米勒平台区对应着最大的负载电流。
Id will reach the maximum value at the region of miller platform.
最低负载电流是必要的运作无误的两线设备。
The minimum load current is necessary for flawless operation with two-wire devices.
2节中描述的负载电流，电源可以正常工作。
The load current is described in section 2.2.2, the power can work normally. 2.2.
如何平均分配负载电流是并联技术的一个重要方面。
Uniform distribution of load current is one of the key technique for paralleling operation.
电动机的负载电流不得超过额定值，三相电流平衡。
The electric motor should not overload, three -phase current should be balance.
负载电流的计算应该根据工作电压和负载的功率计算。
The load current is calculated from the supply voltage and the load power.
该文论述了负载电流为非正弦波时功率因数测量的新方法。
This paper presents a new method for measuring the power factor in nonsinusoidal load current.
具有短路保护、过电流保护、过负载保护以及电压保护多重保护。
With short circuit protection, over current protection, the load voltage protection protection and multiple protection.
短路保护，过电流保护、过负载保护以及电压保护。
Short circuit protection, over current protection, overload protection and voltage protection.
短路保护，过电流保护、过负载保护以及电压保护。
Short circuit protection, over current protection, overload protection, voltage protection.
它可为负载提供大电流脉冲放电。
在输入电压最小值，负载为满载条件下，最大输入电流不大于1.5 A。
The input current should be less than1.5A, under minimum AC input and full load.
论述了小电流互感器专用负载箱的原理及技术设计。
Discussing the principle and technical design of special-purpose loading box for small current mutual inductor.
感性负载的主要特性是电压超前电流。
Voltage ahead of current is the main characteristic of inductive load.
当在太阳能电池上连接负载时，就会产生电流。
When a load is connected to the cell, electric current will flow.
灯泡负载之突入电流为稳定状态之10倍。
The Bulb carry current is 10 times as than in stable condition.
马达负载之突入电流为稳定状态电流之6倍。
马达负载之突入电流为稳定状态电流之6倍。
应用推荐