Record the surface pressure at this point.
记录这一点的地面压力。
Press the cylinder structure, ensure uniform surface pressure.
成型压机采用多缸结构，确保大台面承压均匀。
The surface pressure of a well at the finish of a squeeze cement job.
挤水泥作业结束时井的地面压力。
The dynamic surface pressure was obtained according to experimental data.
根据所测非平衡张力，对应动态表面压力数据也进行了计算。
Surface pressure field was mainly controlled by the huge clod high pressure.
地面气压场主要受庞大的冷高压控制。
A weak area of high surface pressure that covers most of North America in winter.
冬季覆盖北美大部分地区的微弱高压。
Surface pressure distribution can be used to describe the airfoil boundary layer flow well.
可用于表面压力分布以及描述翼型边界层流的。
The paper introduced a spinning model surface pressure measurement sy which used in the wind tunnel.
本文介绍了可用于测量风洞中旋转模型表面压力分布的集成测试系统。
Cylindrical type rubber fender has low reaction force, little surface pressure, reasonable energy absorb.
圆筒型橡胶护舷反力低，面压适中，吸能量合理。
Surface pressure-clamp, high strength, pressure clamp on tool designed to change the form of fast, easy tool changing.
压钳表面平整、强度高，压钳上设计成快换形式，换刀便捷。
The surface pressure distribution around the deck section has significant influence on the aerodynamic behaviour of the deck.
表面压力分布对断面的气动特性有着重要的影响。
The ocean surface currents driven by the sea surface winds and the sea surface pressure fields are also close to the observations.
用海面风场和海面气压场启动的海洋表面流，与实况也较一致。
Result of the experiment shows that the surface pressure and rainfall area are predicted better than the original five-level PE mode…
试验结果，该模式对天气形势和雨区的预报都比原等距五层模式有明显改进。
The surface pressure coefficient and the minimum pressure coefficient of a bridge deck section are important parameters of the bridge.
桥梁断面表面压力系数、最小压力系数等是桥梁断面重要的参数。
The speed fields and circulation distribution of wing-pylon combination, and the surface pressure distributions of the stores are given.
给出了机翼—挂架组合体的速度场，环量分布和外挂表面的压强分布。
The lift and drag coefficients were determined from the surface pressure distributions, which were measured under all tested conditions.
结果表明：所有工况条件下，加襟翼都能够增加升力系数。
The creep of a skin layer under a distributed surface pressure was solved by an analytical method using Hankel transform and Laplace transform.
本文利用积分变换方法求解皮肤层在表面压力作用下的蠕变响应问题。
Too much lip-axis will increase the load-side contacts, while the shaft is too small it will end lip of the seal contact surface pressure enough.
过大的轴会增加唇端的接触载荷，而过小的轴则会使唇端接触面上的密封压力不够。
When they descend to 50 meters or deeper, they must return to the surface slowly, to allow their bodies to readjust to the lower surface pressure.
当他们潜到50米或更深之后，必须缓慢的回到水面，才能使他们的身体重新将压力调节到低一些的水面气压。
By using the spline interpolation, objective analyses of geopotential, temperature and surface pressure fields are tested and good results obtained.
本文用样条插值进行了高度、温度、地面气压等要素场的客观分析试验，取得了良好的结果。
An ideal experiment exhibits that pressure gradient force computations in the pressure terrain-following coordinate are sensitive to surface pressure.
在气压地形追随坐标中气压梯度力的计算对地表气压计算很敏感。
The plug surface pressure profiles for the full-length plug nozzle at different NPR can provide valuable data for researching the truncated plug nozzle.
不同压强比下全锥塞式喷管的塞锥表面压强分布规律，可以作为研究截短型塞式喷管塞锥压强分布的基础。
The initial typhoon circulation is a bogus pattern determined by the central surface pressure and the maximum wind speed of the typhoon being predicted.
初始台风环流是由台风中心海平面气压与最大风速所确定的一个模型环流。
The important role of liquid surface pressure control system on density of casting during die casting process and different process has been put forward.
论述在低压、差压铸造的生产过程中，液面加压控制系统对提高铸件致密度的重要作用。
The influence of clearance between the nozzles and the model of the surface pressure was used in the hybrid extended-range technique of the side back jet.
在风洞实验中采用纹影照相和压力分布相结合的实验方法，确定了侧后向喷流复合增程技术中喷嘴—模型之间间隙的大小对表面压力的影响。
This article mainly analyses the factors that affect the precise indexer life, touching surface pressure, basic motion load and temperature factor for example.
着重分析影响精密分度装置寿命的接触表面压力，基本动载荷，温度系数等因素。
Metal cock ring soft seat surface pressure to the bearing surfaces, such as the valve core and valve seat is concentric ring surface can be a double tight closure.
金属旋塞表面压向阀座环软支座表面，如阀芯和阀座环表面是同心的，就能得到双重严密的关闭。
The invention provides a sinter oil-containing bearing that inhibits self abrasion and shaft abrasion even under the high surface pressure and manufacturing method thereof.
本发明提供一种，即使在高面压条件下，仍可以抑制轴承自身的磨损以及抑制轴磨损的烧结含油轴承及其制造方法。
The invention provides a sinter oil-containing bearing that inhibits self abrasion and shaft abrasion even under the high surface pressure and manufacturing method thereof.
本发明提供一种，即使在高面压条件下，仍可以抑制轴承自身的磨损以及抑制轴磨损的烧结含油轴承及其制造方法。
应用推荐