The total heat exchanger is a new type of energy saving equipment for air-conditioning units.
本文介绍新型空调节能设备——全热交换器的结构、工作原理、热效率及其应用。
The solution now used in China is to allocate a proportion of the total heat based on the floor area of each house unit. This proportion is called area-shared percentage.
目前我国采取的解决办法是将系统总供热量中的一部分按各户建筑面积进行分摊 ,这部分热量占系统总供热量的百分数称为面积分摊百分数。
The main feature of the system is to use total heat of exhaust air to process supplying air.
其系统的主要特点是充分利用排风全热来处理空调送风。
His total heat output was measured and compared with the calorific content of the food he ate.
量出他的总热量输出,并与他吃进去的食物的含热量作了比较。
Low air flow rate will increase the rise of temperature, but total heat transfer will be reduced.
降低空气速度可以提高空气的温升幅度,但是总的吸热量将会降低。
In total heat of radiator, convection heat radiation accounts for about 61%, and radiant heat is about 39%.
实验散热器总放热量中,热对流放热量约占61%,辐射放热量约占39%。
However, under high temperature combustion conditions, gas radiation is very important in the total heat transfer.
然而在高温燃烧环境下,气体辐射在总的热量传递中占有不可忽略的比重。
In this paper, thermal performance test-bed of total heat exchanger is improved with the requirements of the frosting experiment.
本文在全热交换器热工性能实验台上进行了改进和完善,使之符合结霜实验的要求。
The membrane-based total heat exchanger is a novel heat recovery unit due to its simultaneous recovery of sensible heat and moisture.
膜全热交换器由于可以同时回收空调排风中的潜热和显热而受到重视。
The total heat-transfer area is taken, as an objective function to analyse the optimal performance of an irreversible Carnot refrigerator.
本文以总传热面积为目标函数,对不可逆卡诺制冷机进行优化分析。
The results showed that the total heat production(THP)and sensible heat production(SHP)have significant correlation with pullet′s day old;
结果表明,鸡的总产热量(THP)、显热量(SHP)与鸡日龄间存在着显著的相关性;
Calculate the total length of electric heating cables needed according to total heat loss of pipes or tanks and the chosen power per meter.
根据管道或容器罐体总散热量和选定的电热带米功率,计算所需电热带总长度。
For the coastal area where the air humidity is heavy, it is better to adopt total heat reclaiming device than sensible heat reclaiming device.
对空气湿度大的沿海地区,采用全热回收设备比只是显热回收效果要明显。
In the case of constant pipe diameter, lengthening the length of vacuum tube is an effective way to increase the total heat of solar water heater!
在管径恒定的情况下,加长真空管的长度是增加太阳能热水器总得热量的有效途径和方向!
It can be used not only for the on-line measurement of total heat flow but also for the simultaneous measurements of true temperature and emissivity.
用它不仅可以在线测量表面的全热流,而且还可同时测出被测表面的真实温度和发射率。
Heat efficiency during hydrate thermal recovery, i. e., hydrate decomposition heat to total heat input ratio, has also been analyzed based on the model.
在此基础上,分析了水合物热力开采过程中热量的有效利用率,即用于水合物分解的热量与输入的总热量的比值。
The heat flux to slab surface of a walking beam reheating furnace along length of the furnace is computed, and total heat exchange factor is also calculated.
以某轧钢厂的一台步进梁式加热炉为例,计算了钢坯表面热流沿炉长方向的分布,并反算求解总括热吸收率。
When the plate total heat exchanger run in a day, it can be divided into three periods: frost occurring period, frost stable period and frost melting period.
冬季板式全热交换器在全天中的运行可分为结霜发生期、结霜稳定期和融霜期三个时期。
With an example, analyses the effect of total heat exchanger area on system performance and the optimizing results under different conditions and discusses the impact …
结合实际算例,分析了换热器总传热面积对系统特性的影响以及不同设计工况下的优化结果,同时讨论了换热器种类对最小总传热面积的影响。
The total heat loss per unit time decreases gradually as the injection pressure, injection flow rate and injection time increase, but the decrease extent reduces gradually.
随着注入压力、注入流量以及注入时长的增加单位时间的总热损逐渐减小,但是降低幅度变缓。
The model was made up of inner steam temperature drop equations, the steam pipe laying different ways of unit length heat loss equations, total heat resistance calculation equations.
模型由管内蒸汽温降方程、不同敷设方式蒸汽管道的单位长度散热损失方程、总传热热阻计算方程组成。
More place in particular is given to the introduction of the precise equations for total heat content in smoke , replacing the former diagram so as to be suitable for using computers .
侧重介绍烟气热焓的精确计算公式以代替原有的图表,便于应用电子计算机。
Achieve continuous balance between produced and consumed steam. This master pressure control approach controls total heat input into boilers, as well as total steam flow into each header.
实现产出和消耗蒸汽的连续平衡。主压力控制方法控制着输入锅炉的总热量以及流入每个锅炉联管箱的蒸汽量。
Computational accuracy of heating process mathematical model based on total heat exchange factor (THEF) method was found easy to decrease due to complex heat exchange process in a furnace.
复杂的炉内热交换过程容易导致根据总括热吸收率法建立的加热过程数学模型的计算精度降低。
Results showed that the net heat loss on the downstream side of the jet nozzle could reach 20 ~ 30% of total heat flux. Therefore it can not be neglected in calculating the wall temperature.
结果表明,喷管下游端的壁面辐射损失高达壁面总热流的20 ~ 30%,在壁温计算时不容忽略。
The results showed that the total heat transfer coefficient of heat exchanger with hot water arranged in shell-side was relatively higher by 33% than that with hot water arranged in tube-side.
结果表明:在相同的管、壳程流速下热流体在壳程时换热器总传热系数比热流体在管程时相对高出约33%。
The results showed that the total heat transfer coefficient of heat exchanger with hot water arranged in shell-side was relatively higher by 33% than that with hot water arranged in tube-side.
结果表明:在相同的管、壳程流速下热流体在壳程时换热器总传热系数比热流体在管程时相对高出约33%。
应用推荐