The filters are comprised of a clay pot set inside a plastic bucket with a nozzle at the bottom of it.
该过滤器其实就是一个涂敷胶体银的多孔过滤陶罐装在其底部开有水嘴的塑料桶里。
The nozzle insert can either be injection moulded from plastic or can consist of metal.
该喷嘴嵌件既可以由塑料用注塑法生产，也可以由金属制成。
The runner system in the injection mold serves to convey the plastic melt coming from the nozzle of the injection molding machine to the cavity.
注射模的浇注系统是指从注塑机喷嘴开始到型腔为止的塑料流动通道，它是模具的一部分，一般分为普通流道浇注系统和无流道浇注系统两大类。
The smaller threads of the nozzle assemblies allow the sensor to be mounted onto the molding machines nozzle to measure the temperature of the plastic as it exits.
喷嘴装置的螺纹较小，可将传传感器安装在铸造机器喷嘴上，以此来测试塑料的温度。
When the softened plastic reaches the end of this chamber, it is forced at high pressure through a nozzle and into a cool mold.
当达到软化塑料的结束这个会议厅，这是强迫高压通过喷嘴，并进入冷却模具。
Plastic beauty and technical personnel in the successful summarizes the thousands of sets of hot runner system based on the successful development of the: small diameter nozzle wear;
塑美技术人员在成功总结了几千套热流道系统经验的基础上又成功开发了：小直径耐磨喷嘴；
Plastic rifle body, soft seal between the top of the nozzle and the needle, ready for use. Economical but last...
塑料枪体，喷管顶端部位与顶针的密封采用软性材料密封，经济实用。
Flow distribution plate and the nozzle and the injection molding machines are connected, the injection of molten plastic melt by heating the shunting plate pressure evenly distributed to each nozzle.
分流板与喷嘴和注塑机连接，将注塑出来的熔融状态的塑胶熔体通过加热的分流板压力均匀分流到各个喷嘴。
The waste plastic is molded using a molding method of extruding it from a nozzle of a screw-type stuffing machine.
采用使用螺杆式压入机将该废塑料从喷嘴挤出的成型方法进行成型。
The plastic water pipe and the nozzle have not placed at will ground or soak in the basin.
塑料水管及喷头没有随意地放在地上或泡在水池里。
The plastic water pipe and the nozzle have not placed at will ground or soak in the basin.
塑料水管及喷头没有随意地放在地上或泡在水池里。
应用推荐