Results 1 case was male patient, 4 cases were female patient.
结果男性1例，女性4例。所有病例均手术治疗并确诊。
There is no adverse reaction but rash in 1 case of treat group.
不良反应方面，仅1例出现皮疹，余无不良反应。
Result All patients were successful, 1 case had ever pulmonary edema.
结果患者全部获治成功，1例曾出现肺水肿。
Results ARDS occurred only 1 case, the others had no a serious complication.
结果除1例术后出现ARDS外，其余术后均无严重并发症。
Secondary asymptomatic intracranial hemorrhage occurred in 1 case of the treatment group.
治疗组继发无症状性颅内出血1例。
Only 1 case complicated with pancreatitis, who recovered after 2 weeks of conservative treatment.
本组1例并发胰腺炎，保守治疗2周后治愈。
Part 1 in the series focused on two case studies.
本系列的第 1部分重点讨论了两个案例研究。
Consider the case that the code in Listing 1 illustrates.
考虑一下代码清单1中所演示的代码的情况。
Figure 1 illustrates the case study architecture.
图1说明了这个案例研究的架构。
The doctor told me the worst case: There's less than 1 percent chance that you can die during the surgery.
医生告诉我最坏的情况是：你有低于1%的机会在外科手术过程中丢掉性命。
In that case, import file 2 first, followed by file 1.
在这种情况下，首先是导入文件2，接着才是文件1。
To begin, you can select a case (Label 1 in Figure 6).
首先，您可以选择一个案例(图6中的Label1)。
There is a case on in Courtroom No 1.
有案子在第1号法庭里审理。
The document in Case 1 had section numbers included as part of the data.
案例1 之中的文档拥有作为数据部分包含的段落编号。
In Listing 1, you see a condensed test case with two tests.
清单1中所示的是具有两个测试的浓缩测试用例。
Case study 1 focused on customer order analysis.
案例研究1重点讨论客户订单分析。
用例1——从何处开始？
Figure 1: Every use case has an assigned set of scenarios.
图1：每个用例都有一组分配的情境。
With proper treatment, the case fatality rate should remain below 1%.
经过适当治疗，病死率应保持在1％以下。
考虑一下图1之中的事例。
The right side of Figure 1 shows the paravirtualization case.
图1的右边是半虚拟化示例。
But worst case scenario, if only 1 percent... that's still awesome!
但最坏的情况，如果只有百分之一的话…那还是棒极了！
Case 1: the point is connected to (at least) three other points.
情形1：这个点(至少)与其它三个点相连。
Step 1: Identify variables for each use case step
步骤1：为每个用例步骤确定变量
Case 1: everyone has at least one friend.
情形1：每个人至少有1个朋友。
The test case in Listings 1 through 6 implements this scenario
清单1到6的测试用例实现了这个场景
Case study 1: memory leak analysis for the MyClass memory leak example.
案例研究1：myclass内存泄漏示例的内存泄漏分析。
Case 1: Multiple heterogeneous sources.
案例1：多个异构源。
Case 1: Multiple heterogeneous sources.
案例1：多个异构源。
应用推荐