Study showed that angle deformation of T joint is changed along the welded seam length.
研究表明，T形接头的角变形沿焊缝长度方向是变化的。
The small blind hole method is used for the measurement of residual stress inside T joint.
采用盲孔法测定了丁字焊缝的残余应力。
This paper studied mainly multi-T joint test data. By analysis test data, gave experience equation for transverse distortion of T-joint welding structure.
本文重点分析了多个T形接头焊接的工艺试验结果，通过对试验数据的分析，得出了对T形接头焊接构件的横向变形的经验公式。
Under Ankara's ATAK program, AgustaWestland signed a multibillion-dollar contract with Turkey in 2007 for joint manufacture with Turkish partners of at least 50 T-129 attack helicopters.
根据土耳其的ATAK计划，2007年，AgustaWestland公司和土耳其签署了数十亿美元的合同，内容为与土耳其伙伴联合生产至少50架t- 129攻击直升机。
WIN-T is a critical enabler of LandWarNet, the Army's effort to transform into joint, network-centric, knowledge-based warfare.
WIN - t是陆战网(Land War Net)的一个重要使能器，陆战网是美国陆军向联合、网络中心化以及基于知识作战转型的重要网络。
The SATCOM terminals being converted are for the Joint Network Node (JNN)/Warfighter Information Network-Tactical (WIN-T) military network program for Army communications.
对卫星通信终端进行修改是为了陆军通信的联合网络节点（JNN）/士兵信息网络战术（WIN-T）军事网络计划。
All butt, grooved t, and corner joints shall be complete joint penetration weld joints.
所有对接、T型槽和弯管接头都要完全侵入连接到焊接接头上。
Different ways of erosion measurement were also compared with each other and the T-type joint method is the best one.
比较了几种测定熔蚀的方法，其中以丁字接头为最好。
When the damage to people is caused by fallen objects with an unidentified injuring person, it doesn t constitute joint dangerous act and the equitable liability doctrine can not be applied either.
楼上落下物致人损害不能确认加害人，并不构成共同危险行为，也不能适用公平责任，只能对受害人实行社会救济。
The old joint can' t meet the demand of big shell distortion, and the performance of joint should be improved.
原有传爆接头已不适应壳体大变形的需要，需采取措施改进接头性能。
The joint design, welding procedure and mechanical properties of the joint are studied for resistence welding of thin tubular T connection.
研究了薄壁管T型接头的电阻焊焊件的接触形式，焊接规范及接头的机械性能等。
The results show that the T-type connection joint can be regarded as rigid under some circumstances but the effects of certain joint flexibility on the structure system should be taken into account.
分析结果表明，在一定几何条件下，T形相贯节点可以看作刚接节点，但应考虑一定的节点柔性对整体结构变形的影响。
The rotating shafts of three t type joint modules are parallel to each other and are mutually perpendicular to the rotating shafts of the I type joint modules at both ends.
三个T型关节模块的转轴互相平行，并与两端的I型关节模块的转轴互相垂直。
By studying the t section steel truss joint, the defects in truss design are pointed out in this paper.
通过对T型钢桁架节点的研究，指出了目前设计中存在的问题。
The analysis results can be guidance for the optimization design and maintenance of inclined T-tube joint.
分析结果对灌装系统中的斜T型管接头的优化设计及使用维护，有一定的指导作用。
The mathematical model is the academic groundwork of autonomous navigation strategy design and relevant structure design of pipeline robot in T-joint.
所提出数学模型是管道机器人三通自主行走控制策略设计和相应结构设计的理论基础。
A gymnasium consists of space truss structure and shopping basket shaped truss structure, and the T-type rigid connection joint is adopted when the circular tube is intersected.
某体育馆是由网架结构和落地提篮形桁架组成的杂交结构，圆管相交采用T形相贯刚接节点。
Experimental result showed that the robot can move out pipe and can pass over obstacles such as flanges T-joint, and L-joint.
试验结果表明，该机构能够在比较复杂的管路上行驶，能够通过管路上的典型障碍。
From a yield line model used for calculating RHS-joint strength, a stiffness model is developed for a stepped T-type RHS joint, and a stiffness formulas is established.
在计算节点强度的塑性铰线模型的基础上，建立了不等宽t型方管节点在支杆轴压荷载作用下的刚度模型，推出了刚度简化计算公式。
The influence of geometric parameters on stepped T-type RHS joint was studied by using finite element method considering material and geometrically nonlinear effect.
采用能处理几何非线性和材料非线性影响的有限元方法，研究了几何参数变化对弯矩作用下不等宽t型方管节点性能的影响。
Of most interest is the stealth shaping, which is considerably better than that seen in the Russian T-50 PAK-FA prototypes and in the F-35 Joint Strike Fighter.
最令人感兴趣的是它的隐形外形，已经超过了之前所看到的俄罗斯的T - 50 PAK - FA原型机和F - 35联合战斗机。
A mathematical model to describe the traveling-capability of pipeline robot in T-joint is presented, which is composed of a set of constraint equations.
通过对约束方程的分析讨论、与管道机器人弯道通过性的对比分析，得出了规律性的结论。
Temperature and stress distribution of multi-pass welded T-joint was simulated using ABAQUS codes. 3-d solid elements were used to mesh the model.
应用abaqus软件，对多道焊T形接头的温度场和应力场进行了数值模拟。
According to the principle of constructing elliptical conical surface by the circles on a sphere, a T-joint inscribed in a sphere is designed.
根据“球面上圆构造椭圆锥面”的原理，设计了球内接三通接头。
Agricultural universal joint transmission shaft is a common part for connecting P. T. o of the tractor with power-driven implements.
农用万向节传动轴是联结拖拉机动力输出轴与驱动型农机具重要的通用性部件。
To make a better understanding of joint mechanics behaviors, this thesis studies joints of T-section steel truss with finite element method (FEM).
为了更好的了解节点的受力特征，本文将对T型钢桁架节点采用有限元的方法进行一些研究工作。
The check valve and T-joint are designed into one, this simplifies the installation process and avoids to some troubles.
将单向阀（逆止阀）与T型接口设计成一体，简化了安装工序，克服由此引发的故障；
Nomatter transporting gas or oil, there are pipelines, there are pipe fittings such as bend pipe, reducing joint, T-pipe, pipe cap and so on.
无论是用管道输气、输油，凡有管道的地方，都少不了弯头、异径接头、三通、管帽等管件。
Suitable model was established to simulate the temperature distribution of TIG welding of T-joint sheets using ABAQUS code. Temperature dependant material properties were considered in the simulation.
运用大型有限元分析软件ABAQUS，建立了适当的模型对薄板T型TIG焊接接头的温度场进行了数值模拟。
Imagine Forest, a joint effort by Arts Fission Company and the t 'ang Quartet, showed clearly that the preparations were inadequate.
唐四重奏和化生艺术团合作跨界舞台《想像的森林》，也明显准备不足。
应用推荐