The rate of metal evaporation increases with increase of temperature under vacuum.
在一定的真空度下，金属的蒸发速率随着温度的升高而增大。
Processing capacity will decrease with imported sand temperature increase.
处理量随着进口砂温的增高而降低。
Liquid usually expands with the increase of temperature.
液体通常随着温度的上升而膨胀。
Test shows that the embrittlement temperature will increase with increase of the Si content.
试验表明，铸态铁素体球铁硅含量增加时，脆性转变温度也相应提高。
The melt temperature decreases linearly with the increase of the charge mass.
炉料质量与熔体温度呈线性关系，随着炉料质量的增大熔体温度降低。
As we know, materials expand and contract with the increase and decrease of temperature.
正如我们所知道的，物质随着温度的增加和减少而膨胀和收缩。
With the increase of temperature, the weight loss of zinc coating increases.
且随着温度的升高， 镀锌板的锌层脱落量增加。
The separation efficiency increased with the increase of temperature and decrease of pressure.
升高温度降低压力有利于花生四烯酸乙酯和亚油酸乙酯的分离。
The no load speed decreases with the increase of surrounding temperature.
随着环境温度的增加马达的空载转速下降。
With the increase of temperature, the reaction is more complete.
而随着温度的上升，反应越完全。
The initial shrinkage temperature and the shrinkage change little with the increase of heating rate.
升温速率增大，坯片开始收缩的温度及收缩率几乎不变。
Shrinkage stress was found to increase linearly with cure temperature.
我们发现收缩应力随固化温度直线增加。
The mean temperature of ballast is decreased with increase of its thickness.
碎石体的平均温度随碎石厚度增加而降低。
The denitrification rate increased with the increase of the temperature.
温度升高，反硝化速率增加。
Polymerization speed increases with the increase of reaction temperature.
聚合反应温度提高，聚合速率加快。
When deformation temperature is constant, flow stress increases with the increase of strain rate.
当温度一定时，流变应力随着应变速率的升高而增大。
The number of twin increased with the increase of anneals temperature and time.
孪晶密度随退火温度和退火时间的增加而增加。
The room temperature tensile strength increases with the increase of strain rate.
其室温拉伸强度随应变速率的加快而提高；
The maximum cutting temperature increases with the increase in cutting speed.
最高切削温度随着切削速度的增大而增高。
The specific surface area of the activated carbon decreases with the increase of carbonization temperature.
随着炭化温度升高，样品比表面积逐渐降低。
The influence of LC on the strength is reduced with the increase temperature.
失碳率的影响随温度的升高而减弱。
The reduction rate was decreased with the increase of reduction degree at different temperature.
不同温度下，还原速率随着还原程度增加而减小。
The results show that the crystallization temperature decreases with the increase of cold pressure rate.
结果表明，随冷轧压加率的提高，再结晶温度降低。
The results show that the crystallization temperature decreases with the increase of cold pressure rate.
结果表明，随冷轧压加率的提高，再结晶温度降低。
应用推荐