The transfer function is resolved by step response.
应用阶跃响应法导出电机传递函数的模型参数。
The method only requires the step response data of the plant.
该方法仅需要对象的？跃响应数据。
These involve the single step response characteristic of stepping motor.
这些涉及步进电动机的单步响应特性。
From the step response of the electric oven, the model of the oven is obtained.
通过测试电烤箱的阶跃响应，用作图法得到电烤箱的模型。
The experimental curves of step response and output displacement were obtained.
通过试验得到了实测阶跃响应曲线和输出位移曲线。
And evaluate the performance of PID controller by the step response of the system.
并通过系统响应曲线图对设计的PID控制器的性能进行评估。
The system has obtained very good step response, ramp response and sine function response.
所得到的系统对阶跃输入，斜坡输入，正弦函数输入有很好的响应特性。
The paper discusses the single step response characteristic on five-phase hybrid stepping motor.
本文研究了五相混合式步进电动机的单步响应特性。
This paper introduces a bilinear step response model based on the basic dynamics of an actuator.
根据作动器的动力特性，提出液压伺服作动器阶跃响应的双线性简化模型。
A model identification method on multivariate system step response based on least Square is given out.
提出了一种基于最小二乘的多变量系统阶跃响应的模型辨识方法。
Making use of the linearity of system, the technique of obtaining the step force from step response is developed.
利用线性系统的特点，给出使用阶跃响应获取阶跃力的技术。
The setting range of no load voltage step response index for self excited shunt excitation system is put forward.
对自并励静止励磁系统发电机空载阶跃指标提出整定范围。
This paper presents a method for optimizing the digital PID parameters on the basis of object unit-step response curve.
本文介绍了根据对象阶跃响应曲线进行数字PID调节器参数最优整定的方法。
The method of extracting dynamic characteristics of system based on step response is researched mainly in chapter three.
第三章主要研究基于阶跃响应的系统动态特性的提取方法。
A simple and practical improved self-tuning PID controller based on step response identification has been proposed in this article.
提出了一种简单、实用的，基于阶跃辨识的改进型自整定PID控制器的设计方法。
In this paper, a kind of non-parameter model is constructed with the unit step response of the nuclear reactor neutron dynamic system.
利用核电站反应堆中子动力学系统的单位阶跃响应数据，得到了该系统的非参数模型。
In this paper, an adaptive predictive control algorithm based on a simplified model is proposed for a stable system with monotone step response.
针对单调阶跃响应的单变量系统，提出一种基于简化模型的自适应预测控制算法。
The problem of slow step response in electrostrictive actuator is studied and a digital PID method is proposed to compensate the slow step response.
针对压电陶瓷微位移执行器动态响应速度慢的问题进行了研究，提出用数字PID方法加以解决，并研制出一套实用控制系统。
For IIR, after researching Pulse Response Method, Step Response Method, Bilinear Transform Method, Direct Design Method, it is found that IIR is unsatisfactory.
对IIR的脉冲响应不变法、阶跃响应不变法、双线性变换法和直接设计法进行研究，得出IIR难以满足要求的结论。
With the analysis of the step response diagram and poles diagram, the optimal state feedback array is obtained and finish designing of optimal controller of AGV.
通过对闭环系统阶跃响应和零极点图的分析，合理的确定了系统最优反馈控制增益矩阵，最终完成了控制器的设计。
This paper proposed a modeling method using inverter step response waveform data to improve the precision of compensator based on waveform library control technique.
为了提高补偿器的补偿精度，根据波形库控制技术提出基于控制对象单位阶跃响应波形的建模方法。
In general, the dynamic math model of a thermal process is an approximate transfer function obtained from step response curve which is figured through field experiment.
热工过程的动态数学模型通常通过现场试验作出它的阶跃响应曲线，然后从阶跃响应曲线得出近似传递函数。
This paper presents the input voltage shape reconstructed by FFT method from the distorted output shape and unit step response of impulse high voltage measuring system.
本文介绍了一种根据冲击测量系统的方波响应和输出波形，利用FFT算法重建输入波形的方法。
Using the step response behavior of inertia process and the superposition theorem of linear system, this paper puts forward a fuzzy predictive model of dead-time processes.
利用惯性过程的阶跃响应特性和线性系统中的叠加原理，提出了纯滞后过程的模糊预估模型。
It was found that the start-up and step response time of PEM fuel cell was in the order of seconds, which was similar to the simulation results of most presently used models.
结果表明：电池的启动时间和阶跃响应时间均为秒的数量级，与大多数模模拟的结果相一致。
The step response method of the outlet superheat of evaporator is measured by conducting experiments, and dynamic model of EEV is established by LSE (least square estimation).
通过阶跃响应实验法，利用最小二乘法建立燃气机热泵蒸发器—电子膨胀阀系统的过热度响应动态模型。
Using this model and the Recursive Least Square (RLS) method, the model parameters and then the mass to be weighed can he identified from the step response of very short duration.
借助这一模型和递推最小二乘法(RLS)，可以由极短的称重阶跃响应估计出模型参数和被称质量。
An adaptive fuzzy PID controller with modifying rules is introduced and is compared with ordinary PID controller by simulation on step response and response of 15 operating modes.
提出一种带修正因子规则的模糊pid控制，分别用这种控制器和常规pid控制器对阶跃信号和车辆的15工况进行仿真分析。
An adaptive fuzzy PID controller with modifying rules is introduced and is compared with ordinary PID controller by simulation on step response and response of 15 operating modes.
提出一种带修正因子规则的模糊pid控制，分别用这种控制器和常规pid控制器对阶跃信号和车辆的15工况进行仿真分析。
应用推荐