心，以确保信号源不超过设备所允许的电压或电流最高值。
Guarding implies the use of an added low impedance conductor, maintained at the same potential as the high impedance circuit, which will intercept any interfering voltage or current.
而保护意味着使用保持在与高阻抗电路相同电位的附加的低阻抗导体来阻止可能的干扰电压或电流。
By comparing the heating effect of an unknown AC signal to that from a known DC reference, metrologists can determine the RMS AC quantity (voltage or current) in terms of the DC quantity.
为了对比一个已知直流参考的未知交流信号热效应，计量人员可以确定在一段时间内直流的交流有效值(电压或电流)。
Meanwhile, the clamp circuit will limit the output voltage or current at a fixed value when they are abnormal that caused by a DUT short circuit or other fault in order to protect the device.
当被测dut发生短路或其他异常导致电流或电压过高时，钳位电路会将输出电压或电流限制在一个固定值上，以保护器件不被损坏。
The pressure transmitters of type 681 with piezoresistive measuring elements have compensated, adjusted and amplified sensor signals which are available as standard voltage or current outputs.
同类型的681压阻测量元件的压力变送器的补偿，调整和放大传感器信号，即是标准电压或电流输出可用。
The pressure transmitters of type 680 with piezoresistive measuring elements have compensated, adjusted and amplified sensor signals which are available as standard voltage or current outputs.
同类型的680压阻测量元件的压力变送器的补偿，调整和放大传感器信号，即是标准电压或电流输出可用。
A novel fundamental frequency and initial phase detection method based on DSP is proposed, which can be used to get synchronous fundamental frequency voltage or current signals of power system.
提出了一种基于数字信号处理器的基波相位和频率校正检测方法，可用于电力系统中电压或电流基波分量同步信号的获取。
An algorithm produces a specific sequence of pulses of varying width such that the voltage or current delivered to the load from the system plant closely resembles a critical damped step response.
一种算法产生具体的脉冲序列，该脉冲序列改变宽度使得从系统设备传输给负载的电压或电流非常类似于临界阻尼阶跃响应。
This can lead to unwanted fluctuations in current or voltage.
这会导致电流或电压的无用波动。
Devices called synchrophasors can sample voltage and current 30 times a second or faster-giving utilities and system operators a far more accurate view of the health of the grid.
而被称为“同步向量”的设备能以一秒30次或更快的速度采样电压和电流——向电力公司和系统操作员提供有关电网健康状况的信息更为精确。
Devices called synchrophasors can sample voltage and current 30 times a second or faster-giving utilities and system operators a far more accurate view of the health of the grid.
而被称为“同步向量”的设备能以一秒30次或更快的速度采样电压和电流——向电力公司和系统操作员提供有关电网健康状况的信息更为精确。
应用推荐