If air or process fluid leaks, increase the recommended torque in increments of 50 ft. lbs.
如果气体或所处理的流体泄漏，则建议以每次50英尺磅的增量增加螺栓紧固扭矩值。
For the viscosity or density change in the process fluid, the pump will not be affected too much.
对于粘度或密度在工艺中有变化的流体，这种泵不会受到太多影响。
The driver moves the piston inside the cylinder, alternately pulling in and pushing out the process fluid (Fig. ).
原动机驱动在汽缸内的活塞，交替地吸入和排出工艺流体（图）。
A method of reducing the sorbate concentration of a process fluid stream using a sorption bed system includes the following steps.
采用吸附床系统降低工作流体流吸附物浓度的方法包括以下步骤。
A process fluid stream is passed through the sorbent mass in the first zone, and a regeneration fluid stream is passed through the sorbent mass in the fourth zone.
使工作流体在第一区段穿过吸附剂块体，并且使再生流体流在第四区段穿过吸附剂块体。
The potential for efficiency improvement depends mainly on the fuel type fired, the exit flue-gas temperature, the process fluid temperature, the low-level heat required, and the excess air etc.
冷凝式锅炉的热效率提高潜力主要取决于燃料种类、锅炉本体的排烟温度、工艺流体的温度、所需的低品位热能的数量、过量空气系数等。
The research of ore-forming fluid includes large-scale translayer effect, mantle metallogenetic process, fluid thermodynamics and dynamics of fluid.
成矿流体的研究主要包括流体的广域穿层效应，地幔流体成矿作用，成矿流体热力学、动力学等几个方面。
The research of ore-forming fluid includes large-scale translayer effect, mantle metallogenetic process, fluid thermodynamics and dynamics of fluid.
成矿流体的研究主要包括流体的广域穿层效应，地幔流体成矿作用，成矿流体热力学、动力学等几个方面。
应用推荐