Permissible deviation of bolt hole circle diameter on flange and permissible limited deviation of two adjacent holes on flange shall be less than 0.6mm.
法兰螺栓口中心圆的直径的容许偏差及法兰相邻两孔极限容许偏差的应小于0.6毫米。
Lower deviation: the difference between the minimum permissible size of a part and its basic size.
下偏差：零件最小极限尺寸减去其基本尺寸所得的差值。
Such deviation between the products and the sample is normal and permissible, therefore, the claim for compensation cannot be allowed.
这种产品与样品之间的偏差是在正常的允许范围之内，因此，索赔不予受理。
The term permissible running deviation comprises all tolerances which affect bearing running accuracy: radial runout, side face runout relative to the raceway and runout relative to the bore.
宽度上的变化对于最大和最小尺寸的套圈是不同的。列表里允许的运行偏差包括了影响轴承运行精度的所有公差类型。
The determination method and computing formula of the permissible lateral and vertical deviation of arbitrary point on axial line of the target are discussed and derived.
讨论并推导了靶体轴线上任一点的允许横向偏差和允许纵向偏差的规定方法和计算公式。
Deviation from the letter of the original is permissible only if it enhances the audience's understanding of the speaker's meaning.
只要是能让听众更好的理解发言者的意图，即使用词偏差也是可以的。
Deviation from the letter of the original is permissible only if it enhances the audience's understanding of the speaker's meaning.
只要是能让听众更好的理解发言者的意图，即使用词偏差也是可以的。
应用推荐