本文针对复杂杆系结构提出一种超级有限条的分析方法。
A super finite strip method for complex rod-systems has doveloped in this paper.
本文利用有限元数值计算方法对磁流体密封结构进行了分析。
Magnetic fluid seal structure is analyzed by the finite element method (FEM) in this article.
研究主要采用的是有限元数值分析的方法。
The research in this paper adopts the finite element numerical analysis method.
对汽车起重机卷筒结构的有限元分析方法进行了研究。
The finite element analysis of reel structure of automobile crane is studied.
较为典型的边坡分析方法主要有极限平衡法，极限分析法，有限元法等。
The typical methods are the limit equilibrium method, the limit analysis method and FEM.
而ANSYS中的接触单元分析方法就是一种有限元接触分析方法。
The contact element analysis of ANSYS is a kind of FEM contact analysis.
采用有限元分析方法，对多点系泊FPSO系泊结构的局部强度进行了研究。
The local strength of mooring system structure of FPSO is studied in this paper.
有限元法是结构分析中最有效的一种数值分析方法。
FEM (Finite Element method) is the most effective numerical analysis method in structural analysis.
有限元方法中有很多分析软件，ANSYS软件就是其中一种。
The finite element method has many analysis software, the ANSYS software is one kind.
在此基础上运用有限元方法对超前支护效应进行了数值模拟分析。
On this basis, effect of advancing support is analyzed with the finite element method.
方法：采用三维有限元的方法进行试验分析。
Medthod: Test and were made analysis were made by the method of three_dimensional finite element analysis.
对轻轨车站大悬臂结构基础应用三维有限元的方法进行了计算分析。
The large_cantilever structure foundation in light rail station is studied with 3_d finite element analysis method.
最后总结了如何在概念设计阶段用有限元分析的方法进行车身设计。
Finally, the method of body design with FEM at the concept design stage is summarized.
方法采用考虑接触和螺栓预拉的非线性有限单元法对不同构造的梁柱外伸端板连接进行分析。
The high strength bolts resistance on the steel beam-to-column extended endplate connection is studied.
有限元法是家具强度分析非常有效的方法。
FEM is a very effective method on furniture strength analysis.
基于渐进失效分析方法，建立了带孔的三维有限元模型。
Based on progressive failure analysis a 3d finite element model with a hole is built.
介绍了床身有限元分析的力学模型简化方法，结合实例对床身的应力场和位移场进行分析。
It introduces mode analysis and frame optimization method about the bed part of WEDM-LS.
该方法也适用于其他非正弦供电电机的场路耦合有限元分析。
The element analysis about the coupling problem of control circuit and field is...
提出了使用通用有限元程序进行结构分析时套筒连接件的处理方法 。
Study of flowing law of metal in extrusion forming process for tube;
提出了使用通用有限元程序进行结构分析时套筒连接件的处理方法 。
Study of flowing law of metal in extrusion forming process for tube;
应用推荐