• All we need to do is measure the voltage across this resistor.

    我们只需要测量一下该电阻两端的电压。

    youdao

  • As the voltage across a resistance is changed, the current changes.

    电阻的电压变了,电流也变了。

    youdao

  • It is necessary to find the current through and voltage across the capacitor.

    必须求出该电容上的电流和电压。

    youdao

  • Therefore, the subsequent programmed output voltage will be the actual voltage across the load.

    所以,随后编程的输出电压即为负载端的实际电压。

    youdao

  • The waveform of the reverse voltage across the bridge arms and the harmonic contents are analysed.

    本文分析了整流器在不同换流重叠角时的桥臂反压波形及谐波分量。

    youdao

  • The electrical switches conduct heavy current and have nonzero voltage across the switch in the on-state.

    这个电子开关能导通大电流,并且在通态时有非零的压降。

    youdao

  • As shown in Figure 2-2, the input bias current (IBIAS) develops an error voltage across the source resistance (RS).

    如图2 - 2所示,输入偏置电流(IBIAS)在源电阻(RS)上产生了误差电压。

    youdao

  • When a switch is closed, the voltage across the switch is identically equal zero regardless of the current through the switch.

    当它被合上时,不管流经开关元件的电流值是多少,电压恒为零。

    youdao

  • A method of identifying the end of soft starting process based on the voltage across the non-conducting thyristor is introduced.

    介绍了一种利用晶闸管两端电压信号来确定软起动结束点的方法。

    youdao

  • The harmonic balance analysis is applied to calculate the frequency spectrum of the AIA and the voltage across the impedance model.

    谐波平衡法被用于得到AIA的谐波特性和阻抗模型的端口电压。

    youdao

  • A current detecting circuit 6 is connected to both ends of the resistor 2 and detects a current from a voltage across the resistor 2.

    电流检测电路6连接到电阻2的两端并且从电阻2两端电压检测电流。

    youdao

  • The voltage across RL1 is the picoammeter voltage burden, normally less than one millivolt, so the resulting current will be quite small.

    RL1上的电压为皮安计的输入端压降,通常小于1mV,所以产生的电流是相当小的。

    youdao

  • The meter then measures the voltage across the resistance through the same set of test leads and computes the resistance value accordingly.

    然后仪表通过同一套测试引线来测量电阻两端的电压,并计算出相应的电阻数值。

    youdao

  • A power supply system is operable to provide a voltage across at the active and the counter electrode assemblies of a transdermal delivery device.

    供电系统可操作为提供透皮输送装置的有源电极组件和对电极组件之间的电压。

    youdao

  • Also, computer simulation is conducted to work out the contrast curve of scanning spots and the offset voltage across the modulation unit of the optical phased array.

    最后通过计算机模拟计算,得出扫描点的对比度曲线以及相控阵调制单元上所加的补偿电压。

    youdao

  • Thus, one way to minimize the effects of device heating is to use the lowest current possible while still maintaining the desired voltage across the device being tested.

    所以将器件的加热效应降到最低的一种方法是使用尽可能低的电流,而在被测器件上仍然保持希望的电压。

    youdao

  • In the event of an overload when ILOAD exceeds its maximum permissible value, the increase in voltage across R6 results in sufficient base-emitter voltage to turn on Q2.

    当iload超过最大允许值时发生过载情况,R6上的电压增大导致基极-发射极电压足够大到导通Q2。

    youdao

  • It is important to ensure that the total cell voltage across the string does not exceed the common mode voltage rating and the maximum voltage level of the switch module.

    确保电池串两端的电压不超过开关模块的共模电压额定值和最大电压是非常重要的。

    youdao

  • When in the external feedback mode, the electrometer will display the voltage across the feedback element. The unknown charge can be calculated from the following formula.

    在外部反馈模式下,静电计显示反馈元件上的电压。未知电荷可以由下式计算。

    youdao

  • The limiting resistance in SFCL and the fault detection time impact on peak value of fault current, line voltage of feeders without fault and voltage across SFCL are analysed.

    给出了超导限流器的数学模型,着重分析了超导限流器限流电阻和故障检测时间对短路电流峰值、非故障线电压、超导限流器上的电压的影响。

    youdao

  • Because of the difference of DC voltage across it, it maintains its charge which in turn maintains its dielectric layer. And this is the key that answers the long burn-in question.

    由于有电压穿过电容,电容能维持其充电特性,从而维持其电介质层。这就是回答煲机问题的关键所在。

    youdao

  • Because of the difference of DC voltage across it, it maintains its charge which in turn maintains its dielectric layer. And this is the key that answers the long burn-in question.

    由于有电压穿过电容,电容能维持其充电特性,从而维持其电介质层。这就是回答煲机问题的关键所在。

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定