A comparison between switched current and switched capacitor techniques is made.
对开关电流技术与开关电容技术的一些基本特征进行了比较。
This paper summarizes the switched capacitor filter and switched current filter design methods.
本文对开关电容滤波器和开关电流滤波器的设计方法作了综述。
The specification usually includes both the maximum carry current and the maximum switched current.
该指标通常包括最大载流和最大切换电流。
As a new current-mode technique, switched current has been in a forward position of current-mode analog signal processing.
开关电流作为一种新的电流模式技术已经成为电流模式信号处理的前沿课题。
The basic unit structure of the switched current circuit is introduced. Problems with SI technique and their solutions are discussed.
介绍了开关电流电路的基本单元结构，讨论了目前开关电流技术中存在的问题及其解决方法。
If the switched current is too high, the resulting temperature increase and contact arcing will degrade the relay and shorten the contact life.
如果切换电流太高，造成的温度升高和接触电弧将会劣化继电器并缩短接触寿命。
Switched current circuit (si) is a new technique for analog sampled data processing.
开关电流(SI)技术是一种新的模拟抽样数据处理技术。
Switched current is the maximum current that can be handled reliably while opening and closing contacts.
切换电流是指继电器在开路和闭合触点时能可靠处理的最大电流。
The method can analyze electronic circuits by using Trans Linear circuits, Current Mirrors, Current Conveyers, Switched Current circuits in common use.
该方法可以利用跨导线性电路、电流镜、电流传输器、开关电流电路等单元电路来分析常用电子电路。
A design method of switched-current (si) ladder filters using the bilinear transformation is proposed.
本文提出了一种用双线性变换进行开关电流(SI)梯形滤波器设计的方法。
This paper proposed a method for the implementation of continuous wavelet-transform (CWT) using switched-current (si) technology, based on current mode and a substitute of switched-capacitor.
提出了一种基于电流模的开关电流技术取代基于电压模的开关电容技术实现连续小波变换的方法。
It should satisfy dynamic stability, thermal stability, switched-current and switch up-down selectivity in a short circuit while selecting the pumping station using electricity system equipments.
选用站用电系统设备时应满足短路时的动、热稳定，开断电流，开关上、下级的选择性等要求。
It should satisfy dynamic stability, thermal stability, switched-current and switch up-down selectivity in a short circuit while selecting the pumping station using electricity system equipments.
选用站用电系统设备时应满足短路时的动、热稳定，开断电流，开关上、下级的选择性等要求。
应用推荐