Hydrostatic test, Pneumatic test, test pressure, test temperature, Vacuum vessel, Combination units.
液压试验，气压试验，试验压力，试验温度，真空容器，组合容器。
The corrosive solution and test temperature have no apparent effects on the grooving corrosion sensitivity coefficient.
腐蚀介质和介质温度对沟槽腐蚀敏感性系数无显著的影响。
With the elevation of test temperature and pressure, the rocks and minerals were deformed from brittleness to ductility.
随试验温度、压力条件的升高，岩石、矿物从脆性变形向塑性变形演变。
The value of stress under air pressure test shall not exceed 80% of the yield point of the material in test temperature;
气体压力试验时的应力值，不得超过试验温度下材料屈服点的80%。
The value of stress under hydraulic pressure test shall not exceed 90% of the yield point of the material in test temperature;
液体压力试验时的应力值，不得超过试验温度下材料屈服点的90%；
Its accuracy is questionable, and the results vary with the specific procedure used, and with test temperature.
它的准确性值得怀疑，结果也随所使用的特定的程序变化，而且随试验温度变化。
During the air pressure test, the test temperature shall be higher than the brittle transition temperature of the metal material.
气体压力的试验时，试验温度必须高于金属材料的脆性转变温度。
The flow pattern and apparent viscosity of the crude oils vary depending upon their density, water content, and test temperature.
叙述原油流型及表现粘度随原油比重、含水和温度的变化。
Test results show that the yield characteristics of DD3 single crystal depend on test temperature, strain rate, and orientation of samples.
试验发现，单晶DD3的屈服特性随温度、应变率、晶向而变化。
The effect of loading rate, test temperature and pre-plastic deformation on hydrogen induced apparent yield stress reduction have been investigated.
研究了变形速度，试验温度以及预先塑性变形程度对氢致表观屈服强度下降的影响。
The influence of temperature on impact toughness increases with increase of impulse, and is quite smaller than the influence of impulse in the range of test temperature.
温度对冲击韧度的影响随冲量的增加而加大。在试验温度范围内温度的影响远远小于冲量对冲击韧度的影响。
Shortterm shear behaviors depend on loading rate and test temperature while the shapes of the shear creep curve and the creep lives depend on test temperature and stress.
瞬时剪切行为存在加载速率、温度相关性；剪切蠕变曲线形状和蠕变寿命与温度及应力大小有关。
Within the range of test temperature, the factors controlling the toughness are fracture loads, the lengths of fibrous crack, and the energy absorbed by each fibrous crack extension.
在试验温度区内，控制韧性的因素是断裂载荷、纤维裂纹长度和单位纤维裂纹扩展能量。
The results show that the fracture toughness of Kic increased with lower loading rate and higher test temperature and the incision depth has no significant impact on the test results.
结果显示，断裂韧度随加载速率降低和试验温度提高而增大，而切口深度对结果的影响不显著。
The contrasting results show that sound intensity, radiation time and frequency are the main factors, and the secondary factors are test temperature, working mode and settlement time.
对比实验研究表明：声强、辐照时间和频率是影响破乳脱水率的主要因素，而实验温度、工作方式、沉降时间等为次要因素。
Test temperature on wrist before feeding. Feed immediately. Discard unfinished feeds.
在手腕上测试温度是否合适。立即使用，没有吃完的要倒掉。
Test temperature is important to effect the sensitivity of the SDA piezoelectric gene sensor.
实验温度是影响SDA压电基因传感器检测灵敏度的重要因素。
The system can load test, efficiency test, temperature test, locked rotor test.
该系统可以进行加载试验、效率试验、温升试验、堵转试验。
The system can load test, efficiency test, temperature test, locked rotor test.
该系统可以进行加载试验、效率试验、温升试验、堵转试验。
应用推荐