Now node 1 has two partial sums.
现在节点1有两个部分和了。
In Figure 1, the state machine starts at node 1.
在图1中，状态机从节点1开始。
Node 1 adds these partial sums to get the final sum.
节点1对这些部分和进行求和，从而得出最终的总和。
Basic sanity check: Verify Node 1 is up and working.
基本的状态检查：验证节点1正常工作。
Figure 1 shows a reply activity as the last node in the simple process.
图1将应答活动显示为简单流程中的最后一个节点。
Tables 1 and 2 represent data you need to back up on each node.
表1和2代表在每个节点上所需备份的数据。
From the new cluster node Menu, type "1" to create a new cluster.
从新集群节点菜单，键入“1 ”创建新的集群。
Method 1: Set up the backup node.
方法1：设置备份节点。
Finally, notice the last child node of the departments node in Figure 1.
最后，注意图1中departments节点的最后一个子节点。
In Figure 1, the name of the root node is org.
在图1中，根节点的名称为org。
In Figure 1, the engineers group is a child node of the engineering department.
在图1中，engineers组是engineering部门的子节点。
This node is shown in Figure 1.
节点如图1所示。
Figure 1: Drive letter allocation per node.
图1：每节点的驱动器号分配。
The node should normally be soft and pink and less than 1 cm in size.
正常的淋巴结应该是质软、粉红色、直径小于1厘米。
The node should normally be soft and pink and less than 1 cm in size.
正常的淋巴结应该是质软、粉红色、直径小于1厘米。
应用推荐