The data of well-test pressure could be used to describe reservoir heterogeneity.
试并压力资料能有效表述储层非均质性。
The test pressure shall be within the limits set forth by the Hydraulic Institute.
测试压力应该在美国水利协会规定的范围内。
Hydrostatic test, Pneumatic test, test pressure, test temperature, Vacuum vessel, Combination units.
液压试验，气压试验，试验压力，试验温度，真空容器，组合容器。
Meanwhile, this formula can be also used to verify the test pressure specified by the design document.
同时也可用本计算公式来校验设计文件规定的试验压力。
This test pressure includes corrections for service conditions e. g. backpressure or high temperatures.
此试验压力包括工作条件如：背压和高温的校正值。
In this paper, by using reliability design methods, the test pressure of ultrahigh cylinder is studied.
应用可靠性设计方法，对超高压圆筒耐压试验压力进行探讨，定量分析试验压力与影响因素之间的关系。
The TK-DL can test pressure vacuum breakers, reduced pressure backflow preventers or double check valve assemblies.
TK - DL可以检测压力真空断路阀，减压防回流阀或双止回阀总成。
1gas Leakage test for piping system shall be carried out according the design document; the test pressure shall be the design pressure.
1管道系统的气体泄漏性试验，应按设计文件规定进行，试验压力为设计压力。
The test pressure of target service is controlled by using tokens and the load balance of distributed testing is realized by token migration.
采用令牌方式来控制目标服务的测试压力，通过令牌迁移实现分布式测试的负载平衡。
During the pressurization to each test pressure, two tests shall be carried out for the calculation of air volume in the pipeline under test.
在把压力升到每一个试压压力的过程当中，为了计算试压管线当中空气的体积要进行两次测试。
In this case, the test pressure shall not exceed the maximum allowable test pressure for non-isolated components, such as in-line vessels, pumps, and valves.
对于不能隔离的系统，如：在线容器、泵和阀门等，测试压力不应大于系统组件最高允许测试压力。
The test pressure coefficient and safety factor are searched for thin-wall vessels with minimum virgin reliability of burst strength in different working conditions.
基于随机-模糊概率模型，定量分析了钢制薄壁圆筒临界失稳强度的模糊可靠度、稳定系数与外压试验压力系数之间的关系。
Designed to test pressure vacuum breakers, reduced pressure backflow preventers or double check valve assemblies, allowing you to eliminate both pressure and differential test gauges.
适用于检测压力真空断路阀，减压防回流阀或双止回阀总成，不再需要压力表和压差表。
In this paper, by using reliability design methods, the test pressure of ultrahigh cylinder is studied. It is analyzed what the fixed quantity relation of test pressure with influencing factor.
应用可靠性设计方法，对超高压圆筒耐压试验压力进行探讨，定量分析试验压力与影响因素之间的关系。
CONCLUSION: the test anxiety has gender difference of which reason may be because of the cognition of the pressure from school and society and the self-negative cognition induced by test pressure.
结论：考试焦虑存在性别差异，造成差异的原因可能是对学校社会压力的认知和由于考试压力造成的自我负面认知。
In static state characteristic test, pressure gain characteristic, runoff characteristic with load, runoff characteristic without load and leakage characteristic are completed.
在伺服阀静态特性方面，完成了伺服阀的压力增益特性、空载流量特性、负载流量特性及泄漏特性的测试。
In static state characteristic test, pressure gain characteristic, runoff characteristic with load, runoff characteristic without load and leakage characteristic are completed.
在伺服阀静态特性方面，完成了伺服阀的压力增益特性、空载流量特性、负载流量特性及泄漏特性的测试。
应用推荐