Method 1: Set up the backup node.
方法1：设置备份节点。
In Figure 1, the name of the root node is org.
在图1中，根节点的名称为org。
Tables 1 and 2 represent data you need to back up on each node.
表1和2代表在每个节点上所需备份的数据。
Figure 1 shows a reply activity as the last node in the simple process.
图1将应答活动显示为简单流程中的最后一个节点。
Finally, notice the last child node of the departments node in Figure 1.
最后，注意图1中departments节点的最后一个子节点。
Figure 1: Drive letter allocation per node.
图1：每节点的驱动器号分配。
In Figure 1, the state machine starts at node 1.
在图1中，状态机从节点1开始。
This node is shown in Figure 1.
节点如图1所示。
Node 1 adds these partial sums to get the final sum.
节点1对这些部分和进行求和，从而得出最终的总和。
Basic sanity check: Verify Node 1 is up and working.
基本的状态检查：验证节点1正常工作。
The node should normally be soft and pink and less than 1 cm in size.
正常的淋巴结应该是质软、粉红色、直径小于1厘米。
The node should normally be soft and pink and less than 1 cm in size.
正常的淋巴结应该是质软、粉红色、直径小于1厘米。
应用推荐