Once you are done click close.
完成后点击关闭。
In the success dialog, click Close.
在出现的成功消息框中，单击Close。
Click close to close the window.
单击Close关闭窗口。
Click Close to dismiss the window.
单击Close关闭此窗口。
Click close to close the message window.
单击Close关闭消息窗口。
Click Close on the configuration utility.
在配置实用工具上单击Close。
Now you can provide a rating. Click Close.
现在您可以提供一个评级，点击Close。
Click Close and return to the Control Panel.
单击Close，并返回控制面板。
To close the View Report dialog box, click Close .
单击关闭 ，关闭查看报告对话框。
Click Finish, click Close, and then click OK.
单击完成，关闭，确定。
Click Close and complete the provisioning request.
单击Close并完成提供请求。
Click close to close the successful message window.
单击Close关闭成功消息窗口。
Click Close on the policy canvas as shown in Figure 69.
在策略画布上单击Close，如图69所示。
After the package installs, click close to close the dialog.
这个包安装后，点击“关闭”，关闭此对话框。
Click Close to complete the configuration of the component machine.
单击关闭完成组件机的配置。
Check the box, Apply Changes, put in your password, and click close.
打上勾，应用改变，输入你的口令，最后点击关闭。
Click Retry to try setting up these programs again, or click Close to exit.
单击“重试”来试着安装这些程序，或单击“关闭”退出。
When you click Close, you should see that the OVERDRAFT trigger has been created
在点击Close之后，您将看到OVERDRAFT触发器已经创建好了
When the progress bar indicates 100 percent of the tasks are complete, click Close.
当进度栏表明任务已全部完成时，单击Close。
Click OK to close the message dialog.
单击OK关闭这个消息对话框。
Solution: Click here to close this window and return to the main window.
解决方法：单击此处关闭该窗口并返回主窗口。
If the failure can be corrected by reconfiguration, click the Close and confirm the configuration.
如果可以通过重设置纠正该错误，请单击关闭并确认配置。
Click OK to close this dialog.
单击OK关闭该对话框。
Ignore the message, and click OK to close the window.
不管这条信息，并点击OK以关闭该窗口。
单击ok保存并关闭。
请单击OK关闭该窗口。
Then click OK to save and close.
然后单击ok保存并关闭。
Click OK to close the expression editor.
单击ok以关闭表达式编辑器。
Click OK to close the "Create New Derived Attribute" window.
点击OK以关闭“创建新获得的属性”窗口。
Click OK to close the "Create New Derived Attribute" window.
点击OK以关闭“创建新获得的属性”窗口。
应用推荐