在动电位法极化电阻测量中，选择合适的电位扫描速度十分重要。
A simple method of selecting potential sweep rate is given in the paper.
测量第1列和第2列之间的电阻。
对测量的基本限制是源电阻中的约翰逊噪声。
The fundamental limit to measurement is Johnson noise in the source resistance.
重复这一步骤，测量每一通道的LO通道电阻。
Repeat this procedure to measure the LO channel resistance for each channel.
串入的电阻还增加了测量时的RC时间常数。
Any series resistance will also increase the RC time constant of the measurement.
电阻的测量常常使用图3-14所示的两线方法来进行。
Resistance measurements are often made using the two-wire method shown in Figure 3-14.
在测量高电阻时，电缆的绝缘电阻是很重要的。
When measuring high resistance, the insulation resistance of the cable is important.
电阻的测量单位是欧姆。
然而，如果电阻器太大，它可能会影响测量准确度。
However, if the resistor is too large, it may affect measurement accuracy.
现在测量绝缘电阻吗？
湿度将使表面电阻率的测量结果比正常情况低一些。
Moisture will cause the surface resistivity measurements to be lower than normal.
测量每相导体与金属屏蔽、金属套间的绝缘电阻。
Measure each phase conductor to metal mask and to metal sleeve insulation resistance.
测量每相金属屏蔽、金属套与大地之间的绝缘电阻。
Measure each phase metal mask, metal sleeve to ground insulation resistance.
提出了一种新的精确测量小电阻的方法。
Proposed a nwe method of exact measurement of small resistance.
该方法能够实现接触电阻的定量测量。
This method can carry out the quantitative measurement of contact resistance.
提出了一种新的精确测量小电阻的方法。
This paper proposed a new method of exact measurement for small resistance.
利用以上测量方案我们对并五苯单晶材料的电阻率和接触电阻进行了测量。
We measured the resistance and the contact resistance of the pentacene by using such method.
仪表的输入电阻应当远远大于源的内阻才能满足对测量准确度的要求。
The meter input resistance should be much higher than the source resistance.
我们只需要测量一下该电阻两端的电压。
All we need to do is measure the voltage across this resistor.
在测量温度范围内，没有观测到磁电阻效应。
No magnetoresistance effect was observed in the temperature range of measurement.
钻杆测井测量自然电位、短电位电阻率和长电位电阻率。
The drill pipe log records spontaneous potential and short and log resistivity measurements.
四线法是精确测量小电阻时最常用的一种方法。
The four wires method is in common use to accurately measure a little resistance.
测量和计算表明，这种界面电阻值是很小的。
Measurement and calculation show that its value is very small.
电阻包括被测设备和测量仪器两个方面。
The effective source resistance includes the device under test as well as the measurement instrument.
中电阻有多种测量方法。
There are many kinds of measurement methods in middle resistance.
分析了电阻应变计和应变仪的测量原理。
The measuring principle of wire strain gauge is analyzed in this paper.
用欧姆来测量电阻的仪表。
用欧姆来测量电阻的仪表。
而高电阻，因其电流比较小，可用冲击电流计测量。
And high resistance can be examined by Electric bridge Assault.
而高电阻，因其电流比较小，可用冲击电流计测量。
And high resistance can be examined by Electric bridge Assault.
应用推荐