The worst part of the setup is the poor instruction manual.
安装过程中最糟糕的部分就是差劲的操作手册。
This completes the setup of queues.
这就完成了队列的设置。
Students themselves seem to understand the weaknesses inherent in the setup.
学生们自己似乎也理解这种安排所固有的弱点。
Now, look at the setup required for JAXB.
现在，来看一下JAXB所需的设置。
Figure 1 shows the setup of the example.
图1显示了该示例的设置。
Write the setup and teardown methods.
编写setup和teardown方法。
Verify the setup using showmount command.
使用showmount命令验证安装。
Figure 1 below shows the setup of the example.
下面的图1显示了示例的设置。
I'll start by introducing the setup strategy.
首先介绍设置策略。
Listing 2 shows the code for the setup and call.
清单2显示了设置和调用的代码。
For this scenario, the setup would be as follows.
对于该场景，其设置如下。
Select the setup type as Complete and click Next.
选择安装类型为Complete并单击Next。
Then synchronize the setup with the other node, HADB2.
然后，与其他节点HADB2的设置同步。
Configure and use IBM NAS client to test the setup.
配置和使用IBMNAS客户机测试设置。
Figure 4 shows the setup of the disk (for partitioning).
图4显示了磁盘设置(分区)。
This completes the setup of your development environment.
这就完成了开发环境的设置。
After the setup is complete, there are five ways to create a test.
在完成这些设置之后，有五种创建测试的方法。
Both of these steps are shown in Figure 5 within the setup function.
这两个步骤在图5的setup函数内有所显示。
Here is the setup information needed to run the sample code in JUnit.
这里是需要在Junit中运行样本代码的设置信息。
Figure 1 provides a schematic overview of the setup for this installation.
图1给出了这种安装设置的概述图。
The list of endpoint listeners comes from the setup steps we did in Part 2.
端点侦听器列表来自在 第 2部分中执行的安装步骤。
So, why don't you add this functionality in the setup/teardown routines?
那么，为什么不在设置/清除例程中添加这种功能呢？
Once the setup is complete, users of the data will see updates automatically!
完成这个设置后，数据的用户就可以自动看到更新！
Choose exit to exit the setup section and launch minicom with these Settings.
选择Exit退出设置过程并用这些设置启动minicom。
Once the setup has completed, choose Finish to exit the installation panel.
完成设置后，选择Finish退出安装面板。
You're almost done with the setup work; you still need to perform one final step.
您几乎已经完成了设置工作；但仍需要执行最后一步。
For multiple fixtures, the setup and tear-down occurs in the order you declare them.
对于多个装备，它们的设置和清除按照声明的次序执行。
The following example shows the setup and how to achieve the objective of this article.
下面的示例说明这种设置以及实现本文目标的方法。
应用推荐